stop start Peugeot iOn 2015 Owner's Manual

.
.
Instrument panel 9
I ndicator and warning lamps
1
0
Operation indicator lamps

1
1
Main battery state of charge indicator

1
8
Energy consumption / generation indicator
1

9
Distance recorder

2
0
Trip distance recorder

2
0
Lighting dimmer

2
1
Service indicator
2

1
Range indicator
2

3
MonitoringOver view
Eco-driving
Remote control key 2 4
Doors 27
Boot


28
Electric windows

2
9
Charging flaps
3

0
Access
Front seats 31
Rear seats
3
3
Mirrors


35
Interior fittings

3
7
Ventilation


40
Heating


42
Air conditioning
4

2
Front demist - defrost

4
5
Rear screen demist - defrost

4
5
Comfort
Driving recommendations 46
Starting - stopping the vehicle
4
7
Parking brake

4
8
Drive selector
49
Driving
Lighting controls 5 1
Automatic illumination of headlamps
5
3
Headlamp adjustment
5

3
Wiper control

5
4
Courtesy lamp

5
5
Visibility
Contents

26
Ion_en_Chap02_ouvertures_ed01-2014
Lost keys
Visit a PEUGEOT dealer with the vehicle's V5 registration document and your personal
identification documents.
The PEUGEOT dealer will be able to retrieve the key code and the transponder code
required to order a replacement key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your
pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of
your vehicle. You run the risk of stopping it from working.
The remote control does not operate when the key is in the ignition, even when the ignition
is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the
emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition when you
leave the vehicle, even for a short time.
Anti-theft protection
Do not make any modifications to the electronic immobiliser system; this could cause
malfunctions.
When purchasing a second-hand vehicle
Have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your
possession are the only ones which can start the vehicle.
Access

45
Ion_en_Chap03_confort_ed01-2014
Switch off the demisting/defrosting
of the rear screen and door mirrors
as soon as appropriate, so as to limit
electrical consumption and optimise the
range of the vehicle.
Front demist -
defrostRear screen demist - defrostThe control button is located on the right of the centre console.
F
P
ress this button to demist /defrost
the rear screen and (depending
on version) the door mirrors. The
indicator lamp associated with the
button comes on.
Place the air distribution control in
this position.
Switching on
Switching off
The demisting/defrosting switches off automatically
to prevent an excessive electric consumption.
F

I
t is possible to stop the demisting/
defrosting operation before it is switched
off automatically by pressing the button
again. The indicator lamp associated with
the button goes off.
For rapid demisting - defrosting, you
can also press the " MAX" button.
The intake of exterior air is selected (indicator
lamp off) and depending on equipment, the air
conditioning starts running (indicator lamp on).
Place the temperature control
between "●" and " H".
Place the air flow control
in the desired position.
Front demisting-defrosting can be used as
soon as the "Ready" lamp is on.
Rear screen demisting/defrosting can only
operate when the "Ready" lamp is on.
3
Comfort

47
Ion_en_Chap04_conduite_ed01-2014
Starting - stopping the vehicle
- Position 1: LOCK The steering is locked.
-

P
osition 2: ACC
T

he ancillaries (radio, 12 V socket...) can
be used.
-

P
osition 3: ON
I

gnition on.
-

P
osition 4: S TA R T
"

Ready" lamp on.
M

otor ready to drive the vehicle.
Ignition switch
F Check that the drive selector is in position P.
F

I
nsert the key in the ignition switch.
F

T
urn the key to position 4 (S TA R T ) .
StartingStopping
F Stop the vehicle.
F
K eep your foot on the brake pedal.
F

P
lace the drive selector in position P .
F

A
pply the parking brake.
F

T
urn the key to position 1 (LOCK) .
F

R
emove the key from the ignition switch.
F

H

old it in this position for a few
seconds until the " RE ADY " lamp
comes on accompanied by an
audible signal.
F

R

elease the key.
T

he key returns automatically to position 3
(ON) . Do not attach any heavy objects to the
key as this could weigh down on it when
in the ignition switch and cause a fault.
If you use the ancillaries for a prolonged
period (with the key in the ACC position),
you risk discharging the ancillaries
battery. Starting your vehicle will then no
longer be possible. Be aware.
4
Driving

86
Ion_en_Chap08_info-pratiques_ed01-2014
Do not touch the metal end of the
normal charging socket or of the
charging cable (risk of electrocution
and/or faults).
F

P

ress the latch 2 to open the socket cover. F

E

nsure that there is no foreign object on
the vehicle's socket.
F

R

emove the protective cover from the
charging cable.
F

I

nsert the charging plug into the socket
without pressing the button, until it clicks
into place .
Use the cord supplied to hook the
control unit, so that it does not weigh
down on the power point (risk of
damage to the charging cable or
electric power point). F
C
heck that the charging lamp
in the instrument panel and
the green CHARGING lamp in
the control unit are on fixed.
The start of charging may be
accompanied by the noise of a fan
running. This noise is perfectly normal.
The charge may be interrupted at any
time by withdrawing the charging plug.
If this is not the case, charging has not
started; repeat the procedure, ensuring that all
connections are correct.
The state of charge indicator for the main
battery is displayed in the instrument panel and
the number of bars illuminated increases as the
battery is charged.
If exceptionally you have to interrupt the
charge by disconnecting the charging
cable from the power point, it is
essential to first press the Manual Stop
button on the control unit.
Never connect or disconnect the the
cable or charging plug with wet hands

(risk of electrocution).
Practical information

i
92
Ion_en_Chap08_info-pratiques_ed01-2014
F Check that the charging warning lamp
in the instrument panel is on fixed.
Fast charging stops automatically when
the battery is around 80 % charged.
It is possible to attain a level of 100 %
charged by restarting the procedure.
However, the time taken by this
additional charge will be relatively long,
as the charging rate is reduced. During the fast charge, the vehicle's air
conditioning may start automatically,
if needed to cool the main battery. It is
therefore perfectly normal to hear the
noise of a fan running from outside the
vehicle and to see a puddle of water
form under the vehicle.As a safety measure, the motor will
not start when the charging cable is
connected to the vehicle's socket.
Also, any attempt to start the motor
interrupts the charging procedure. It
will then be necessary to disconnect
and reconnect the charging cable
plug to continue charging, following
the instructions for using the charging
station.If the ambient temperature is below 0 °C,
the charging time may be longer.
If the ambient temperature is below -25 °C,
charging may not be possible.
If this is not the case, charging has not started;
check the operating instructions for the
charging station. The charging warning lamp in the instrument
panel goes off when charging is complete.
F
D
isconnect the charging cable following
the instructions for the charging terminal.
F
C
lose the charging socket cover and the flap.
After charging, close the charging
socket cover and flap.
Take care to avoid the ingress of water
or dust to the socket and its cover
or the charging plug. Risk of fire or
electrocution.
Vehicle out of use for a long
period
When your vehicle is going to be out
of use for a long period, charge the
main battery completely every three
months (following the normal charging
procedure).
Before charging, check that the
ancillaries battery is not disconnected
or discharged. If this is the case, refer
to the "ancillaries battery" section for
reconnecting or charging the battery.
Practical information

04


149
Ion_en_Chap11b_RDE2_ed01-2014
USING THE TELEPHONE
Make along press on SRC/TEL to
display the calls list.
In the list of calls, select the number and choose
"Missed calls", "Dialed calls" or "Answered
calls". Previous or next page in the calls list.
"OK" starts the call.
Making a call - Recently called numbers*
Navigation in the calls list.
The calls list includes the calls sent from and by from the vehicle via \
the connected telephone.
It is possible to make a call directly from the telephone; stop the
vehicle as a safety measure.
* Depending on the compatibility of the telephone.
For access to the calls list, it is also possible to press MENU,
select

"T

elephone", then select "Call", and finally select "Calls list".

158
Ion_en_Chap11b_RDE2_ed01-2014
FREqUENTLY ASKED q UESTIONS
qUESTION ANSWER SOLUTION
An iPod is not recognised
when connecting to the
USB port. The iPod is of a generation that is not compatible with the USB.
The hard disk or device
is not recognised when
connecting to the USB
port. Some hard disks and devices need a power supply greater than is
provided by the audio system.
Connect the device to the 230 V socket, the 12 V
socket or an external power supply
.
Caution: ensure that the device does not transmit
a voltage greater than 5 V (risk of destruction of
the system).
When streaming, the
sound cuts momentarily. Some telephones prioritise connection of the "hands-free" profile.
Delete the "hands-free" connection profile to
improve streaming.
In "Random all" play,
not all of the tracks are
played. In "Random all" play, the system can only take into account up to
999
tracks.
With the engine off, the
audio system switches
off after a few minutes
of use. When the engine is switched off, the audio system operating time
depends on the battery charge.
The switch-off is normal: the audio system switches to economy mode
and switches off to prevent discharging the vehicle's battery. Start the vehicle's engine to increase the battery
charge.
The message "the audio
system is overheated"
appears on the display. In order to protect the installation if the surrounding temperature is t\
oo
high, the audio system switches to an automatic thermal protection mode \
leading to a reduction of the volume or stopping of the playing of the C\
D. Switch the audio system off for a few minutes to
allow the system to cool.

159
Ion_en_Chap12_recherche-visuelle_ed01-2014
Exterior
Remote control key 24-25
- u nfolding / folding the key
-

u
nlocking /locking
the vehicle
-
a

nti-theft protection
Starting - Stopping the vehicle

4
7 Lighting


51-53
Headlamp height adjustment
5

3
Changing bulbs
1

06-111
-

f
ront lamps
-


foglamps
-
d

aytime running lamps
-
d

irection indicator repeaters
Wipers
54
Changing a wiper blade
1

19 Door mirrors

3
5
Doors
27
-
ope

ning / closing
Electric windows

2
9
Charging flaps
3

0
Charging the main battery
8

5 -92
-
normal
-
fast
Accessories
1

20-121
ABS, EBFD, EBA, ASR, ESP

6
2- 64
Tyre pressures
1

32
Under-inflation detection
5

8-61
Changing a wheel
1

01-104
Snow chains

1
05
Boot


28
-
ope

ning / closing
Changing bulbs
1

11-113
-
r

ear lamps
-

3
rd brake lamp
-

n
umber plate lamps
-


foglamp Recovery
119
.
Visual search

162
Ion_en_Chap12_recherche-visuelle_ed01-2014
Instruments and controls (continued)
Lighting control 51-53
Direction indicators 5 6
Automatic operation of brake lamps

5
6
Instrument panels
9
W
arning lamps
1
0-17
Indic ators

18 -23
-
m
ain battery state of charge
indicator
-
e
nergy consumption /
generation indicator
-

speedometer
-
t
otal distance recorder
-
t
rip distance recorder
-
l
ighting dimmer
-
ser
vice indicator
-
r
ange indicator
Horn 57Hazard warning lamps
5

6
Wiper control
5
4
Ignition switch, starting/stopping the vehicle


47
Door mirrors

3
5 Emergency or assistance
c all
5

7, 13 3 -13 4
Headlamp height adjustment
5

3
Visual search