remote start Peugeot iOn 2018 Owner's Manual

19
Remote control key
System used to lock or unlock the vehicle's
central locking system with a key or remotely.
It also starts the vehicle and provides anti-theft
protection.
Unfolding/folding the key
F Press button A to unfold or fold the key.
Unlocking the vehicle
Unlocking using the remote
control
F Press the open padlock button to unlock the vehicle.
Unlocking is confirmed by illumination of the
interior courtesy lamp for about 15
seconds
and the direction indicators flashing twice.
Unlocking using the key
F Turn the key towards the right in the
driver's door lock to unlock the vehicle.
Unlocking is confirmed by illumination of the
interior courtesy lamp for about 15

s
econds and
the direction indicators flashing twice .
However, the door mirrors do not unfold.
The passenger door lock does not allow
the locking or unlocking of the other doors
and/or of the boot.
The vehicle will lock again automatically
after thirty seconds unless a door or the
boot is opened. This mechanism helps
avoid unlocking by mistake.
Locking the vehicle
The door mirrors unfold at the same time
(depending on version).
Normal locking using the remote
control
F Press the closed padlock button to lock the vehicle. Locking is confirmed by the direction indicators
flashing once
.
The door mirrors fold at the same time
(depending on version).
Normal locking using the key
F Turn the key towards the left in the driver's door lock to lock the vehicle.
Locking is confirmed by the direction indicators
flashing once .
However, the door mirrors do not fold.
Anti-theft protection
Electronic immobiliser
The key contains an electronic chip which has
a specific code. When the ignition is switched
on, this code must be recognised to enable the
vehicle to start.
This electronic immobiliser locks the motor
management system a few minutes after the
ignition is switched off and prevents the engine
being started by anyone who does not have
t h e key.
In the event of a fault, or if your vehicle does
not start, contact a PEUGEOT dealer as soon
as possible.
2
Access

20
In the event of a fault with the remote control,
you can no longer unlock or lock your vehicle.
F
F
irst of all, use the key in the driver's door
lock to unlock or lock your vehicle.
F

S
econdly, ask a PEUGEOT dealer to check
the operation of the remote control and to
replace the battery if necessary. Lost keys
See a PEUGEOT dealer with the vehicle
registration certificate and your ID.
A PEUGEOT dealer can retrieve the key
code and the transponder code to order the
replacement key.
Remote control problemAnti-theft protection
Do not make any modifications to the
electronic vehicle immobiliser system; this
could cause malfunctions.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while
it is in your pocket as there is a possibility
that it may unlock the vehicle without you
being aware of it.
Do not repeatedly press the buttons of
your remote control when out of range and
out of sight of your vehicle, as it may stop
working.
The remote control does not operate when
the key is in the ignition, even when the
ignition is switched off.
Locking the vehicle
Driving with the doors locked may make
access to the passenger compartment by
the emergency ser vices more difficult in an
emergency.
As a safety precaution (with children on
board), remove the key from the ignition
when leaving the vehicle, even for a short
time. When purchasing a second-hand vehicle
Have the key codes memorised by a
PEUGEOT dealer, to ensure that the keys in
your possession are the only ones which can
start the vehicle.
Access

34
Front demist – defrost
Place the air distribution
adjustment control in this position.
The intake of exterior air is selected (indicator
lamp off) and, depending on equipment, the air
conditioning comes on (indicator lamp lit). Place the temperature adjustment
control between "●" and " H".
Place the air flow adjustment
control in the desired position.
For fast demisting/defrosting, you can also
press the " MAX" button.
Rear screen demist –
defrost
Switching on
F Press this button to demist /
defrost the rear screen and,
depending on version, the door
mirrors. The button indicator
lamp comes on.
Switching off
Demisting/defrosting switches off automatically
to prevent an excessive consumption of
electricity.
F

I
t is possible to stop the
demisting/defrosting operation
before it is switched off
automatically by pressing the
button again. The warning lamp
for the button goes out. Switch off the demisting/defrosting of
the rear screen and door mirrors as
soon as appropriate in order to control
the vehicle's electrical consumption and
optimise its range.
Remote control
(Depending on equipment.)
The remote control can be used to control the
following functions remotely:
-

C
heck the vehicle's charge status.
-
R

echarge programming: start time and
charge duration.
-

A
ctivate the air conditioning functions
(heating, air conditioning, demist - defrost).
To programme recharging, the following
conditions must be met:
-

P
lace the drive selector in position P .
-

P
lace the switch to LOCK .
-

C
onnect the vehicle with the normal
recharging cable.
The remote control range is approximately
100
metres.
Ease of use and comfort

35
Buttons
1.On/off, data transmission.
2. MODE: allows you to scroll through the
different available functions (charge start,
charge duration, thermal comfort).
3. Immediate vehicle charging (reset
programmings to zero).
4. Settings.
Display screen
1.Data transmission status indicator.
2. Recharge indicator.
3. Fault indicator.
4. Battery charge status indicator.
5. Recharge programming function status
i n d i c a t o r.
6. Charge time remaining indicator.
7. Thermal comfort function status indicator.
On/Off
Extend the aerial.
Press and hold this button to switch
the remote control on or off.
The remote control will switch off
automatically if no action takes place
within thirty seconds.
Charge start programming
This function is used to set the remaining time
before starting to charge your vehicle.
(Example: it is 7 p.m. when the system is
programmed and the programmed charge time
is two hours: charging will start at 9 p.m.).
Switch on the remote control.
This symbol is displayed on the
screen.
Use the arrows to adjust the charge start time:
each press adjusts the time in half-hourly
intervals.
Press the on/off button briefly to send the data
to the vehicle.
3
Ease of use and comfort

36
If the charge start is programmed without
programming the charge duration, the
battery will be charged fully.
Charge duration
programming
This function is used to set the charging time
for your vehicle.
Switch on the remote control.
Press the MODE button to select the charge
duration programming.This symbol is displayed on the
screen.
Use the arrows to adjust the charging time:
each press adjusts the time in half-hourly
intervals.
Press the on/off button briefly to send the data
to the vehicle.
The charge duration can be programmed
for between 0.5 and 19.5
hours. However,
you can also select the duration "-h": in
this case, charging will stop when the
battery is fully charged. This duration is
the value entered by default. If the charge duration is programmed
without programming the start time, the
battery will be charged immediately for
a duration corresponding to the one
programmed.
Cancelling programmings
With the remote control
Press the charge immediately
button, then press the on/off button
briefly to send the data to the
vehicle.
With the switch
Turn the vehicle's ignition switch to the ON

position then turn it to LOCK .
Any programming carried out with remote
control is cancelled automatically every
time the vehicle is started.
Thermal comfort
programming
This function is used to programme the running
of the:
-

heating,
-
a

ir conditioning,
-


demisting.To programme the heating, air
conditioning or demisting functions, the
following conditions must be met.
-

T
he drive selector is in position P .
-

T
he ignition switch is on LOCK .
-

T
he vehicle is connected with the
normal recharging cable.
-

A
ll the doors are closed properly.
-

T
he battery is sufficiently charged (one
bar minimum).
For maximum efficiency in programming
the thermal comfort, make sure that all the
vehicle's windows are closed.
Ease of use and comfort

90
F Disconnect the cable from the (-) terminal.
F L ift the protective cover from the (+)
terminal


2.
F

S
lacken the nut 3 .
F

D
isconnect the cable from the (+) terminal.
F

R
emove the battery.
F

C
harge the battery following the instructions
on use provided by the manufacturer of the
battery charger.
F

R
econnect the battery starting with the
cable on the (+) terminal.
Ensure that the terminals and connectors
are clean. If they are covered with
sulphate (whitish or greenish deposit),
remove and clean them. Do not charge the battery without first
disconnecting the terminals and removing
the battery from the front compartment.
Do not disconnect the terminals when the
"Ready" lamp is on, nor when the vehicle
is on charge.
Before disconnecting
Wait 2
minutes after switching off the
ignition before disconnecting the battery.
After reconnection
Following reconnection of the battery,
switch on the ignition and wait 1 minute
before starting, to permit initialisation of
the electronic systems. However, if minor
problems persist following this operation,
contact a PEUGEOT dealer or a qualified
workshop.
Remember to reinitialise the audio system
yourself.
Batteries contain harmful substances such as
sulphuric acid and lead. They must be disposed
of in accordance with local regulations and
must not, in any circumstances, be discarded
with household waste.
Take used remote control batteries and vehicle
batteries to a designated collection point.
Temporary puncture
repair kit
Scan the QR code on page 3 to view
explanatory videos.
Complete kit comprising a compressor and a
sealant bottle, which allows the temporary
repair of a tyre so that you can drive to the
nearest garage.
It is designed to repair most punctures which
could affect the tyre, located on the tyre tread
or shoulder.
Access to the kit
This kit is stored in the storage box located
under the rear bench seat, right-hand side.
Therefore, to access the kit you must remove
the rear seat.
In the event of a breakdown