lock Peugeot Boxer 2016 User Guide

19
boxer_en_Chap02_Pret-a-Partir_ed01-2015
remote control fault
unlock the doors by using the key in the
door lock; the alarm is triggered.
Switch on the ignition, recognition of the

key's code turns off the alarm.
Locking the doors by using the key in
the door lock does not set the alarm.
deactivation using the remote control
When this button is pressed, the
alarm is deactivated when the
vehicle is unlocked.
deactivation of the anti-tilt
protection*
Press this control to deactivate
the protection (when towing the
vehicle with the alarm on, for
example).
t

he protection remains active
until the doors are unlocked with the central
locking.
ALArM
If your vehicle is fitted with an anti-theft
alarm.
t

his provides:
-

exterior perimeter protection by

detectors on the openings (doors,
bonnet) and on the electrical power
supply,
-

anti-tilt protection*.
Activation of the alarm
First ensure that all of the doors and bonnet
are closed correctly.
*
Depending on engine.
Good practice
to deactivate the siren quickly following
a false alarm:
-

switch on the ignition, recognition of the

key's code will switch off the alarm,
-

press the unlocking button (cab and key)

on the remote control.
to avoid setting the alarm, when washing


the vehicle for example, lock the vehicle
using the key.
u

nlocking the vehicle using the remote
control deactivates the siren automatically.
t

he alarm is set by pressing this
padlock, the protection is active
after a few seconds.
While the alarm is monitoring,
any intrusion triggers the siren for
approximately 30 seconds, accompanied by
illumination of the direction indicators.
t

he alarm then returns to
monitoring mode but the
triggering event is stored and is
indicated by illumination of the
electronic immobiliser warning lamp for about
10

seconds when the ignition is switched on.
t

he alarm is also triggered following an
electrical supply cut-off, when the supply is
restored.
2
Access
rEAdY to SEt oFF

20
boxer_en_Chap02_Pret-a-Partir_ed01-2015
Front doorSc hild lock
this prevents opening of the sliding side
door from the inside.
Press the control located on the edge of the

side door.u
se the corresponding button on the remote
control or use the key in the driver's door
lock barrel to unlock.
Pull the handle towards you.
SLIdInG SIdE door
take care not to obstruct the guide space
on the floor in order for the door to slide
correctly.
From outside
Pull the handle towards you then towards
the rear.
From inside
to unlock and open, push the handle
towards the rear.
e

nsure that the door opens fully in order
for the latch at the bottom of the door to
engage.
to release and close, pull the handle while


sliding the door.
Do not drive with the sliding side door
open.
Access

22
boxer_en_Chap02_Pret-a-Partir_ed01-2015
LocKInG / unLocKInG FroM InSIdEd oor open warning lamp
If this warning lamp comes on,
check that all of the doors and
the bonnet are closed correctly.
reversing camera
With the vehicle stationary, opening the rear
doors activates the camera and sends the
image to the screen fitted in the cab.
cab and load space
Pressing permits electric central
locking and unlocking, when the
doors are closed.
t

he doors can still be opened from the
inside.
If one of the doors is open or is not
closed correctly, the central locking
does not work.
t
he indicator lamp in the control:
Load space
Press to lock or unlock the side
door and rear doors from the cab.
t

he indicator lamp remains on
when locked
Anti-intrusion security
When the vehicle is started, the system
locks the cab and load space doors
automatically when you reach approximately
12 mph (20 km/h).
If none of the doors is opened during the
journey, the locking remains active.
Activation/deactivation of the system
t

he system setting is made with the M od E
button: in the "Autoclose" menu, select "ON"
or "OFF".
-

comes on when the doors


are locked and the ignition is
switched on,
-

then flashes when the doors


are locked when stationary
with the engine off.
t

he control is not active when the vehicle
has been locked using the remote control or
the key from the outside.
Good practice
If you decide to drive with the doors locked,
be aware that this could make access to the
vehicle by the emergency services more
difficult in an emergency. Refer to the "
t
echnology on board -

Vehicle configuration" section.
Access

24
boxer_en_Chap02_Pret-a-Partir_ed01-2015
WArn I n G / I nd I c At or LAMPS
every time the engine is started: a series of warning lamps comes on, app\
lying a self-checking test. t hey go off almost immediately.
When the engine is running: a warning lamp becomes an alert if it remain\
s on continuously or flashes.
t
his initial warning may
be accompanied by an audible signal and a message in the screen. "Do not\
ignore these warnings."
Warning/indicator lamp isindicates Solution - action
Service on temporarily. minor faults.
Contact a P
euge O t
dealer or a qualified workshop.
continuously on,


accompanied by
a message on
the screen. major faults.
Make a note of the warning message and contact a
P
euge O t
dealer or a qualified workshop.
Parking brake -


Brake fluid level on.
that the parking brake is applied
or has not been released correctly. Releasing the parking brake switches off the warning
lamp.
on. that the fluid level is too low.
top up with a fluid listed by P

euge O t
.
continuously on,


even though the
level is correct. Stop as soon as it is safe to do so. Park, switch off
the ignition and contact a PE
u GE ot dealer or a
qualified workshop.
+
e

lectronic brake
force distribution on.
a fault with the system. Stop as soon as it safe to do so. Contact a P
euge O t

dealer or a qualified workshop.
Anti-lock braking


system on.
a fault with the system.
t

he vehicle retains conventional braking without
assistance. However, we recommend that you stop and
contact a P
euge O t
dealer or a qualified workshop.
Instruments and controls

28
boxer_en_Chap02_Pret-a-Partir_ed01-2015
Warning/indicator lampisindicates Solution - action
Lane departure
warning flashing,
accompanied by
an audible signal. unintended wander to the left.
turn the steering wheel in the other direction to return


to the correct trajectory.
unintended wander to the
right.
e

lectronic
immobiliser on.
the ignition key introduced
has not been recognised
Staring is not possible. Change the key and have the faulty key checked by a
P
euge O t
dealer
.
"Ready to set off - Access" section.
on for 10 seconds
when switching on
the ignition. triggering of the alarm.
Have the state of the locks checked by a P
euge O t

dealer or a qualified workshop.
W

ater in Diesel
fuel filter on, accompanied
by a message in
the screen. that there is water in the fuel
filter. Have the filter bled by a P
euge O t
dealer or a qualified

workshop.
"Checks - Levels and checks" section.
AdBlue additive on, then flashing,
accompanied by
a message in the
screen. reduced driving range. Have the AdBlue topped-up without delay.
Do not wait until the remaining range is 0 miles, you will
not be able to restart the engine!
"Checks - AdBlue" section.
Low fuel level on with the needle
in zone
e .that the fuel reserved is being
used. Fill up with fuel without delay.
t

he calculation of the
remaining fuel depends on the style of driving, the
profile of the road, the time elapsed and the distance
travelled since the warning lamp first came on.
flashing. a fault with the system. Contact a P
euge O t
dealer or a qualified workshop.
Instruments and controls

37
boxer_en_Chap02_Pret-a-Partir_ed01-2015
StEErInG WHEEL A dju S t ME nt
With the vehicle stationary, first adjust your
seat to the most suitable position.
Release the steering wheel adjustment
mechanism by pulling the lever towards you.
Adjust the reach of the steering wheel, then
lock the mechanism by pushing the lever
fully forwards.
operation
the information appears in the
instrument panel screen in the
form of the
SHIF t indicator,
accompanied by an upward arrow
to signal to the driver that they can change up.
t

he system adapts its gear change
recommendations according to the driving
conditions (slope, load, ...) and demands
from the driver (for power, acceleration,
braking,

...).
Switching off
this system cannot be deactivated by the
driver .
As a safety measure, these operations
must not be carried out while driving.
Gearbox and steering wheel
2
rEAdY to SEt oFF

38
boxer_en_Chap02_Pret-a-Partir_ed01-2015
IGnItIon SWItcH
StoP position: steering lock.
t
he ignition is off.
MA
r position: ignition on.
Certain accessories can be used.
AV V position: starter.
t

he starter is operated.
Starting the engine
Engine immobiliser warning lamp
If this warning lamp comes

on, use another key and have
the faulty key checked by a
P
euge O t
dealer
.
d

iesel pre-heating warning lamp
With the parking brake applied
and the gearbox in neutral, turn
the key to the MA
r position.
Wait for this warning lamp to go off then
operate the starter (AV V position) until the
engine starts.
t

he period of illumination of the warning
lamp depends on the climatic conditions.
d
oor or bonnet open warning
lamp
If this warning lamp comes on,

check that the doors and bonnet
are closed correctly.
Switching off the engine
Stop the vehicle and apply the parking
brake, then, with the engine at idle, return
the key to the S
to P position.
In low temperatures
In mountainous and/or cold areas, it is
advisable to use a "winter" type fuel suited
to low or minus temperatures.
Avoid attaching heavy objects to the
key or the remote control, which would
weigh down on its blade in the ignition
switch and could cause a malfunction.
It could adversely affect the deployment of
the front airbag. With the engine hot, the warning lamp comes
on for a few moments, you can start the engine
without waiting.
As soon as the engine is running, release the key.
Starting and switching off

67
boxer_en_Chap03_ergo-et-confort_ed01-2015
Setting the time of the internal clock
Set the clock on the control panel before
programming the deferred switching on of
the heating.Press and hold the "set" button.
t

he time setting screen and
indicator come on.
Within ten seconds, press one of the two
setting buttons until the correct time is
displayed: -

">"
to increase the time,
or
-

"<"
reduce the time.
reading the time
Pro
G
r
AMMABLE

A
dd
I
t
I
on
AL
HEAt

I
n
G
If your vehicle is fitted with separate
programmable heating, it gradually brings
the engine up to a good temperature to
facilitate starting.
An integrated clock permits programming of
its start time.
t

he passenger compartment
will be heated more quickly.
time display
digital programming control
the programmable heating control panel
is located to the side of the steering wheel
below the M
od E switch panel. Heating cycle indicator
time setting and reading indicator
Display of the programme number

selected
Ventilation indicator
time setting buttons
Programme selection button
Button for immediate switching on

of the heating Press and hold the button for more rapid
scrolling of the digits.
Release the"set" button.
When the screen is off, the time is
memorised.
Press the "<" or ">" button.
t
his time reading indicator comes
on and the time is displayed for
approximately ten seconds.
Ventilation
3
EASE oF uSE and coMFort

71
boxer_en_Chap03_ergo-et-confort_ed01-2015
drIVEr'S SEAt
Head restraint
Press the tab to adjust the height of the
head restraint.
to remove the head restraint, press the tabs

and raise the head restraint.
Adjustable armrest
Raise or, lower the armrest.
turn the wheel located under the end of the


armrest to lock it in the desired position.
Seats
3
EASE oF uSE and coMFort

76
boxer_en_Chap03_ergo-et-confort_ed01-2015
cABIn FIttInGS
Front seat storage
there is a fixed storage tray under the
driver's seat.
central glove box
If fitted with a lock, you can lock it using
the key.
It gives access to the auxiliary sockets (Jack
and
u SB) intended for the transfer of data to
the audio system. If your vehicle is fitted with a seat with
variable damping, it does not have any
storage compartments.t
he space under the passenger's seat is
used to store the tool box containing the
tools required to change a wheel or bulb or
to tow the vehicle.
to take out the box, turn the control a


quarter turn to unlock it, then pull the box
forward.
When putting it back, don't forget to turn the
control a quarter turn in the other direction to
lock the box in its housing.
Practical information