ESP Peugeot Expert VU 2016 User Guide

35
Expert_en_Chap01_instruments-de-bord_ed01-2016
AdBlue® fluid range
indicators
once the AdBlue® tank is on reserve or after
detection of a fault with the SCR emissions
control system, when the ignition is switched
on, an indicator displays an estimate of the
distance that can be covered, the range, before
engine starting is prevented.
In the event of simultaneous system fault and
low AdBlue
® level, the shortest range figure is
the one displayed.
In the event of the risk of non-starting related to a lack of AdBlue®
the engine start prevention system
required by regulations is activated
automatically once the AdBlue
® tank is
e m pt y.
Remaining range greater than 1 500 miles (2 400 km )
Pressing this button will display the remaining
range.
F
t
hen
select "Diagnostic ".
Above 3 000 miles (5 000 km), the value is not
specified. When switching on the ignition, there is no
automatic display of range in the instrument
panel.
the

range is then displayed temporarily.
You can access this information in the touch
screen, if your vehicle has one.
F

Sel
ect the "Driving" menu.
Remaining range between 350 and 1500 miles (600 and 2 400 km)
When switching on the ignition, this warning
l amp comes on, accompanied by an audible
signal and the display of a message (e.g.: "
to

p
up emissions additive: Starting prevented in
900 miles") indicating the remaining range
expressed in miles or kilometres.
F

Sel

ect " OPTIONS ".
For more information on AdBlue
® and
the SCR system , and in particular on
topping-up the AdBlue
®, refer to the
corresponding section.
If your vehicle has an LCD instrument panel,
"N
o

S
tA

R
t

IN" is displayed.
When driving, the message is displayed every
200 miles (300 km) until the fluid has been
topped-up.
go t

o a PE
u

g
Eo

t
dealer or a qualified
workshop to have the AdBlue
® topped-up.
You can also top-up the tank yourself.
1
Instruments

36
Remaining range between 0 and 350 miles (0 and 600 km)
When switching on the ignition, this warning
lamp flashes, accompanied by an audible
signal and the display of a message (e.g. "
to
p
up emissions additive: Starting prevented in
350 miles") indicating the remaining range
expressed in miles or kilometres. Breakdown related to a lack of AdBlue
®
When switching on the ignition, this
warning lamp flashes, accompanied
by an audible signal and the display
of the message "
to

p up emissions
additive: Starting prevented".
to b

e able to start the engine,
we recommend that you call on a
PE
u

g
Eo
t dealer or a qualified
workshop for the top-up required.
If you carry out the top-up yourself, it
is essential to add at least 3.8 litres of
AdBlue
® to the tank.
For more information on AdBlue
® and
the SCR system , and in particular on
topping-up the AdBlue
®, refer to the
corresponding section.
If your vehicle has an LCD instrument panel,
"N
o

S
tA

R
t

IN" is displayed.
If your vehicle has an LCD instrument panel,
"N
o
S
tA
R
t
IN" is displayed.
When driving, the message is displayed every
30 seconds until the fluid has been topped-up.
go t

o a PE
u

g
Eo

t
dealer or a qualified
workshop to have the AdBlue
® topped-up.
You can also top-up the tank yourself.
ot

her wise you will not be able to restart your
engine.
th
e AdBlue
® tank is empty: the system required
by regulations prevents engine starting.
Instruments

44
Driving menu
the systems with settings that can be adjusted are detailed in the table below.
For more information on a driving assistance system refer to the corresponding section.Button Corresponding function Comments
Under-inflation initialisation Reinitialisation of the under-inflation system.
Blind spot monitoring system Activation/Deactivation of the function.
Stop & Star t system Activation/Deactivation of the function.
or Lane departure warning
system
Activation/Deactivation of the function.
Automatic headlamp dip Activation/Deactivation of the function.
Instruments

45
Expert_en_Chap01_instruments-de-bord_ed01-2016
ButtonCorresponding function Comments
Vehicle settings
to

deactivate/activate a
function, press
o
F
F/
oN.to m

odify a setting (lighting
duration, ...) or find additional
information, press the symbol
for the function. Access to other functions with settings that can be adjusted.
Select or deselect the tabs at the bottom of the touch screen to sort the display of the desired
functions.
-

L
ighting:
-
"

Directional headlamps": activation/deactivation of the directional headlamps.
-
"gu

ide-me-home lighting": activation/deactivation of the automatic guide-me-home lighting.
-
"

Welcome lighting": activation/deactivation of the exterior welcome lighting.
-
"

Mood lighting": activation/deactivation of the interior mood lighting.
-

A
ccess:
-

"
Hands-Free Access": activation/deactivation of the motorized opening and closing of a side
door by the hands-free system,
-

"
Locks your vehicle after the motorized closing of a side door, using hands-free access.":
activation/deactivation of the locking of your vehicle after the motorized closing of a side door
by the hands-free system.
-

A
ssistance (driving aids):
-

"
Rear wiper in reverse": activation/deactivation of the operation of the rear wiper in reverse.
-

"
Recommended speed display": activation/deactivation of the speed limit recognition system,
allowing a speed setting to be given to the cruise control or speed limiter.
-
"

Collision risk alert and automatic braking": activation/deactivation of collision risk alerts.
-
"

Fatigue Detection System": activation/deactivation of the driver fatigue detection system.
Diagnostic List of current alerts.
Parking sensors Activation/Deactivation of the function.
Adjust speed settings Memorisation of speed settings for the speed limiter or active cruise control.
1
Instruments

53
Expert_en_Chap02_ouvertures_ed01-2016
B a c k- u p c o nt r o l (s)
Locking the driver's doorLocking the front passenger door
F open the door.
For mechanically locking and unlocking the doors in the event of a fault with the central locking
system or a battery failure.
If your vehicle has an alarm, it will not
be deactivated/activated on unlocking/
locking the vehicle.
op

ening a door will trigger the alarm,
which can be stopped by switching on
the ignition.
Locking the sliding side door
F If fitted to your vehicle, check that the electric child lock is not on.
F
o
p
en the door.
Unlocking
F Insert the key in the door lock and turn it to the front.
Unlocking
use the interior door handle.
Unlocking
F use the interior door handle.
For more information on the Child lock ,
refer to the corresponding section.
F

I

nsert the key in the door lock and turn it to
the rear. F

R

emove the cap on on the edge of the
d o o r.
F

I

nsert the key into the latch aperture
(without forcing) and turn the assembly.
F

R

emove the key and refit the cap.
F

C

lose the door and check from the outside
that it has locked correctly. F
R
emove the cap on the edge of the door.
F
I
nsert the key into the latch aperture
(without forcing) and turn the assembly.
F
R
emove the key and refit the cap.
F
C
lose the door and check from the outside
that it has locked correctly.
2
Access

59
Expert_en_Chap02_ouvertures_ed01-2016
the unlocking, locking or deadlocking
does not take place:
-
i
f the ignition is on,
-

i
f one of the doors or the boot is still
open,
-

i
f the key for the Keyless Entry and
Starting system has been left inside
the vehicle.
When the vehicle is locked (with the
remote control or Keyless Entry and
Starting), if it is unlocked inadvertently,
it will lock itself again automatically after
about thirty seconds unless a door has
been opened.
And if your vehicle has an alarm, this
will be reactivated (with volumetric
monitoring, even if this had been
deactivated).
"Keyless Entry and
Starting" on your person
this allows the unlocking, locking and starting
the vehicle while keeping the remote control on
your person. As a safety measure (children on
board), never leave the vehicle without
taking your Keyless Entry and Starting
remote control, even for a short period.
gu

ard against theft when the Keyless
Entry and Starting remote control is in
the recognition zone with the vehicle
unlocked.
In order to preserve the charge of the
cell battery in the remote control, the
"hands-free" functions go into extended
stand-by after 21 days of non-use.
to r

estore these functions, press one of
the remote control buttons or start the
engine with the remote control at the
reader.
th
e folding and unfolding of the door
mirrors by the remote control can be
deactivated by a PE
u
g
Eo
t dealer or a
qualified workshop.
In the ignition on (accessories) position,
with the "S
tA
R
t/
S
t
o
P
" button, the
hands-free function is deactivated.
For more information on " Keyless
Entry and Starting " and in particular
the "ignition on" position, refer to the
corresponding section.
2
Access

60
Expert_en_Chap02_ouvertures_ed01-2016
Cab and loading area selectivity
deactivated.
un

locking is signalled by the rapid
flashing of the direction indicators for
about two seconds.
Depending on version, the door mirrors
unfold and the alarm is deactivated.
Total unlocking
F to unlock the vehicle , remote control on
your person and in the recognition zone A,
pass your hand behind one of the door
handles (front doors, manual sliding side
doors or side-hinged doors).
F

P
ull the handle to open the corresponding
d o o r.
With electric sliding slide door(s)
F to unlock the vehicle , remote control on
your person and in the recognition zone A,
pull and release the door handle.
t
h
is
action also triggers the electrically powered
opening of the corresponding door.
With tailgate
F to unlock the vehicle , remote control on
your person and in the recognition zone A ,
pull the tailgate handle.
F

Ra
ise the tailgate.
Access

61
Expert_en_Chap02_ouvertures_ed01-2016
Depending on version, the door mirrors
unfold only on unlocking the cab, the
alarm is deactivated
Cab
and loading area selectivity
activated.
Selective unlocking
F to unlock the cab only , remote control on
your person in the recognition zone A or B,
pass your hand behind one of the front
door handles.
F

P
ull the handle to open the corresponding
d o o r. F
t
o u
nlock the loading area only
,
remote control on your person and in the
recognition zone A , B or C, pass your
hand behind the door handle on one of the
doors, left, right or rear.
F P ull on the handle to open the
corresponding door.
With electric sliding slide door(s)
F to unlock the loading area , remote control
on your person and in the recognition
zone
A and B, pull and release the
door handle.
t
h
is action also triggers
the electrically powered opening of the
corresponding door.
th

e state of the locks for the loading
area doors remains unchanged.
2
Access

63
Expert_en_Chap02_ouvertures_ed01-2016
Unlocking
F to unlock the vehicle, remote control on your person and in the recognition zone A,
pass your hand behind one of the door
handles (front doors, manual sliding side
doors and side-hinged doors).
F

P
ull the handle to open the corresponding
d o o r.
With electric sliding slide door(s)
F to unlock the vehicle, remote control on your person and in the recognition
zone
A, pull and release the door handle to
trigger the electric powered opening of the
corresponding door.
With tailgate
F to unlock the vehicle, remote control on your person and in the recognition zone A ,
pull the tailgate handle.
F

Ra
ise the tailgate.
un

locking is signalled by the rapid
flashing of the direction indicators for
about two seconds.
Depending on version, the door mirrors
unfold, the alarm is deactivated.
2
Access

69
Expert_en_Chap02_ouvertures_ed01-2016
For more information on the child lock,
refer to the corresponding section.
Locking a sliding side door
F If fitted to your vehicle, check that the electric child lock is not on.
F
o
p
en the door.
Locking the side-hinged doors
F If fitted to your vehicle, check that the electric child lock is not on.
F
o
p
en the left-hand side-hinged door.
Unlocking
F use the interior door handle.Unlocking
F use the interior door handle. F
R
emove the cap on the edge of the door.
F
I
nsert the key into the latch aperture
(without forcing) and turn the assembly.
F
R
emove the key and refit the cap.
F
C
lose the door and check from the outside
that the vehicle has locked correctly. F
I
nsert the key (without forcing) into the
latch aperture located on the edge of the
door and slide the assembly upward.
F
R
emove the key.
F
C
lose the door and check from the outside
that the vehicle has locked correctly.
2
Access