four wheel drive Peugeot Partner VP 2004 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2004, Model line: Partner VP, Model: Peugeot Partner VP 2004Pages: 128, PDF Size: 1.49 MB
Page 8 of 128
9YOUR PARTNER AT A GLANCE
STEERING WHEEL HEIGHT ADJUSTMENT When stationary, push the control Aforwards to unlock
the steering wheel.
Adjust the height of the stee-ring wheel.
Lock it by pulling control A
towards you fully.CRUISE CONTROL The cruise control makes it pos- sible to maintain a constant vehicle
speed, programmed by the driver,irrespective of the profile of theroad and without any action on theaccelerator or the brake pedals. In order for the vehicle speed to be memorised, it must be greater thanapproximately 25 mph (40 km/h)and fourth or fifth gear must beengaged.
Activation Place the knob 1in the ON
position
A speed can now be memorised. Place the knob 1in the OFF
position to deactivate the system.
Memorising a speed When you reach the required speed, press button 2or 3. The
speed is memorised and will be
maintained automatically. Deactivating the memorised speed If you wish to deactivate the memorised speed: press button 4or the brake or
clutch pedal.
Recalling the memorised speed After deactivation, press button 4 . Your vehicle reverts to the last
memorised speed. Cancelling the stored speed Place the knob 1in the OFF
position or switch off the ignition.
7889
22-12-2003
Page 119 of 128
22-12-2003
PRACTICAL INFORMATION
112
TOWING YOUR VEHICLE
Without lifting (four wheels on the ground)
You must always use a tow bar. From the front or the rear Attach the tow bar to the towing eye. By lifting (two wheels only on the ground) It is preferable to lift the vehicle by the wheels.
SNOW SCREEN*The snow screen is installed on the lower part of the front bumper to pre-vent the accumulation of snow at theradiator cooling fan. When the snow has cleared, do not forget to remove the snowscreen. FITTING
Offer up the snow screen facing its centring pin Aon the front
bumper.
Put it in place by pressing ateach clip Blocated in the four
corners.
REMOVAL Pass a screwdriver into the hole located near each of the clips.
Use the screwdriver as a lever tounclip the four clips Bin turn.
* According to destination.
Never use the radiator crossmember.