door lock Peugeot iOn 2018 Owner's Manual

2
.
.
Instrument panel 7
W arning and indicator lamps 7
M
ain battery state of charge indicator
1
4
Energy consumption/generation indicator
1

4
Instrument panel display screen

1
5
Instruments and controls

4
R
emote control key
1
9
Doors

21
Boot
2
1
Electric windows
2
2
Charging flaps
2
3
Front seats
2
4
Rear seats
2

5
Mirrors
26
Interior fittings

2
7
Ventilation
2

9
Recommendations for ventilation and air
conditioning
3

0
Heating
3

1
Air conditioning

3
2
Front demist – defrost

3
4
Rear screen demist – defrost

3
4
Remote control

3
4Lighting control stalk

4
0
Headlamp beam height adjustment
4
2
Wiper control stalk
4
2
Courtesy lamp
4
3
General safety recommendations
4
5
Hazard warning lamps
4

6
Brake lamps, automatic operation
4

6
Horn


46
Horn for pedestrians

4
6
Emergency or assistance call
4

7
Braking assistance systems

4
8
Trajectory control systems

4
9
Engine brake reduction indicator lamp

5
0
Seat belts
5

1
Airbags


54
Child seats

5
7
Deactivating the passenger's front airbag
5

8
ISOFIX mountings and child seats

6
3
Advice on child seats

6
6
Child lock

6
7
Over view
Dashboard instruments Access
Ease of use and comfort Safety
Lighting and visibility
Eco-driving
Contents

10
Warning/indicator lampStateCause Action/Observations
Door(s) open/Boot
open Fixed, accompanied
by an audible signal. A door or the boot is still open. Close the door or boot.
Parking brake Fixed. The parking brake is applied or
not properly released. Release the parking brake to switch off the warning
light, keeping your foot on the brake pedal.
Observe the safety recommendations.
For more information on the Parking brake
, refer to
the corresponding section.
Braking Fixed. The brake fluid level has
dropped significantly.
There is a braking assistance
system fault. Stop as soon as it is safe to do so.
Top up with brake fluid approved by PEUGEOT.
If the problem persists, have the system checked by a
PEUGEOT dealer or a qualified workshop.
+ Fixed, associated
with the ABS warning
lamp.
The electronic brake force
distribution (EBFD) system is
faulty. You must stop as soon as it is safe to do so.
Have it checked by a PEUGEOT dealer or a qualified
workshop.
Anti-lock Braking
System (ABS) Fixed.
The anti-lock braking system
has a fault. The vehicle retains conventional braking capabilities.
Drive carefully at reduced speed and contact a
PEUGEOT dealer or a qualified workshop without
d e l ay.
Orange warning/indicator lamps
Dashboard instruments

19
Remote control key
System used to lock or unlock the vehicle's
central locking system with a key or remotely.
It also starts the vehicle and provides anti-theft
protection.
Unfolding/folding the key
F Press button A to unfold or fold the key.
Unlocking the vehicle
Unlocking using the remote
control
F Press the open padlock button to unlock the vehicle.
Unlocking is confirmed by illumination of the
interior courtesy lamp for about 15
seconds
and the direction indicators flashing twice.
Unlocking using the key
F Turn the key towards the right in the
driver's door lock to unlock the vehicle.
Unlocking is confirmed by illumination of the
interior courtesy lamp for about 15

s
econds and
the direction indicators flashing twice .
However, the door mirrors do not unfold.
The passenger door lock does not allow
the locking or unlocking of the other doors
and/or of the boot.
The vehicle will lock again automatically
after thirty seconds unless a door or the
boot is opened. This mechanism helps
avoid unlocking by mistake.
Locking the vehicle
The door mirrors unfold at the same time
(depending on version).
Normal locking using the remote
control
F Press the closed padlock button to lock the vehicle. Locking is confirmed by the direction indicators
flashing once
.
The door mirrors fold at the same time
(depending on version).
Normal locking using the key
F Turn the key towards the left in the driver's door lock to lock the vehicle.
Locking is confirmed by the direction indicators
flashing once .
However, the door mirrors do not fold.
Anti-theft protection
Electronic immobiliser
The key contains an electronic chip which has
a specific code. When the ignition is switched
on, this code must be recognised to enable the
vehicle to start.
This electronic immobiliser locks the motor
management system a few minutes after the
ignition is switched off and prevents the engine
being started by anyone who does not have
t h e key.
In the event of a fault, or if your vehicle does
not start, contact a PEUGEOT dealer as soon
as possible.
2
Access

20
In the event of a fault with the remote control,
you can no longer unlock or lock your vehicle.
F
F
irst of all, use the key in the driver's door
lock to unlock or lock your vehicle.
F

S
econdly, ask a PEUGEOT dealer to check
the operation of the remote control and to
replace the battery if necessary. Lost keys
See a PEUGEOT dealer with the vehicle
registration certificate and your ID.
A PEUGEOT dealer can retrieve the key
code and the transponder code to order the
replacement key.
Remote control problemAnti-theft protection
Do not make any modifications to the
electronic vehicle immobiliser system; this
could cause malfunctions.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while
it is in your pocket as there is a possibility
that it may unlock the vehicle without you
being aware of it.
Do not repeatedly press the buttons of
your remote control when out of range and
out of sight of your vehicle, as it may stop
working.
The remote control does not operate when
the key is in the ignition, even when the
ignition is switched off.
Locking the vehicle
Driving with the doors locked may make
access to the passenger compartment by
the emergency ser vices more difficult in an
emergency.
As a safety precaution (with children on
board), remove the key from the ignition
when leaving the vehicle, even for a short
time. When purchasing a second-hand vehicle
Have the key codes memorised by a
PEUGEOT dealer, to ensure that the keys in
your possession are the only ones which can
start the vehicle.
Access

21
Doors
Opening
From outside
F After unlocking the vehicle using the remote control or the key, pull the door
handle.
From inside
F Pull the front or rear door control to open the door.
If the doors are locked:
-
o

pening the driver's door unlocks the other
doors,
-

t
he front passenger door or the rear doors
must first be manually unlocked using the
lock control before being opened.
Closing
If a door or the boot is not properly
closed, this warning lamp comes
on in the instrument panel until the
relevant door or the boot is closed.
Locking/unlocking from
inside
F Push the driver's door button for wards to lock or rear wards to unlock the entire
vehicle. The front and rear passenger door buttons
lock /unlock only the corresponding door.
Boot
Opening
F After unlocking the vehicle using the
remote control or the key, press the
handle


A, then raise the tailgate.
2
Access

23
Always remove the key from the ignition
when leaving the vehicle, even for a short
time.
In the event of contact during operation of
the electric windows, you must reverse the
movement of the window. To do this, press
the corresponding control.
When operating the passenger electric
window switches, the driver must ensure
that no-one is preventing correct closing
of the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating the
windows.
Charging flaps
Normal charging
F Pull control A in the lower part of the dashboard, driver's side, to unlock the
access flap.
F

O
pen the access flap on the right-hand
side of the vehicle.
F

P
ress on latch B to open the socket cover.
Fast charging
(Depending on equipment.) F
P
ull control C under the driver's seat, near
the door, to unlock the access flap.
F
O
pen the access flap on the left-hand side
of the vehicle.
F
P
ress on latch D to open the socket cover.
For more information on Recharging the
main battery , refer to the corresponding
section.
2
Access

26
Folding the backrest
1.Place the head restraints in the low
position or remove them if necessary.
2. Pull the control for wards to release the
seat backrest.
3. Tilt the backrest for wards.
Returning the backrest to the normal position
When returning the seat backrest to its
normal position, take care not to trap the
seat belts and their buckles.
Mirrors
Door mirrors
Adjustment
Adjustment is possible when the switch is in
position "ON" or "ACC".
F

M
ove control A to the right or to the left to
select the corresponding mirror.
F

M
ove control B in any of the four directions
to adjust the mirror.
After adjustment, return control A to the central
position.
F Put the seat backrest in the upright position and lock it in place.
F

R
efit or put the head restraints back in place.
Ease of use and comfort

27
Rear view mirrorInterior fittings
1.Glove box
2. Retractable cup holders
Press the lid to open the cup holder.
3. 12
V accessor y socket (120 W)
Obser ve the maximum power rating to
avoid damaging your accessory.
Adjust the rear view mirror by moving it
upwards, downwards and/or to the left or right.
The rear view mirror has two positions:
-

d

ay (normal),
-

n

ight (anti-dazzle).
To change from one to the other, push or pull
the lever on the lower edge of the mirror.
Electric door mirror folding/
unfolding
(Depending on version.)
F
I
gnition switch in the "ON" or "ACC"
position: press control C to unfold them.
F

I
gnition switch in the "LOCK" position: press
control C within 30
seconds to fold them.
The door mirrors can also be folded
manually.
However, they must never be unfolded
manually because they may not remain in
position when driving.
Always use control C to unfold them.
3
Ease of use and comfort

34
Front demist – defrost
Place the air distribution
adjustment control in this position.
The intake of exterior air is selected (indicator
lamp off) and, depending on equipment, the air
conditioning comes on (indicator lamp lit). Place the temperature adjustment
control between "●" and " H".
Place the air flow adjustment
control in the desired position.
For fast demisting/defrosting, you can also
press the " MAX" button.
Rear screen demist –
defrost
Switching on
F Press this button to demist /
defrost the rear screen and,
depending on version, the door
mirrors. The button indicator
lamp comes on.
Switching off
Demisting/defrosting switches off automatically
to prevent an excessive consumption of
electricity.
F

I
t is possible to stop the
demisting/defrosting operation
before it is switched off
automatically by pressing the
button again. The warning lamp
for the button goes out. Switch off the demisting/defrosting of
the rear screen and door mirrors as
soon as appropriate in order to control
the vehicle's electrical consumption and
optimise its range.
Remote control
(Depending on equipment.)
The remote control can be used to control the
following functions remotely:
-

C
heck the vehicle's charge status.
-
R

echarge programming: start time and
charge duration.
-

A
ctivate the air conditioning functions
(heating, air conditioning, demist - defrost).
To programme recharging, the following
conditions must be met:
-

P
lace the drive selector in position P .
-

P
lace the switch to LOCK .
-

C
onnect the vehicle with the normal
recharging cable.
The remote control range is approximately
100
metres.
Ease of use and comfort

36
If the charge start is programmed without
programming the charge duration, the
battery will be charged fully.
Charge duration
programming
This function is used to set the charging time
for your vehicle.
Switch on the remote control.
Press the MODE button to select the charge
duration programming.This symbol is displayed on the
screen.
Use the arrows to adjust the charging time:
each press adjusts the time in half-hourly
intervals.
Press the on/off button briefly to send the data
to the vehicle.
The charge duration can be programmed
for between 0.5 and 19.5
hours. However,
you can also select the duration "-h": in
this case, charging will stop when the
battery is fully charged. This duration is
the value entered by default. If the charge duration is programmed
without programming the start time, the
battery will be charged immediately for
a duration corresponding to the one
programmed.
Cancelling programmings
With the remote control
Press the charge immediately
button, then press the on/off button
briefly to send the data to the
vehicle.
With the switch
Turn the vehicle's ignition switch to the ON

position then turn it to LOCK .
Any programming carried out with remote
control is cancelled automatically every
time the vehicle is started.
Thermal comfort
programming
This function is used to programme the running
of the:
-

heating,
-
a

ir conditioning,
-


demisting.To programme the heating, air
conditioning or demisting functions, the
following conditions must be met.
-

T
he drive selector is in position P .
-

T
he ignition switch is on LOCK .
-

T
he vehicle is connected with the
normal recharging cable.
-

A
ll the doors are closed properly.
-

T
he battery is sufficiently charged (one
bar minimum).
For maximum efficiency in programming
the thermal comfort, make sure that all the
vehicle's windows are closed.
Ease of use and comfort