tow Peugeot iOn 2011 User Guide

i
i
Practical information
102
1.Brake lamps/Sidelamps (LEDs).2. Direction indicators (W Y21W - 21 W).3.Reversing lamps (W21W - 21 W).
Rear lamps
Amber coloured bulbs, such as the direction indicators, must be replaced with bulbs of identical specification and colour.
In some weather conditions (e.g. lowtemperature or humidity), the presenceof misting on the internal surface of the glass of the headlamps and rear lamps is normal; it disappears after the lampshave been on for a few minutes.
Changing an integrated direction
indicator side repeater (WY5W - 5 W)
)Push the repeater towards the rear anddetach it. )Turn the bulb holder to the left andpull it out. )Pull the bulb out and replace it.
To r e f i t , c a r ry out these operations in reverse order.

8
Practical information
103
Changing a direction indicator bulb
) Turn the bulb holder to the left and
pull it out. ) Pull the bulb out and replace it.
To r efit, carry out these operations in reverse order.
Access to bulbs
)Remove the two screws. )Disengage the lamp unit by pulling it
towards you.

Changing a brake/sidelamp bulb

All work on the LED lamps must be carried out
by a PEUGEOT dealer or a qualified workshop.


Changing a reversing lamp bulb
)
Turn the bulb holder to the left and pull it out.)
Pull the bulb out and replace it.
To r efit, carry out these operations in reverseorder.

8
i
!
Practical information
105











Changing a fuse

The extraction tweezer is fitted to the back of
the fusebox cover in the dashboard (left handside).
For access: )Unclip the cover and remove it completely by pulling it towards you.)Remove the tweezer.



Access to tools
Before changing a fuse, the cause of the failure
must be identified and rectified. ) Check that the ignition switch is in
the "LOCK " position.)
Identify the faulty fuse by checking
the condition of its filament.
Changing a fuse
Good Failed
)
Use the special tweezer to extract the fuse from its location.)
Always replace the faulty fuse with a fuse
of the same rating. ) Check that the number etched on the box,
the rating etched on the top and the tablesbelow all agree.
PEUGEOT will not accept responsibilityfor the cost incurred in repairing your vehicle or for rectifying the malfunctionsresulting from the installation of accessories not supplied and not recommended by PEUGEOT andnot installed in accordance with itsinstructions, in par ticular when the consumption of all of the additional equipment connected exceeds 10 milliamperes.

Your vehicle's electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories in your vehicle, contact a PEUGEOT dealer or a qualified workshop.

8
Practical information
109

Access to the fuses
)Open the bonnet (refer to the "Checks" section). )Unclip the cover and remove it completely
by pulling towards you. )Change the fuse (refer to the corresponding paragraph).)When you have finished, close the cover carefully to ensure sealing of the fusebox.
Fuse N°RatingFunctions
11

10 A
On-board charger.
12


10 A
Dir
ection indicator.


13


10 A
H
orn.
14


10 A Daytime running lamps.
15

15 A
Batter
y fan.
16


10 A
Air conditionin
g compressor.
17 20 A

Right hand dipped beam.
18 20 A

Le
ft hand dipped beam, headlamp adjusters.


19


10 A
Ri
ght hand main beam.


20


10 A
L
eft hand main beam.

i !
!
Practical information
110





Towing the vehicle
Procedure for having your vehicle towed using fixed mechanical equipment.


To w i ng your vehicle

The towing eye is welded to the body below thefront bumper.)
Install the towing bar. )
Start your vehicle ("Ready" lamp on).)
Put the drive selector in position N . )
Release the parking brake.)
Switch on the hazard warning lamps onyour vehicle.)
Have your vehicle towed for no more than 20 miles (30 km) without exceeding a
speed of 20 mph (30 km/h) .


When towing the vehicle with the four wheels on the ground, always use a towing bar.
When towing with only two wheels onthe ground, use professional lifting equipment.


Failure to follow these instructions may cause damage to braking components and the electric motor.









Changing a wiper
blade
Removing a front or rear
wiper blade
)Raise the corresponding wiper arm.)Remove the wiper blade, sliding it towards
the outside.
Fitting a front or rear wiper
blade
)Put the new wiper blade in place and
secure it. )Fold down the wiper arm carefully.



To w i ng another vehicle

Your vehicle cannot be used in any circumstances to tow another vehicle.

9
i
Checks
119










Checks
Unless other wise indicated, check these components in accordance with the ser vicing booklet.
Other wise, have them checked by a PEUGEOT dealer or a qualified workshop.

Passenger compartment filter

Refer to the ser vicing booklet for
details of the replacement inter vals
f
or this filter.
Depending on the environment (e.g.
dusty atmosphere) and the use of the vehicle (e.g. city driving), replace it twice as often if necessary.y A dirty passenger compartment filter may have
an adverse effect on the performance of the air conditioning system and generate undesirableodours.
Brake wear depends on the style
o
f driving, par ticularly in the case
of vehicles used in town, over shor t
distances. It ma
y be necessary tohave the condition of the brakes checked, evenbetween vehicle services.
Unless there is a leak in the circuit, a drop in
the brake fluid level indicates that the brake
pads are worn.
Brake pads
Only use products recommended by PEUGEOT or products of equivalent quality and specifications. In order to optimise the operationof units as impor tant as the braking system, PEUGEOT selects and offers very specific products.
Parking brake

If a loss of effectiveness of thissystem is noticed, the parking brakemust be checked, even between two services.
This system must be checked by a PEUGEOT
dealer or a qualified workshop.
Brake disc/drum wear
For information on checking the
brake disc or drum wear, contact
a PEUGE
OT dealer or a qualified
workshop.

10
!
Technical data
121
WEIGHTS (in kg)
Electric motorY4 F1
Main batteryLithium-Ion
Model type code:1 N ZK Z Z
Unladen weight

1 120

Kerb weight 1 195

Gross vehicle weight (GV W) 1 450

Gross train wei
ght (GTW)1 450

Maximum load on the roo
f (including the roof bars)43

Your vehicle cannot be fitted with a towbar. It cannot tow a trailer.

Alphabetical index
158
Ser vice indicator...........................................r29Sidelamps .............................97, 100, 102, 103Side repeater............................................... 102Speedometer................................................r18Stability control (ESP)...................................72Starting the vehicle.................................52, 54Stopping the vehicle...............................52, 54Storage..........................................................44Sun visor.......................................................r45Systems, ASR and ESP................................72
Technical data .............................................120Te m p o r a ry tyre repair kit ...............................90Third brake lamp .........................................104Total distance recorder.................................r28Towing another vehicle ............................... 110Traction control (ASR)..................................72Tr affic information (TA)...............................131Tyre pressures............................................123
T
Ventilation................................................47-49
V
Weights.......................................................121Window controls............................................34
Wipers ...........................................................59
W
Unlocking from the inside .............................35USB (Peugeot Connect).........................44,46USB port................................................46,133
U