Peugeot RCZ 2011 Owner's Manual - RHD (UK, Australia)
Manufacturer: PEUGEOT, Model Year: 2011, Model line: RCZ, Model: Peugeot RCZ 2011Pages: 276, PDF Size: 16.64 MB
Page 181 of 276
8/
F10
F11
F13F14F12
F20
F19
F18
F17
F16
F15
F4
F8F2
F3F5 F7
F9
F6
F21 F1
PRACTICAL INFORMATION
ENGINE COMPARTMENT FUSES
The fusebox is placed in the engine compartment near the battery
(left-hand side).
Access to the fuses
)
Unclip the cover.
)
Change the fuse (see corresponding paragraph).
)
When you have fi nished, close the cover carefully to assure the
sealing of the fusebox.
Fuse table
Fuse N°
Rating
Functions
F1
20 A
Engine control unit supply, injection
pump and EGR electrovalves (Diesel),
injectors (Diesel).
F2
15 A
Horn.
F3
10 A
Front wash-wipe.
F4
20 A
Daytime running lamps.
F5
15 A
Air fl ow sensor, coolant pump, oil pump,
thermostat, blow-by heater (petrol),
by-pass and EGR electrovalves (Diesel),
diesel heater (Diesel).
F6
10 A
Steering wheel angle sensor, ABS/ESP
control unit, ESP control unit.
F7
10 A
Power steering control unit, automatic
gearbox, engine coolant level detector,
dual function brake switch.
F8
25 A
Starter motor control.
F9
10 A
Diagnostic socket, directional
headlamps, particle emission fi lter pump
(Diesel).
F10
30 A
Engine control unit actuators (petrol:
ignition coils, electrovalves, injectors,
fuel pump (Diesel: electrovalves,
heaters).
F11
40 A
Air conditioning blower.
Page 182 of 276
F10
F11
F13F14F12
F20
F19
F18
F17
F16
F15
F4
F8F2
F3F5 F7
F9
F6
F21 F1
180
Fuse N°
Rating
Functions
F12
40 A
Windscreen wipers slow/fast speed.
F13
40 A
Built-in systems interface supply (ignition
positive).
F14
-
Not used.
F15
10 A
Right-hand main beam headlamp.
F16
10 A
Left-hand main beam headlamp.
F17
15 A
Left-hand dipped headlamp.
F18
15 A
Right-hand dipped headlamp.
F19
15 A
Variable timing electrovalve, oxygen
sensors (petrol), electrovalves (Diesel).
F20
10 A
Turbine discharge and canister purge
electrovalves (petrol), air fl ow sensor
(1.6 l THP 200), water in diesel sensor
(Diesel).
F21
5 A
Fans control, Turbo pump (petrol),
Valvetronic motor (1.6 l THP 200).
Page 183 of 276
8/
F1 F3 F5F2 F4 F6F7
F11F9F8
F12
F10
PRACTICAL INFORMATION
Table of fuses over the battery
Fuse N°
Rating
Functions
F1
-
Not used.
F2
5 A
Dual function brake switch.
F3
5 A
Battery charge unit.
F4
25 A
ABS/ESP electrovalves.
F5
-
Not used.
F6
15 A
Automatic gearbox. All work on the other types of fuses (midi-fuses and maxi-fuses)
must only be done by a PEUGEOT dealer or a qualifi ed workshop.
Page 184 of 276
182
TOWING A VEHICLE
TOWING EYE
This is stored in the boot under the fl oor.
For access to it:
)
open the boot,
)
raise the fl oor using the strap,
)
secure it in the vertical position beyond the stops, located on the
sides of the boot,
)
remove the towing eye from the storage box.
GENERAL RECOMMENDATIONS
Observe the legislation in force in your country.
Ensure that the weight of the towing vehicle is higher than that of
the towed vehicle.
The driver must stay at the wheel of the towed vehicle.
Driving on motorways and fast roads is prohibited when towing.
When towing a vehicle with all four wheels on the ground, always
use an approved towing bar; rope and straps are prohibited.
When towing a vehicle with the engine off, there is no longer any
power assistance for braking or steering.
In the following cases, you must always call on a professional
recovery service:
- vehicle broken down on a motorway or fast road,
- when it is not possible to put the gearbox into neutral, unlock
the steering, or release the parking brake,
- towing with only two wheels on the ground,
- where there is no approved towing bar available...
Page 185 of 276
8/
PRACTICAL INFORMATION
TOWING YOUR VEHICLE
)
On the front bumper, unclip the cover by pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Place the gear lever in neutral (position N
on the automatic
gearbox).
Failure to observe this instruction could result in damage to certain
components (braking, transmission...) and the absence of braking
assistance the next time the engine is started.
)
Unlock the steering by turning the ignition key one notch and
release the parking brake.
)
Switch on the hazard warning lamps on both vehicles.
)
Move off gently and drive slowly and for a short distance only.
TOWING ANOTHER VEHICLE
)
On the rear bumper, unclip the cover by pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps on both vehicles.
)
Move off gently and drive slowly and for a short distance only.
Page 186 of 276
184
TOWING A TRAILER
Towbar suitable for the attachment of a trailer with additional lighting
and signalling.
Your vehicle is primarily designed for transporting people and luggage,
but it may also be used for towing a trailer.
We recommend use of the PEUGEOT genuine towbar with ball
which can be removed without tools and its harness that have
been tested and approved from the design stage of your vehicle,
and that the fi tting of the towbar is entrusted to a PEUGEOT
dealer or a qualifi ed workshop.
If the trailer is fi tted outside the PEUGEOT dealer network, it must
be fi tted in accordance with the manufacturer's instructions.
DRIVING ADVICE
Driving with a trailer subjects the towing vehicle to more signifi cant
stress and its driver must be particularly careful.
Distribution of loads
)
Distribute the load in the trailer so that the heaviest items are as
close as possible to the axle and the nose weight approaches the
maximum permitted without exceeding it.
Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum towing load must be reduced by
10 % and so on for every 1 000 metres of altitude.
Refer to the "Technical Data" section for details of the weights and
towing loads which apply to your vehicle version.
Side wind
)
Take into account the increased sensitivity to side wind.
Page 187 of 276
8/
PRACTICAL INFORMATION
Cooling
Towing a trailer on a slope increases the temperature of the coolant.
As the fan is electrically controlled, its cooling capacity is not dependent
on the engine speed.
)
To lower the engine speed, reduce your speed.
The maximum towing load on a long slope depends on the gradient and
the ambient temperature.
In all cases, pay attention to the coolant temperature.
Braking
Towing a trailer increases the braking distance.
Tyres
)
Check the tyre pressures of the towing vehicle and of the trailer,
observing the recommended pressures.
Lighting
)
Check the electrical signalling on the trailer.
)
If the warning lamp and the STOP
warning lamp come
on, stop the vehicle and switch off the engine as soon as
possible.
The rear parking sensors will be deactivated automatically if a
genuine PEUGEOT towbar is used.
When not towing a trailer, remove the quickly-detachable tow ball
before driving, so as to avoid masking the central rear lamp.
Page 188 of 276
186
CLEANING AND MAINTENANCE
The general recommendations on cleaning and maintaining your vehicle
are given in the Warranty and Maintenance Record.
ALUMINIUM ARCHES
To clean these arches, do not use a dry cloth with an abrasive product.
Use a sponge and soapy water.
PEUGEOT TECHNO TEP
To clean this trim, do not use solvents or detergents with a dry cloth.
First remove dust, then use a soft cloth and soapy water. Dry with
another soft cloth.
HEADLAMPS AND LAMPS
The headlamps have polycarbonate lenses, fi nished with a protective
lacquer.
Do not clean them with a dry or abrasive cloth, nor with detergent or
solvent products.
Use a sponge and soapy water.
CUSTOMISING STICKERS
These customising parts are self-adhesive stickers, treated to give good
resistance to ageing and tearing.
They are intended for customising the body.
Available also as accessories, we recommend that you have them fi tted
by a PEUGEOT dealer or a qualifi ed workshop.
MATT PAINT
If you vehicle is fi nished with a clear matt lacquer, please observe the
following recommendations to avoid damaging the paintwork by the use
of an inappropriate procedures.
These recommendations are also valid for alloy road wheels fi nished
with clear matt lacquer.
The use of a high pressure jet wash for cleaning the headlamps,
lamps and their surrounds may damage the lacquer and seals.
Observe the recommendations on pressure and distance for jet
washing.
First clean persistent stains with a sponge and warm soapy water. When washing your vehicle, keep the end of a high-pressure
lance at least 30 centimetres from the stickers.
Never polish the vehicle body, nor the alloy wheels. Doing this will
make the paintwork shiny.
Do not use paint cleaners, abrasive products or paint polishing or
preserving products (such as wax, for example) on the paintwork.
These products are only suitable for bright fi nishes. Application of
these products on vehicles with a matt fi nish will seriously damage
the paint surface of the vehicle, giving rise to shiny or stained
areas.
Never select a wash programme that fi nishes with a hot wax
cycle.
Always have paint repairs done by a PEUGEOT dealer or a
qualifi ed workshop.
From the range of cleaning and maintenance products recommended and approved
by PEUGEOT, use only products for removing insects and car shampoo.
Page 189 of 276
8/
PRACTICAL INFORMATION
ACCESSORIES
A wide range of accessories and genuine parts is available from the
PEUGEOT dealer network.
These accessories and parts have been tested and approved for
reliability and safety.
They are all adapted to your vehicle and benefi t from PEUGEOT's
recommendation and warranty.
"Comfort":
cool box, smoker's kit, reading lamp...
"Transport solutions":
boot tray, boot spacers, towbar bicycle carrier, towbar with quickly
detachable ball, towbar harnesses...
"Style":
Alcantara steering wheel, aluminium gear lever knob, alloy wheels, front
spoiler, carbon fi bre door mirror shells...
"Safety and security":
anti-theft alarm, window etching, wheel security bolts, breathalyser, fi rst
aid kit, fi re extinguisher, warning triangle, high visibility jacket, booster
cushions and child seats, stolen vehicle tracking system, snow chains,
anti-skid tyre covers, audible front parking sensors...
"Protection":
mats * , door sill protectors, rubbing strips, exterior protective cover...
*
To avoid any risk of jamming of the pedals:
- ensure that the mat is positioned and secured correctly,
- never fi t one mat on top of another.
When fi tting a trailer towbar and its harness outside the
PEUGEOT dealer network, this must be done following
the manufacturer's recommendations.
Page 190 of 276
188
Installation of radio communication transmitters
Before installing any after-market radio communication transmitter,
you can contact a PEUGEOT dealer for the specifi cation of
transmitters which can be fi tted (frequency, maximum power,
aerial position, specifi c installation requirements), in line with the
Vehicle Electromagnetic Compatibility Directive (2004/104/EC).
Depending on the legislation in force in the country, it may be
compulsory to have a high visibility safety vest, warning triangle
and spare bulbs and fuses available in the vehicle.
The fi tting of electrical equipment or accessories which are not
recommended by PEUGEOT may result in a failure of your
vehicle's electronic system and excessive electrical consumption.
Please note this precaution. You are advised to contact a
PEUGEOT representative to be shown the range of recommended
equipment and accessories.
"Multimedia":
audio systems, portable navigation system, Bluetooth hands-free
system, speakers, DVD player, speed camera alert, Wi-Fi on Board...
By going to a PEUGEOT dealer you can also obtain products for
cleaning and maintenance (exterior and interior) - including ecological
products from the "TECHNATURE" range, topping up products
(screenwash, ...), touch-up pens and aerosols for the exact colour of
your vehicle, refi lls (cartridge for temporary tyre repair kit...), ...