ECU Peugeot Boxer 2010 Owner's Guide

142
Changing a fuse
The three fuseboxes are placed in the dashbard
on the passenger’s side, in the driver’s door pillar
and in the engine compartment.
The pliers are secured to the fusebox on the
driver ’s side.
Removing and fitting a fuse
Before changing a fuse, the cause of the
fault must be found and rectified. The fuse
numbers are indicated on the fuse box.
- Use the pliers.
Always replace a faulty fuse with a fuse
of the same rating.
No responsibility can be accepted for
expenses incurred by repairs to your vehicle
or for any malfunctions resulting from the
installation of additional accessories which
are not supplied or recommended by the
manufacturer and which are not installed in
accordance with its instructions, in particular
when the combined consumption of all of
the additional equipment connected exceeds
10 milliamperes.

Correct Incorrect

146
Changing a wiper blade
CHANGING A WIPER BLADE
The steps, located in the front bumper,
enable you to access the blades and the
screenwash nozzles. Changing a front wiper blade
Lift the wiper arm.
Unclip the blade by pressing the button and
remove it by pulling it outwards.
Fit the new blade and ensure that it is
secured correctly.
Push back the wiper arm.
Changing the rear wiper blade
Lift the wiper arm, then unclip the blade and
remove it.
Fit the new blade and push back the wiper arm.

To return the windscreen wipers to their
normal position, switch on the ignition
and operate the
wiper
stalk. Check that the screenwash or headlamp
wash nozzles are not blocked.