light Peugeot Partner VU Dag 2004 Owner's Guide

PRACTICAL INFORMATION95
22-12-2003
Third brake light (tailgate) (W 5 W) 
With the tailgate open, unscrew the two nuts.
 Unclip the support to gain accessto the bulbs.
 Change the faulty bulb. Third brake light (rear left door) (W 5 W) 
Remove the housing cover by pressing the tab A(round
section) at the end of the light.
 Pull the housing cover rearwards. 
Squeeze the two tabs B to
remove the bulb holder.
 Pull the faulty bulb and change it.
To refit, proceed in the reverse order.

PRACTICAL INFORMATION99
22-12-2003
Fuse N¡ Rating
Functions
1 10 A Pre-heat unit (diesel) - Brake and clutch switches - Reversing lights.
2 15 A Fuel pump.
3 10 A ABS control unit.
4 10 A Engine control unit.
5Ð Not used.
6 15 A Front fog lamps.
7 20 A Headlamp wash pump.
8 20 A Fan assembly relay - Engine control unit.
9 15 A Left-hand dipped beam.
10 15 A Right-hand dipped beam.
11 10 A Left-hand main beam.
12 10 A Right-hand main beam.
13 15 A Horns.
14 10 A Front and rear windscreen wash pumps.
15 30 A Oxygen sensor - Air flow sensor.
16 30 A Air pump relay.
17 30 A Front windscreen wiper.
18 40 A Air conditioning fan.

PRACTICAL INFORMATION97
22-12-2003
Fuse N¡ Rating
Functions
1 15 A Rear wiper (hinged doors) - Rear 12 V sockets.
4 20 A Multi-function display - Instrument panel - Audio equipment - Steering wheel controls.
5 15 A Alarm siren.
6 10 A Diagnostic socket.
7 15 A Alarm.
9 30 A Heated seats.
10 40 A Rear screen and mirror demisting.
11 15 A Rear windscreen wiper (tailgate).
12 30 A Front electric windows.
14 10 A Engine fuse box - Steering wheel controls - Rain sensor.
15 15 A Instrument panel - Multi-function display - Audio equipment.
16 30 A Locking/unlocking controls for doors, bonnet and boot.
20 10 A Right-hand brake light.
21 15 A Left-hand brake light.
22 20 A Front courtesy light - Map reading light - Lighter - Front 12 V socket -
Electric mirror.

PRACTICAL INFORMATION
100
22-12-2003
BATTERY
To charge the battery using a battery charger:
Ð Disconnect the battery,
Ð Follow the instructions for use given by the battery charger manufacturer,
Ð Reconnect starting with the negative (Ð) terminal,
Ð Check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
Ð Connect the red cable to the positive (+) terminals of the two batteries,
Ð Connect one end of the green or black cable to the negative (Ð) terminal of the slave battery,
Ð Connect the other end of the green or black cable to an earth point on the broken down vehicle as far as possible from the battery.
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð After every reconnection of the battery, switch on the ignition and wait 1 minute before starting to allow the electronic systems to be initialised. If slight difficulties are experienced after this, please
contact a PEUGEOT dealer. A flat battery will preventthe engine from starting.
It is advisable to disconnect the battery if the vehicle is not to be used
for a period of more than one month.
ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message "Eco mode active"
appears on the multifunction displayand the active functions are put on
standby.

PRACTICAL INFORMATION103
22-12-2003
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is basically designed for transporting people and luggage but it
may also be used for towing a trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres ofaltitude.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approachesthe maximum permitted withoutexceeding it. Cooling: Towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed, and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
Check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommendedpressures. Braking: Towing increases the braking
distance. Lights: Check the electrical signalling
on the trailer. Side wind: Take into acount the
increased sensitivity to side wind.