19
Partner_2_VP_en_Chap03_Pret-a-partir_ed02-2014
Good practice
take care not to allow the remote
control to come into contact with
grease, dust, rain or a damp
environment.
A
heavy object attached to the key
(keyring, ...) weighing on the shaft of
the key in the switch, may cause a
malfunction.
REMOTE CONTROL Reinitialising the remote control
Following changing of the remote
control battery or disconnection of the
vehicle battery, the remote control may
have to be reinitialised.
Wait at least one minute before using
the remote control.
Insert the key in the ignition switch with
the buttons (padlocks) of the remote
control facing you.
Switch on the ignition.
Press the locking padlock for at
least five seconds within the next
ten
seconds.
Switch off the ignition.
Wait at least one minute before using
the remote control.
t
he remote control is now working
again.u
se only identical batteries or
batteries of an equivalent type to those
recommended by P
euge
O
t
dealers.
Do not discard the remote control
batteries, they contain metals which
are harmful to the environment.
Deposit them at a P
euge
O
t
dealership, or at an authorised
collection point.
Folding / unfolding the key
Changing the battery
Battery ref.: CR1620 / 3 volts.
The "battery flat" information is given
by an audible signal, accompanied by
a message in the screen.
to replace the battery
, unclip the
casing using a coin at the ring.
If the remote control does not work
after the battery has been changed,
reinitialise the remote control.
t
here is a risk of damage if the
replacement battery is not the correct
type. Press this button to release
the key from its housing.
to fold the key
, press this
chromed button then fold
the key into the housing.
If you do not press the button, the
mechanism may be damaged.
Access
ReADY tO Set OFF
3
