Peugeot Partner VU Dag 2004 Owners Manual

1.Power steering reservoir
2. Windscreen and headlamp* wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil reservoir
* According to destination.
1.9 LITRE (70 bhp) DIESEL ENGINE
PRACTICAL INFORMATION
86
22-12-2003

PRACTICAL INFORMATION87
22-12-2003
1.
Power steering reservoir
2. Windscreen and headlamp* wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil reservoir
* According to destination.
2 LITRE (90 bhp) TURBO DIESEL HDI ENGINE

PRACTICAL INFORMATION
88
22-12-2003
CHECKING THE LEVELS Oil level Check the level regularly and top up
between changes. The maximum consumption is 0.5 l per 1 000 km. Check the level with the vehicle on level ground, engine cold, using the oillevel gauge on the instrument panel orthe dipstick. Dipstick
There are two marks on the dipstick: A=maximum
Never fill past this mark.B= minimum
To maintain the reliability of engines and emissioncontrol systems, the useof additives in engine oilis prohibited. Viscosity selection In all cases, the oil selected must meet the manufacturer's requirements.
Brake fluid level:
Ð The level must always be between the DANGER and MAXI-
MUM marks in the reservoir.
Ð If the level drops substantially, contact a PEUGEOT dealer
immediately.
Fluid change:
Ð Must be carried out according to the manufacturer's servicing schedule.
Ð Use fluids recommended by the manufacturer, which fulfil DOT4standards.
Note: Brake fluid is harmful to health
and very corrosive. Avoid all contactwith the skin. Cooling system Use the fluid recommended by the
manufacturer. When the engine is warm, the tem- perature of the coolant is controlled
by the engine fan. As this fan canoperate with the ignition keyremoved and because the coolingsystem is pressurised, wait for atleast one hour after the engine hasstopped before carrying out anywork. Slacken the cap to the first notch torelease the pressure to prevent anyrisk of scalding. When the pressurehas dropped, remove the cap andtop up the level. Note:
The coolant does not need to
be changed. Used oil Do not dispose of used oil, brake fluid or coolant into drains or into theground. Power steering reservoir  Open the reservoir, with the engine at ambient temperature.The level should always beabove the MIN. mark and closeto the MAX. mark.
Windscreen and headlamp* wash level For best quality cleaning and for
your safety, we advise that youuse products recommended by
PEUGEOT.
* According to destination.
Oil change According to the information given in
"PEUGEOT SERVICING" .
Note: avoid used oil coming into
prolonged contact with the skin.

Only use products recom-
mended by PEUGEOT.
To ensure best per-
formance from components as important as the power steer-ing and the braking system,PEUGEOT selects and offersspecific products.
To prevent damage to the electrical units, avoid washingthe engine.
PRACTICAL INFORMATION 89
22-12-2003
RUNNING OUT OF FUEL (DIESEL) If you should run out of fuel, it is necessary to re-prime the circuit:
Ð fill the fuel tank with at least five
litres of diesel,
Ð operate the manual re-priming pump, under the bonnet under the
protective cover, until fuelappears in the transparent pipe,
Ð operate the starter until the engine starts.
FUEL SUPPLY CUT-OFF (PETROL) In a serious collision, a mechanism prevents fuel from reaching theengine.
To re-establish the fuel supply, press the switch on the corner of the front
right-hand suspension assembly,under the bonnet.
CHECKS Battery
At the start of winter, have your bat-
tery checked by a PEUGEOT deal-
er. Air filter and passenger compartment filter Have the filter elements replaced
regularly.
If you drive in dusty con-
ditions, change them twice asoften. Brake pads Brake pad wear depends on the style of driving, in particular for vehicles which are used in town,over short distances. It may be necessary to check the thickness of the pads, even betweenservices. Handbrake Where the handbrake travel is too great or there is a reduction in theperformance of the system, thehandbrake should be adjusted, evenbetween services. Have the system checked by a
PEUGEOT dealer. Oil filter
Change the filter regularly, in accor- dance with the servicing schedule. Manual gearbox This does not require an oil change. Check the level in accordance with themanufacturer's servicing schedule.

PRACTICAL INFORMATION
90
22-12-2003
CHANGING A WHEEL Parking the vehicle
Ð If possible, park the vehicle on
level, stable and non-slippery ground.
Ð Apply the handbrake, switch off the ignition and engage first or
reverse gear.
Access to the spare wheel andthe jack The wheel is located outside the
vehicle, under the rear floor,
supported by a metal carrier.
Ð Remove the jack and the wheel- brace 1, secured behind the
driver's seat. Ð Using the wheelbrace
1, slacken the spare wheel carrier retaining bolt, located
on the inside near the closing system.
Ð Lift the carrier to release the hook rearwards, then lower it.
Ð Remove the chock 2located in the spare wheel.
Removing a wheel
Ð Chock the rear of the wheel diagonally opposite the wheel to be changed, using the chock 2.
Ð Remove the wheel trim using the wheelbrace 1, by pulling at the valve
passage hole.
Ð Slacken the wheel bolts.
Ð Place the jack under the locating point on the sub-frame Athat is closest to
the wheel to be changed. Ensure that the entire surface of the jack base plate is in contact with the ground.
Ð Extend the jack, completely unscrew the bolts and remove the wheel.

PRACTICAL INFORMATION91
22-12-2003
Refitting the wheel
Ð After positioning the wheel, lightly pre-tighten the bolts using the wheelbrace.
Ð Compress the jack and release it.
Ð Fully tighten the bolts using the wheelbrace.
Ð Replace the trim, starting at the valve passage hole, and press it on using the
palm of the hand.
Replacing the wheel in the carrier
Ð Replace the chock 2 in the wheel.
Ð Replace the wheel in the carrier.
Ð Lift the wheel then the carrier and reposition the hook.
Ð Do not forget to fully tighten the spare wheel carrier retaining bolt.
Ð Stow the wheelbrace 1 and the jack.
For your safety, always change a wheel:
Ð on level, stable and non slippery ground,
Ð with the handbrake applied,
Ð with first or reverse gear engaged,
Ð with the vehicle chocked,
Ð never go underneath a vehicle raised using a jack (use an axle stand).
After changing the wheel
Ð Have the tightening of the bolts and the pressure of the spare tyre checked as soon as possible
by a PEUGEOT dealer.
Ð Have the punctured tyre repaired and replace it on thevehicle as soon as possible.

PRACTICAL INFORMATION
92
22-12-2003
CHANGING A BULB Front lights
1 - Dipped beam headlamps/Main beam headlamps
(H4-60/55 W)
Ð Turn and remove the protector A.
Ð Disconnect the connector.
Ð Unclip the spring.
Ð Remove and replace bulb. 2 - Side lights (W 5 W)
Ð Turn and remove the protector
A.
Ð Pull the bulb holder rearwards.
Ð Change the bulb.
3 - Direction indicators (PY 21 W amber)
Ð Turn the bulb holder B a quarter turn and remove it.
Ð Change the bulb. Note: in certain weather conditions (low temperatures,
humidity), the presence of condensation on the inside
of the headlamp glass is normal ; it disappears a few
minutes after the lights have been switched on.

PRACTICAL INFORMATION93
22-12-2003
Direction indicatorside
repeaters (WY 5 W amber)
Ð Push the transparent cover for-
wards or rearwards and release it.
Ð Turn the bulb holder a quarter turn.
Ð Change the bulb.
Coloured bulbs (direction indicators and side repea-ters) must be replaced bybulbs of identical specifica-
tion and colour.
Only use H4 bulbs manu-factured by:
Ð GE/TUNGSRAM,
Ð PHILIPS,
Ð OSRAM,
to avoid damaging the headlamps. These meet the anti-UV (ultra-violet) specifications necessary for the correct operation and reliability ofthe headlamps. The headlamps are fitted with a
polycarbonate lens coated with a
protective varnish. You are stronglyadvised to avoid cleaning themusing a dry or abrasive cloth and using detergent products orsolvents. Use a soft, damp cloth.

Rear lights
1 - Fog lamp (P 21 W).
2 - Direction indicators (P 21 W).
3 - Reversing lights (P 21 W).
4 - Brake lights/Side lights (P 21/5 W).Ð Open the rear door.
Ð Unscrew the nut
A.
Ð Push the light unit gently towards the interior of the vehicle to unclip the two side retaining clips.
Ð Remove the light unit and disconnect it.
Ð Unclip the bulb holder by pressing the tabs B.
Ð Change the faulty bulb.
PRACTICAL INFORMATION
94
22-12-2003
Number plate lights (W 5 W) Unclip the translucent protector to gain access to the bulb.

PRACTICAL INFORMATION95
22-12-2003
Third brake light (tailgate) (W 5 W) 
With the tailgate open, unscrew the two nuts.
 Unclip the support to gain accessto the bulbs.
 Change the faulty bulb. Third brake light (rear left door) (W 5 W) 
Remove the housing cover by pressing the tab A(round
section) at the end of the light.
 Pull the housing cover rearwards. 
Squeeze the two tabs B to
remove the bulb holder.
 Pull the faulty bulb and change it.
To refit, proceed in the reverse order.