wipers Peugeot Expert VU 2009 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2009, Model line: Expert VU, Model: Peugeot Expert VU 2009Pages: 226, PDF Size: 10.49 MB
Page 5 of 226
Interior
8
INSTRUMENTS AND CONTROLS
1. Lights and direction indicators stalk.
2. Instrument panel with display.
3. Wipers, wash-wipe, trip computer
controls.
4. Gear lever.
5. Ignition.
6. Audio equipment controls.
7. Driver's air bag, horn.
8. Steering wheel height and depth
adjustment.
9. Headlamp beam adjustment.
10. Cruise control, speed limiter switch.
11. 12 volt accessories socket
(120 W max) of the lighter type.
12. Ashtray.
13. Glove box, auxiliary socket,
passenger air bag disarming switch.
Page 9 of 226
3
3
7
Interior
12
SEE CLEARLY 37
Lights off.
Side lights.
Main beam headlamps (blue).
Dipped headlamps (green). Wipers stalk
2 fast.
1 normal.
I intermittent.
0 off.
single wipe.
AUTO , press the stalk down.
AUTO, automatic switching
on of the lights.
Lights stalk
40 Changing bulbs
111
In bad weather or in winter, check that the
lights are not covered with mud or snow.
Page 41 of 226
39
Steering wheel controls
ERGONOMICS and COMFORT
3
Automatic switching on of the lights Activation
Turn the ring to the
AUTO position.
The activation of this function is
accompanied by a message on the display.
If the brightness sensor does not
function correctly , the lights come on
accompanied by the service warning light,
an audible signal and a message on the
display.
Consult a PEUGEOT dealer.
HEADLAMP BEAM
Depending on the load in your vehicle, the
beam setting must be adjusted.
0 - No load.
1 - Partial load.
2 - Average load.
3 - Maximum authorised load.
Do not cover the brightness sensor
located on the windscreen, behind the
mirror. It is used for the automatic switching
on of the lights and for the automatic wipers. The side lights and dipped
beam headlamps switch
on automatically if the light
is poor, or during operation
of the windscreen wipers. They switch off as
soon as the light becomes bright enough or
the windscreen wipers stop.
This function is not compatible with the
daytime lights. Deactivation
Turn the ring forwards or rearwards. The
deactivation of this function is accompanied
by a message on the display.
The function is deactivated temporarily when
you use the manual lights stalk.
Initial setting is position 0.
In foggy weather or in snow, the
brightness sensor can detect sufficient
light. As a consequence, the lights will
not come on automatically. If necessary,
you must switch on the dipped headlamps
manually.
Page 42 of 226
40
Steering wheel controls
WINDSCREEN WIPER STALK
Manual windscreen wipers
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
Single wipe
(press downwards). Do not cover the rain sensor,
located in the centre of the
windscreen, behind the mirror.
Wash-wipe and headlamp wash
Pull the stalk towards you, the wash-wipe
is accompanied by a timed sweep of the
wipers.
The headlamp wash is linked with the wash-
wipe, it is triggered if the dipped headlamps
are on.
In the I ntermittent position, the wiping speed
is in proportion to the vehicle speed. To top up the levels, refer to the
"Levels" section of chapter 6.
In the AUTO position, the windscreen wipers
operate automatically and adapt their speed
to the intensity of the rainfall.
When not in AUTO mode, for the other
positions, refer to the manual windscreen
wipers section.
Whenever the ignition has been switched
off for more than one minute, with the
windscreen wiper stalk in position
2 , 1 or I ,
the stalk must be reactivated:
- move the stalk to any position,
- then move it back to the required position. Automatic windscreen wipers
Page 43 of 226
41
Steering wheel controls
ERGONOMICS and COMFORT
3
Special position of the windscreen
wipers
In the minute following switching off of the
ignition, any action on the stalk positions the
wipers against the windscreen uprights. This action enables you to position the
wiper blades for winter parking, cleaning or
replacement.
Refer to the "Changing a windscreen
wiper blade" section of chapter 7.
When using an automatic car wash,
switch off the ignition to avoid
triggering of the automatic wiping.
In winter, it is advisable to wait for the
windscreen to completely clear of ice before
operating the automatic wipe.
Rear windscreen wiper
Turn the ring to the first notch. Rear windscreen wash
Turn the ring past the first notch:
the windscreen wash then the
windscreen wiper operate for a
fixed time.
In winter, in the event of a considerable
amount of snow or ice, switch on the
rear screen demister. Once de-icing is
complete, remove the snow or ice which has
accumulated on the rear wiper blade. You
can then operate the rear windscreen wiper.
To park the wipers in their normal position
after this has been done, switch on the
ignition and move the stalk.
Activation
Press the control downwards. Activation of
the function is accompanied by a message
on the display.
The automatic windscreen wipers function
must be reactivated if the ignition has been
switched off for more than one minute, by
pressing the stalk downwards.
Deactivation/Switching off
Place the windscreen wipers stalk in
position
I , 1 or 2 . Deactivation of the
function is accompanied by a message
on the display.
In the event of malfunction of the automatic
windscreen wipers, the windscreen wipers
will operate in intermittent mode.
Contact a PEUGEOT dealer to have the
system checked.
Page 124 of 226
119
Changing a fuse
TROUBLESHOOTING
7
FUSES UNDER THE BONNET
- After opening the bonnet, slide the screenwash support to make access
easier.
- Unclip and tilt the box to access the fuses.
Fuses A (amps) Allocation
1 20 Engine control unit, Fuel supply and air supply sy
stems,
Fan assembly
2 15 Horn
3 10 Front and rear wash-wipe pump
4 20 Headlamp wash pump
5 15 Fuel supply system
6 10 Power steering, Secondary brake pedal switch
7 10 Braking system (ABS/ESP)
8 20 Starter control
9 10 Main brake pedal switch
10 30 Fuel supply and air supply systems, Emission contr
ol
systems
11 40 Front ventilation
12 30 Windscreen wipers
13 40 Built-in systems interface
14 30 Free
Page 126 of 226
121
Changing a wiper blade
TROUBLESHOOTING
7
Placing the wiper blades in the
special position
- Less than a minute after switching off the ignition, press the wipers stalk
downwards to position the wiper blades
along the windscreen uprights
(special position). Changing a front wiper blade
- Lift the wiper arm.
- Unclip the blade and remove it.
- Fit the new blade.
- Push back the wiper arm.
Changing the rear wiper blade
- Lift the wiper arm, then unclip the blade
and remove it.
- Fit the new blade and push back the wiper arm.
CHANGING A WINDSCREEN WIPER BLADE
To return the windscreen wipers to their
normal position, switch on the ignition and
operate the wipers stalk.
Page 205 of 226
0 9
9.61
TRIP COMPUTER
V E H I C L E D I A G N O S T I C S
- T h e " v e h i c l e " t a b : T h e r a n g e , t h e c u r r e n t c o n s u m p t i o n a n d t h e d i s t a n c e r e m a i n i n g . - T h e " 1 " ( r o u t e 1 ) t a b w i t h : T h e a v e r a g e s p e e d , t h e a v e r a g e consumption and the distance travelled calculated over route "1". - T h e " 2 " ( r o u t e 2 ) t a b w i t h t h e s a m e functions for a second route.
R a n g e : d i s p l a y s t h e d i s t a n c e w h i c h c a n t r a v e l l e d w i t h t h e r e m a i n i n g d i s p l a y s t h e d i s t a n c e w h i c h c a n t r a v e l l e d w i t h t h e r e m a i n i n g f u e l d e t e c t e d i n t h e t a n k , i n r e l a t i o n t o t h e a v e r a g e c o n s u m p t i o n o v e r f u e l d e t e c t e d i n t h e t a n k , i n r e l a t i o n t o t h e a v e r a g e c o n s u m p t i o n o v e r t h e l a s t f e w m i l e s ( k i l o m e t r e s ) . T h i s d i s p l a y e d v a l u e m a y v a r y s i g n i fi c a n t l y f o l l o w i n g a c h a n g e i n t h e T h i s d i s p l a y e d v a l u e m a y v a r y s i g n i fi c a n t l y f o l l o w i n g a c h a n g e i n t h e vehicle speed or the relief of the route. W h e n t h e r a n g e f a l l s b e l o w 2 0 m i l e s ( 3 0 k m ) , d a s h e s a r e d i s p l a y e d . W h e n t h e r a n g e f a l l s b e l o w 2 0 m i l e s ( 3 0 k m ) , d a s h e s a r e d i s p l a y e d . A f t e r fi l l i n g w i t h a t l e a s t 5 l i t r e s o f f u e l , t h e r a n g e i s r e c a l c u l a t e d a n d A f t e r fi l l i n g w i t h a t l e a s t 5 l i t r e s o f f u e l , t h e r a n g e i s r e c a l c u l a t e d a n d i s d i s p l a y e d w h e n i t e x c e e d s 6 0 m i l e s ( 1 0 0 k m ) . I f , w h i l s t d r i v i n g , d a s h e s a r e d i s p l a y e d c o n t i n u o u s l y i n p l a c e o f t h e I f , w h i l s t d r i v i n g , d a s h e s a r e d i s p l a y e d c o n t i n u o u s l y i n p l a c e o f t h e d i g i t s , c o n t a c t a P E U G E O T d e a l e r .
C u r r e n t c o n s u m p t i o n : only calculated and displayed aayed above 20 mph ( 3 0 k m / h ) .
A v e r a g e c o n s u m p t i o n : t h i s i s t h e a v e r a g e q u a n t i t y o f f u e l t h i s i s t h e a v e r a g e q u a n t i t y o f f u e l consumed since the last trip computer zero reset.
D i s t a n c e t r a v e l l e d : calculated since the last trip compucomputer zero reset.
D i s t a n c e r e m a i n i n g t o t h e d e s t i n a t i o n : calculated wited with reference t o t h e fi n a l d e s t i n a t i o n , e n t e r e d b y t h e u s e r . I f g u i d a n c e i s a c t i v a t e d , t o t h e fi n a l d e s t i n a t i o n , e n t e r e d b y t h e u s e r . I f g u i d a n c e i s a c t i v a t e d , t h e n a v i g a t i o n s y s t e m c a l c u l a t e s i t a s a c u r r e n t v a l u e .
A v e r a g e s p e e d : t h i s i s t h e a v e r a g e s p e e d c a l c u l a t e d s i n c e t h e l a s t t h i s i s t h e a v e r a g e s p e e d c a l c u l a t e d s i n c e t h e l a s t t r i p c o m p u t e r z e r o r e s e t ( i g n i t i o n o n ) .
Each press of the button at the end of the wipers stalk dstalk displays the v a r i o u s t r i p c o m p u t e r d a t a i n s u c c e s s i o n , a c c o r d i n g t o t h e d i s p l a y . v a r i o u s t r i p c o m p u t e r d a t a i n s u c c e s s i o n , a c c o r d i n g t o t h e d i s p l a y .
A FEW DEFINITIONS