tyre pressure Peugeot RCZ 2011 Owner's Manual - RHD (UK, Australia)
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2011, Model line: RCZ, Model: Peugeot RCZ 2011Pages: 276, PDF Size: 16.64 MB
Page 23 of 276
LIMIT THE CAUSES OF
EXCESS CONSUMPTION
Spread loads throughout the vehicle; place
the heaviest items in the bottom of the boot,
as close as possible to the rear seats.
Limit the loads carried in the vehicle and
reduce wind resistance (roof bars, roof rack,
bicycle carrier, trailer...). Use a roof box in
preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and
refi t your summer tyres.
OBSERVE THE RECOMMENDATIONS
ON MAINTENANCE
Check the tyre pressures regularly, when cold,
referring to the label in the door aperture,
driver's side.
Carry out this check in particular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the tyres
on any trailer or caravan.
Have your vehicle serviced regularly (engine
oil, oil fi lter, air fi lter...) and observe the
schedule of operations recommended by
the manufacturer.
When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid any
overfl ow.
At the wheel of your new vehicle, it is only
after the fi rst 1 800 miles (3 000 kilometres)
that you will see the fuel consumption settle
down to a consistent average.
Page 30 of 276
28
Engine
autodiagnosis
system
fl ashing. The engine management system
has a fault. Risk of destruction of the catalytic converter.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
fi xed. The emission control system has
a fault. The warning lamp should go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or qualifi ed
workshop without delay.
Low fuel level
fi xed with the
needle in the
red zone,
accompanied by
an audible signal
and a message. When it fi rst comes on there
remains approximately 5 litres
of fuel in the tank.
At this point, you begin to use the
fuel reserve. Refuel as soon as possible to avoid running out of fuel.
Until suffi cient fuel has been added, this warning lamp
will come on every time the ignition is switched on,
accompanied by an audible signal and a message.
The audible signal and message are repeated with
increasing frequency as the fuel level drops towards "0"
.
Fuel tank capacity: approximately 55 litres
.
Never continue to drive until you run out of fuel, as this
could damage the emission control and injection systems.
Warning lamp
is on
Cause
Action/Observations
Service
temporarily,
accompanied by
a message. Minor faults have occurred for
which there is no specifi c warning
lamp. Identify the fault by reading the message displayed in the
screen:
- doors, boot or bonnet open,
- low engine oil level,
- low screenwash/headlamp wash reservoir level,
- remote control battery fl at,
- low tyre pressures,
- saturation of the particle emission fi lter on Diesel vehicles
(see Checks - checking levels/particle emissions fi lter).
For any other faults, contact a PEUGEOT dealer or a
qualifi ed workshop.
fi xed,
accompanied by
a message and
an audible signal. Major faults have occurred for
which there is no specifi c warning
lamp. Identify the fault by reading the message shown in the
screen and you must then contact
a PEUGEOT dealer or
a qualifi ed workshop.
Page 102 of 276
100
TYRE UNDER-INFLATION DETECTION
System which automatically and continuously checks the pressure of
the tyres while driving.
The tyre under-infl ation detection system is an aid to driving which
does not replace the need for the driver to be vigilant or to drive
responsibly. Sensors fi tted in each valve trigger a warning in the event of malfunction
(speed above 12 mph (20 km/h)).
Under-inflated tyre
This warning lamp is displayed in the instrument panel
accompanied by an audible signal and an alert message
identifying the wheel concerned.
)
Check the tyre pressures as soon as possible.
This check must be carried out when the tyres are cold.
HORN
Audible warning to alert other road users to an imminent danger.
)
Press one of the spokes of the steering wheel.
EMERGENCY OR ASSISTA NCE
CALL
This system allows you to make an emergency or assistance call to the
emergency services or to the dedicated PEUGEOT service.
For more information on the use of this function, refer to the "Audio and
telematics" section.
Page 103 of 276
5/
SAFETY
All repairs and changing of tyres on a wheel fi tted with this
system must be carried out by a PEUGEOT dealer or a qualifi ed
workshop.
If, when changing a tyre, you install a wheel which is not detected
by your vehicle (example: fi tting of snow tyres), you must have
the system reinitialised by a PEUGEOT dealer or a qualifi ed
workshop.
This system does not avoid the need to have the tyre pressures
checked regularly (refer to the "Identifi cation markings" section)
to ensure that the optimum dynamic performance of the vehicle is
maintained and prevent premature wear of the tyres, particularly in
arduous driving conditions (heavy load, high speed).
The tyre pressures must be checked cold, at least once a month.
Remember to also check the pressure of the spare wheel if your
vehicle has one.
The tyre under-infl ation detection system may experience
temporary interference due to electro-magnetic signals on a
frequency close to that used by the system.
Puncture
The STOP
warning lamp comes on and this warning lamp is
displayed in the instrument panel, accompanied by an audible
signal and an alert message identifying the wheel concerned.
)
Stop as soon as it is safe to do so, avoiding any sudden movement
of the steering wheel and the brakes.
)
Repair or change the damaged wheel (punctured or very defl ated
tyre), and have the tyre pressure checked as soon as possible.
Sensor(s) not detected or faulty
This warning lamp is displayed in the instrument panel
accompanied by an alert message to identify the wheel
or wheels which are not detected or to indicate a fault in
the system.
Contact a PEUGEOT dealer or a qualifi ed workshop to replace
the faulty sensor(s).
This message is also displayed when one of the wheels is away
from the vehicle (being repaired) or when one or more wheels
without a sensor are fi tted.
If your vehicle has a spare wheel, this does not have a sensor.
Page 104 of 276
102
BRAKING ASSISTA NCE SYSTEMS
Group of supplementary systems which help you to obtain optimum
braking in complete safety in emergency situations:
- anti-lock braking system (ABS),
- electronic brake force distribution (EBFD),
- emergency braking assistance (EBA).
ANTI-LOCK BRAKING SYSTEM AND
ELECTRONIC BRAKE FORCE DISTRIBUTION
Linked systems which improve the stability and manoeuvrability of your
vehicle when braking, in particular on poor or slippery surfaces.
Activation
The anti-lock braking system comes into operation automatically when
there is a risk of wheel lock.
Normal operation of the ABS may make itself felt by slight vibration of
the brake pedal.
When braking in an emergency, press very fi rmly without releasing
the pressure.
Operating fault
If this warning lamp comes on, accompanied by an audible
signal and a message in the screen, it indicates a malfunction
of the anti-lock braking system which could result in loss of
control of the vehicle when braking. If this warning lamp comes on, together with the STOP
and
ABS
warning lamps, accompanied by an audible signal and
a message in the screen, it indicates a malfunction of the
electronic brake force distribution which could result in loss of control of
the vehicle when braking.
You must stop as soon as it is safe to do so.
In either case, contact a PEUGEOT dealer or a qualifi ed workshop.
When replacing wheels (tyres and rims), ensure that they conform
to the manufacturer's recommendations.
When braking in an emergency, press fi rmly without releasing
the pressure.
EMERGENCY BRAKING ASSISTANCE
System which, in an emergency, enables you to obtain the optimum
braking pressure more quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in the resistance of the pedal and an
increase in braking effi ciency.
Page 156 of 276
0
154
DESCRIPTION OF THE KIT
A.
"Sealant" or "Air" position selector.
B.
On "I"
/off "O"
switch.
C.
Defl ation button.
D.
Pressure gauge (in bar or p.s.i.).
E.
Compartment housing:
- a cable with adaptor for 12 V socket,
- various infl ation adaptors for accessories, such as balls,
bicycle tyres...
F.
Sealant cartridge.
G.
White pipe with cap for repair.
H.
Black pipe for infl ation.
I.
Speed limit sticker.
The speed limit sticker I
must be affi xed to the vehicle's steering
wheel to remind you that a wheel is in temporary use.
Do not exceed a speed of 50 mph (80 km/h) when driving with a
tyre repaired using this type of kit.
Page 158 of 276
0 5 km
3,5 miles 20-60 km/h max
15-35 mph max
0
156
)
Switch on the compressor by moving the switch B
to position "I"
until the tyre pressure reaches 2.0 bars.
The sealant is injected into the tyre under pressure; do not
disconnect the pipe from the valve during this operation (risk of
splashing).
)
Remove the kit and screw the cap back on the white pipe.
Take care to avoid staining your vehicle with traces of fl uid. Keep
the kit to hand.
)
Drive immediately for approximately three miles (fi ve kilometres), at
reduced speed (between 15 and 35 mph [20 and 60 km/h]), to plug
the puncture.
)
Stop to check the repair and the tyre pressure using the kit.
If after around 5 to 7 minutes the pressure is not attained, this
indicates that the tyre is not repairable; contact a PEUGEOT
dealer or a qualifi ed workshop for assistance.
Tyre under-inflation detection
If the vehicle is fi tted with tyre under-infl ation detection, the under-
infl ation warning lamp will remain on after the wheel has been
repaired until the system is reinitialised by a PEUGEOT dealer or
a qualifi ed workshop.
Page 159 of 276
8/
00
0
0
0
PRACTICAL INFORMATION
2. Inflation
)
Turn the selector A
to the "air" position.
)
Uncoil the black pipe H
fully.
)
Connect the black pipe to the valve of the wheel.
)
Visit a PEUGEOT dealer or a qualifi ed workshop as soon as
possible.
You must inform the technician that you have used this kit.
After inspection, the technician will inform you whether the
tyre can be repaired or must be replaced.
)
Connect the compressor's electric plug to the vehicle's 12 V socket.
)
Start the vehicle again and leave the engine running.
)
Adjust the pressure using the compressor (to infl ate: switch B
in position "I"
; to defl ate: switch B
in position "O"
and press
button C
), in accordance with the vehicle's tyre pressure label
(located on the left hand door aperture).
A loss of pressure indicates that the puncture has not been fully
plugged; contact a PEUGEOT dealer or qualifi ed workshop for
assistance.
)
Remove and stow the kit.
)
Drive at reduced speed (50 mph [80 km/h] max) limiting the
distance travelled to approximately 120 miles (200 km).
Page 161 of 276
8/
0
0
0
PRACTICAL INFORMATION
CHECKING TYRE PRESSURES/INFLATING
ACCESSORIES
You can also use the compressor, without injecting any product, to:
- check or adjust the pressure of your tyres,
- infl ate other accessories (balls, bicycle tyres...).
)
Turn the selector A
to the "Air" position.
)
Uncoil the black pipe H
fully.
)
Connect the black pipe to the valve of the wheel or
accessory.
If necessary, fi t one of the adaptors supplied with the kit fi rst.
)
Connect the compressor's electrical connector to the vehicle's 12 V
socket.
)
Start the vehicle and let the engine run.
)
Adjust the pressure using the compressor (to infl ate: switch B
in position "I"
; to defl ate: switch B
in position "O"
and press
button C
), according to the vehicle's tyre pressure label or the
accessory's pressure label.
)
Remove the kit then stow it.
Page 187 of 276
8/
PRACTICAL INFORMATION
Cooling
Towing a trailer on a slope increases the temperature of the coolant.
As the fan is electrically controlled, its cooling capacity is not dependent
on the engine speed.
)
To lower the engine speed, reduce your speed.
The maximum towing load on a long slope depends on the gradient and
the ambient temperature.
In all cases, pay attention to the coolant temperature.
Braking
Towing a trailer increases the braking distance.
Tyres
)
Check the tyre pressures of the towing vehicle and of the trailer,
observing the recommended pressures.
Lighting
)
Check the electrical signalling on the trailer.
)
If the warning lamp and the STOP
warning lamp come
on, stop the vehicle and switch off the engine as soon as
possible.
The rear parking sensors will be deactivated automatically if a
genuine PEUGEOT towbar is used.
When not towing a trailer, remove the quickly-detachable tow ball
before driving, so as to avoid masking the central rear lamp.