Peugeot iOn 2015 Owner's Manual

129
Ion_en_Chap10_caracteristiques-techniques_ed01-2014
Motor and main battery
Model type code:1 N ZK Y Z
Electric motor Y51
Technology Synchronous with neodymium permanent magnets
Max. power: EU standard (kW) 49
Max. power speed (rpm) 4 000 to 8 800
Max. torque: EU standard (Nm) 19 6
Max. torque speed (rpm) 0 to 300
Main battery Lithium-Ion
Energy capacity (kWh) 14.5
Normal charge
Voltage (V) AC 230
Charging time
(*) (**):
-
1
6 A
-

1

4 A
-

1

0 A
-

8 A 5 h

ours 30 minutes
6 hours
8 hours
11 h o u r s
Fast charge
Voltage (V) DC 300
Charging time (80% charge)** 30 minutes
Range varies according to the exterior climatic conditions, the driver's style of driving, the use of electrical equipment, the frequency of normal or fast
charges and ageing of the main battery. * Depending on the power supply in the country.
** Time measured for ambient temperatures between 20 and 25° C.
10
Technical data

130
Ion_en_Chap10_caracteristiques-techniques_ed01-2014
Electric motorY51
Main battery Lithium-Ion
Model type code: 1 N ZK Y Z
Unladen weight 1 065
Kerb weight 1 140
Gross vehicle weight (GV W) 1 450
Gross train weight (GTW) 1 450
Maximum load on the roof (including the roof bars) 43
Your vehicle cannot be fitted with a towbar. It cannot tow a trailer.
Weights (in kg)
Technical data

131
Ion_en_Chap10_caracteristiques-techniques_ed01-2014
Dimensions (in mm)
10
Technical data

132
Ion_en_Chap10_caracteristiques-techniques_ed01-2014
Identification markingsVarious visible markings for the identification of your vehicle.
A.
S
er vice - Replacement Par ts
identification plate.
This plate is riveted to the underside of the
bonnet. Tyre pressures must be checked
when the tyres are cold, at least once
a
month.
Low tyre pressures increase the
electrical power consumption of your
vehicle, which reduces its range.
B. Tyre identification label.
This label is affixed to the driver's centre pillar.
It bears the following information:
-

t
he tyre pressures (in bars),
-
t

he tyre specification,
-

t
he type of tyre.C. Manufacturer's plate
.
This plate is riveted to the left hand centre
pillar.
D. Vehicle identification number (VIN).
This number is is engraved on the inner wheel
arch, inside the boot, right hand side.
For information on fitting snow chains,
contact a PEUGEOT dealer or a
qualified workshop.
It bears in particular the following information:
-

t
he vehicle model,
-

t
he paint code,
-

t
he type, variant, version.
Technical data

133
Ion_en_Chap11a_BTA_ed01-2014
EMERGENCY OR ASSIST ANCE CALL

134
Ion_en_Chap11a_BTA_ed01-2014
EMERGENCY OR ASSIST ANCE CALL
In an emergency, press this button for more than 2 seconds.
Flashing of the green LED and a voice message confirm
that the call has been made to the "PEUGEOT Connect
SOS" centre*.
The green LED remains on (without flashing) when communication is
established. It goes off at the end of communication.
When the ignition is switched on, the green
LED comes on for 3 seconds indicating that
the system is operating correctly.
Pressing this button again immediately cancels the request.
The cancellation is confirmed by a voice message.
Press this button for more than 2 seconds to request
assistance if the vehicle breaks down.
A voice message confirms that the call has been made**.
Pressing this button again immediately cancels the request. The green
LED goes off. Cancellation is confirmed by a voice message
To cancel a call, tell the "PEUGEOT Connect SOS" call centre that the call
was a mistake.
"PEUGEOT Connect SOS" immediately locates your vehicle, starts
communication with you in your language**, and where necessary sends the\

appropriate public emergency services**. In countries where the service \
is not
available, or when the locating service has been expressly declined, the\
call
sent directly to the emergency services (112) without the vehicle location. If an impact is detected by the airbag control unit, and
independently of the deployment of any airbags, an emergency call
is made automatically. If the orange LED flashes: there is a system
fault.
If the orange LED is on continuously: the
backup battery must be replaced.
In either case, contact a PEUGEOT dealer.
If you purchased your vehicle outside the PEUGEOT dealer network,
we invite you to have a dealer check the configuration of these services
and, if desired, modified to suit your wishes. In a multi-lingual country ,
configuration is possible in the official national language of your choice.
For technical reasons and in particular to improve the quality of
"PEUGEOT CONNECT services" services to customers, the manufacturer
reserves the right to carry out updates to the vehicle's on-board telema\
tic
system.
*

Subject to the general conditions for the service available from dealers\

and to technological and technical limitations.
**


Depending on the geographical cover of "PEUGEOT
Connect SOS",
"PEUGEOT Connect Assistance" and the official national language
selected by the owner of the vehicle.
The list of countries covered and PEUGEOT CONNECT services services
is available from dealers or at www.peugeot.co.uk.
PEUGEOT Connect SOS
PEUGEOT Connect Electric
If you benefit from the PEUGEOT Electric offer, you have other services
available to you in your MyPEUGEOT personal space, via the PEUGEOT
website in your country, accessible on www.peugeot.co.uk.
PEUGEOT Connect Assistance
Operation of the system

135
Ion_en_Chap11b_RDE2_ed01-2014
Audio system / Bluetooth®
01 First steps
For safety reasons, the driver must only carry out
operations which require prolonged attention while the
vehicle is stationary.
When the engine is switched off and to prevent
discharging of the battery, the system switches off after
activation of the energy economy mode.
CONTENTS
02 Radio
03
Audio
04

Using
the telephone
05
Audio settings
06
Configuration
07

Screen menu maps
Frequently

asked questions p.
p.
p.
p.
p.
p.
p.
p.
136
137
140
146
152
153
154
155After a battery disconnection, a code has to be entered
for operation of the radio.
A maximum of five attempts are possible. For the
last
two attempts, a 15 minutes wait is imposed between
each attempt.
Refer to the end of this document to find the label
indicating this code:

01
136
Ion_en_Chap11b_RDE2_ed01-2014
FIRST STEPS
Selection of source:
-
FM1, FM2, CD, USB,
AUX,
Streaming.
-

Accept an incoming call.
Long press:
-


access to the calls log of the
telephone connected.
-


or end a call if in progress. Adjust audio settings: sound
ambience, treble, bass,
loudness, distribution, left/
right balance, front/rear
balance, automatic volume.
On / Of

f and volume
adjustment. Abandon the current
operation.
Go up one level (menu or
folder).
Eject CD.
Select a preset radio station.
Radio: long press: preset a
radio station.
Other than radio: see the
corresponding sections.
Automatic search for a lower / higher radio
frequency.
Select previous / next CD, USB track..
Navigation in a list.
Press and hold: fast forwards or backwards.
Open the main menu.
Display the list of stations received, the
CD/USB tracks or folders.
Long press: update the list of stations
received.

02
137
Ion_en_Chap11b_RDE2_ed01-2014
Press SRC/TEL several times in
succession and select the FM1 or FM2
radio band.
Press a button to listen to the
corresponding preset station.Select the desired radio station and
confirm by pressing
"OK".
Radio
Press LIST to display the list of stations
received in alphabetical order.
The exterior environment (hills, buildings, tunnel, car park, below gro\
und...) may prevent reception, even in RDS station tracking mode.
This
phenomenon is normal in the propagation of radio waves and is in no way \
indicative of a fault with the audio system.
A long press on LIST builds or updates
the list of stations; audio reception is cut
momentarily.
Make a long press on one of the buttons
to preset the station being heard.
The name of the station is displayed
accompanied by an audible signal to
confirm the preset.
A press changes to the next or previous
letter (e.g. A, B, D, F, G, J, K, ...).
Managing the list
Presetting and selecting a station
RADIO

02
138
Ion_en_Chap11b_RDE2_ed01-2014
RDS, if displayed, enables you to continue listening to the same
station by automatic retuning to alternative frequencies. However,
in certain conditions, coverage of an RDS station may not be
assured throughout the country as radio stations do not cover
100 % of the territory. This explains the loss of reception of the
station during a journey.
RDS
With source FM1 or FM2, press MENU
then select "Radio".
Select or deselect "RDS" to activate or
deactivate RDS then confirm with "OK"
to save the setting.
Entering a frequency manually
Press MENU, select "Radio", then
select "Write freq.".
Press + or - to select the desired
frequency and confirm with "OK".
RADIO