Peugeot Partner VU Dag 2004 Owner's Manual

CHANGING A FUSE The fuse boxes are located under the fascia and in the engine compartment. Fascia fuse box Unclip the cover to gain access to the fuses. The spare fuses and the pliers Bare
secured on the inside of the cover A.
PRACTICAL INFORMATION
96
22-12-2003
Removing and fitting a fuse
Before changing a fuse, the cause of the fault must be found and remedied. The fuse numbers are indicated on the fuse box. Use the pliers
B.
Always replace a faulty fuse (identification according to fuse) with a fuse of the same rating.
Correct Pliers B
Incorrect

PRACTICAL INFORMATION
98
22-12-2003
Engine compartment fuse box
To gain access to the box in the engine compartment (next to the battery), unclip
the cover.
After carrying out work, close the cover very carefully.
The electrical circuit of your vehicle is designedto operate with standardor optional equipment.
Before installing other electricalequipment or accessories in yourvehicle, consult a PEUGEOT
dealer. Some electrical accessories or the way in which they are fittedmay have an adverse effect onthe operation of your vehicle (itselectronic control circuits, theaudio circuit and the electricalcharging circuit). PEUGEOT declines any respon- sibility for expenses incurredthrough the repair of your vehicleor for any malfunctions resultingfrom the installation of auxiliaryaccessories, not supplied and notrecommended by PEUGEOT andnot installed in accordance withPEUGEOT's instructions, in particular for any equipment thepower consumption of which
exceeds 10 milliamps. The maxi fuses provide additional protection for the electrical systems.Any work on these fuses must be
carried out by a PEUGEOT dealer.

PRACTICAL INFORMATION99
22-12-2003
Fuse N¡ Rating
Functions
1 10 A Pre-heat unit (diesel) - Brake and clutch switches - Reversing lights.
2 15 A Fuel pump.
3 10 A ABS control unit.
4 10 A Engine control unit.
5Ð Not used.
6 15 A Front fog lamps.
7 20 A Headlamp wash pump.
8 20 A Fan assembly relay - Engine control unit.
9 15 A Left-hand dipped beam.
10 15 A Right-hand dipped beam.
11 10 A Left-hand main beam.
12 10 A Right-hand main beam.
13 15 A Horns.
14 10 A Front and rear windscreen wash pumps.
15 30 A Oxygen sensor - Air flow sensor.
16 30 A Air pump relay.
17 30 A Front windscreen wiper.
18 40 A Air conditioning fan.

CHANGING A FUSE The fuse boxes are located under the fascia and in the engine compartment. Fascia fuse box Unclip the cover to gain access to the fuses. The spare fuses and the pliers Bare
secured on the inside of the cover A.
PRACTICAL INFORMATION
96
22-12-2003
Removing and fitting a fuse
Before changing a fuse, the cause of the fault must be found and remedied. The fuse numbers are indicated on the fuse box. Use the pliers
B.
Always replace a faulty fuse (identification according to fuse) with a fuse of the same rating.
Correct Pliers B
Incorrect

PRACTICAL INFORMATION97
22-12-2003
Fuse N¡ Rating
Functions
1 15 A Rear wiper (hinged doors) - Rear 12 V sockets.
4 20 A Multi-function display - Instrument panel - Audio equipment - Steering wheel controls.
5 15 A Alarm siren.
6 10 A Diagnostic socket.
7 15 A Alarm.
9 30 A Heated seats.
10 40 A Rear screen and mirror demisting.
11 15 A Rear windscreen wiper (tailgate).
12 30 A Front electric windows.
14 10 A Engine fuse box - Steering wheel controls - Rain sensor.
15 15 A Instrument panel - Multi-function display - Audio equipment.
16 30 A Locking/unlocking controls for doors, bonnet and boot.
20 10 A Right-hand brake light.
21 15 A Left-hand brake light.
22 20 A Front courtesy light - Map reading light - Lighter - Front 12 V socket -
Electric mirror.

PRACTICAL INFORMATION
100
22-12-2003
BATTERY
To charge the battery using a battery charger:
Ð Disconnect the battery,
Ð Follow the instructions for use given by the battery charger manufacturer,
Ð Reconnect starting with the negative (Ð) terminal,
Ð Check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
Ð Connect the red cable to the positive (+) terminals of the two batteries,
Ð Connect one end of the green or black cable to the negative (Ð) terminal of the slave battery,
Ð Connect the other end of the green or black cable to an earth point on the broken down vehicle as far as possible from the battery.
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð After every reconnection of the battery, switch on the ignition and wait 1 minute before starting to allow the electronic systems to be initialised. If slight difficulties are experienced after this, please
contact a PEUGEOT dealer. A flat battery will preventthe engine from starting.
It is advisable to disconnect the battery if the vehicle is not to be used
for a period of more than one month.
ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message "Eco mode active"
appears on the multifunction displayand the active functions are put on
standby.

PRACTICAL INFORMATION101
22-12-2003
FITTING AUDIO EQUIPMENT
Your vehicle is equipped with certain factory-fitted audio equipment:
Ð roof aerial,
Ð coaxial aerial cable,
Ð basic interference suppression,
Ð supply to front speakers,
Ð two 8-way connectors.Making the connections
A1 : Ð
A2 : Ð
A3 : Ð
A4 : Ð
A5 : Ð
A6 : (+ve) Accessories
A7 : (+ve) Permanent
A8 : (Ðve) Earth
B1 : (+) Ð
B2 : (Ð) Ð
B3 : (+) Front right speaker
B4 : (Ð) Front right speaker
B5 : (+) Front left speaker
B6 : (Ð) Front left speaker
B7 : (+) Ð
B8 : (Ð) Ð
FITTING SPEAKERS The factory-fitted equipment allows the fitting of 165 mm diameter
speakers in
the front doors.
Contact a PEUGEOT dealer before fitting audioequipment or speakers inyour vehicle.

SNOW SCREEN* The snow screen is installed on the lower part of the front bumper toprevent the accumulation of snow atthe radiator cooling fan. When the snow has cleared, do not forget to remove the snowscreen. FITTING Offer up the snow screen facing its centring pin Aon the front
bumper.
 Put it in place by pressing ateach clip Blocated in the four
corners.
REMOVAL  Pass a screwdriver into the hole located near each of the clips.
 Use the screwdriver as a lever tounclip the four clips Bin turn.
* According to destination.
PRACTICAL INFORMATION
102
22-12-2003
TOWING YOUR VEHICLE
Without lifting (four wheels on the ground)
You must always use a tow bar. From the front or the rear Attach the tow bar to the towing eye. By lifting (two wheels only on the ground) It is preferable to lift the vehicle by the wheels.
Never use the radiator crossmember.

PRACTICAL INFORMATION103
22-12-2003
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is basically designed for transporting people and luggage but it
may also be used for towing a trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres ofaltitude.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approachesthe maximum permitted withoutexceeding it. Cooling: Towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed, and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
Check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommendedpressures. Braking: Towing increases the braking
distance. Lights: Check the electrical signalling
on the trailer. Side wind: Take into acount the
increased sensitivity to side wind.

PRACTICAL INFORMATION
104
22-12-2003
ACCESSORIES FOR YOUR PARTNER
For your PEUGEOT only use accessories and original parts approved by the manufacturer.
These accessories and parts are all adapted to your PEUGEOT, after being tested and approved for reliability and safety,
which PEUGEOT cannot guarantee for other products.
A wide choice of original accessories, approved by PEUGEOT, is available through the dealer network. They all carry
the PEUGEOT guarantee.
Ð Safety :
Separation grille, window protectors, anti-theft alarm, wheel locks, parking assistance, signalling triangle, first aid kit, fog lamps, safety jacket...
Ð Comfort : Rear and side windows, audio-telephone console, covers compatible with side air bags,mats, luggage net, door deflectors...
Ð Loading : Roof bars, thermoformed interior protectors, wooden interior fittings, loading roller...
Ð Communication : Audio systems, audio-telephone, speakers, CD changer, navigation system...
Ð Customising : Alloy wheels, door sills, mud flaps, ...
Ð Leisure : Tow bar, roof box, snow chains, tailgate bicycle carrier...
Ð Children : Booster seats and child seats...
Ð Maintenance products : Screenwash, interior and exterior maintenance and cleaning products...
Before installing any electrical accessory on your vehicle, contact a PEUGEOT dealer.