ECU Peugeot iOn 2018 User Guide

87
Parking brake
If excessive travel or a loss of
effectiveness of this system is
noticed, the parking brake must
be checked, even between two
services.
This system must be checked by a PEUGEOT
dealer or a qualified workshop.
Only use products recommended by
PEUGEOT or products of equivalent
quality and specification.
In order to optimise the operation of
components as important as those in the
braking system, PEUGEOT selects and
offers very specific products.
After washing the vehicle, dampness, or
in wintry conditions, ice can form on the
brake discs and pads: braking efficiency
may be reduced. Make light brake
applications to dry and defrost the brakes.
Changing a wiper blade
Removing front or rear
wiper blades
F Raise the corresponding wiper arm.
F T ake off the wiper blade by sliding it to the
outside.
Fitting front or rear wipers
F Put the new wiper blade in place and secure it.
F

C
arefully lower the wiper arm.
Washing precautions
Never wash the vehicle while the battery
is on charge.
Before washing the vehicle, check that
the access flaps and the charging socket
covers (normal and fast) are closed
properly.
In order to avoid damaging the electric
units, the use of a high pressure jet wash
is strictly forbidden:
-

u
nder the bonnet,
-

u
nder the chassis.
Do not use a pressure greater than
80
bars when washing the bodywork.
7
Practical information

88
Ancillaries battery
All of the electrical components on your vehicle
(with the exception of the electric motor, the
heating and the air conditioning) are powered
by the ancillaries battery.
It is located in the front compartment under
the bonnet and is charged by the main battery
during phases of operation ("Ready" lamp on in
the instrument panel) and charging.If the ancillaries battery is discharged,
the electric motor cannot be started and
charging of the main battery is no longer
possible.
It is not recommended to disconnect the
battery.
However, during a prolonged period of
more than one month without using your
vehicle, it may be necessary, in winter,
to disconnect the battery and store it to
prevent the electrolyte freezing.
After prolonged disconnection of the
battery, you must consult a PEUGEOT
dealer or a qualified workshop in order to
have the electronic computer reset.
Access to the battery
F Open the bonnet using the interior release lever and then the exterior safety catch.
F

S
ecure the bonnet stay.
F

L
oosen the nut 1 .
F

R
emove the protective cover from the
battery for access to the two terminals.
Starting using another
battery
Make sure the electrolyte is not frozen.
Check the level and top up with distilled
water, if necessary.
For more information on Checking levels ,
refer to the corresponding section.
Ensure that the back-up battery is a 12
V
battery.
F

L
ift the protective cover from the (+)
terminal,
In the event of a breakdown