ignition Peugeot RCZ 2011 User Guide
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2011, Model line: RCZ, Model: Peugeot RCZ 2011Pages: 276, PDF Size: 51.24 MB
Page 38 of 276
= 0
36
Service overdue
For 7 seconds after the ignition is switched on, the spanner fl ashes
to
indicate that the service must be carried out as soon as possible.
Example:
the service is overdue by 300 miles.
For 7 seconds after the ignition is switched on, the central screen indicates:
The spanner remains lit
on the small screen
to indicate that a service should have been
carried out.
The distance remaining may be weighted by the time factor,
depending on the driver's driving habits.
Therefore, the spanner may also come on if you have exceeded
the two year service interval.
Service indicator zero reset
Retrieving the service information
You can access the service information at any time.
This information appears when running through the manual check
procedure.
)
Briefl y press the "CHECK/000"
button.
The service information is displayed for a few seconds on
the instrument panel central screen, then disappears.
Following this operation, if you wish to disconnect the battery, lock
the vehicle and wait at least fi ve minutes for the zero reset to be
registered. After each service, the service indicator must be reset to zero.
The procedure for resetting to zero is as follows:
)
switch off the ignition,
)
press and hold the "CHECK/000"
button,
)
switch on the ignition; the distance recorder display begins a
countdown,
)
when the instrument panel central screen indicates "=0"
, release
the button; the spanner disappears from the small screen.
Interval
exceeded by
300 miles
-300miles
Page 39 of 276
1/
INSTRUMENTS AND CONTROLS
MANUAL CHECK
This function allows you to check the status of the vehicle (reminder
of the alert warnings and of the state of the confi gurable functions -
"activated" or "deactivated") and the service information.
)
With the engine running, to start a manual check, briefl y press the
"CHECK/000"
button on the instrument panel.
If no faults have been detected, "CHECK OK"
appears in the
instrument panel central screen.
If a "minor" fault has been detected, the warning lamp concerned then
"CHECK OK"
appear in the instrument panel central screen. Contact a
PEUGEOT or a qualifi ed workshop.
If a "major" fault has been detected, only the warning lamps concerned
appear in the instrument panel central screen. Have it checked by a
PEUGEOT dealer or a qualifi ed workshop.
DISTANCE RECORDERS
The total and trip distances are displayed for thirty seconds when
the ignition is switched off, when the driver's door is opened and when
the vehicle is locked or unlocked.
Measures the total distance travelled by the vehicle since its fi rst
registration.
Total distance recorder
)
With the ignition on, press and hold this button until zeros appear.
Trip distance recorder
Measures a distance travelled since it was reset to zero by the driver.
4.5
65
4
/min1000mph
CHECK/000
mph 55LIMIT Pause
CHECK/000
13 011 0907
05
0
3010
6
7 5
4
/min1000mph
5
.5
offmph55
CHECK
OK
Page 40 of 276
00.5
16
7
60
6
12
93
55
50
45
40
353025
20
15
1
0
5
38
LIGHTING DIMMER
Permits manual adjustment of the brightness of the instruments and
controls to suit the ambient light level. Only operates when the vehicle
lighting is on, with the exception of the daytime running lamps.
Activation
)
Press the button to change the brightness of the instruments and
controls.
)
When the lighting reaches the minimum setting, release the button,
then press again to increase it.
or
)
When the lighting reaches the maximum setting, release the button,
then press again to reduce it.
)
When the lighting reaches the level of brightness required, release
the button.
Deactivation
When the vehicle lighting is off, or in day mode on vehicles fi tted with
daytime running lamps, pressing the button does not have any effect.
CLOCK
The analogue clock, located between the central vents of the
dashboard, does not have an adjustment button.
To set the time, refer to the section relating to your multifunction
screen's confi guration menu.
The clock is synchronised with the multifunction screen time; once the
the setting has been confi rmed on the multifunction screen, the hands
will turn to synchronise with the screen, and each time the ignition is
switched on.
Page 43 of 276
1/
INSTRUMENTS AND CONTROLS
A FEW DEFINITIONS…
Range
(miles or km)
This indicates the distance which can still be travelled
with the fuel remaining in the tank in relation to the average fuel
consumption over the last few miles (kilometres) travelled.
This value may vary following a change in the style of driving
or the relief, resulting in a signifi cant change in the current fuel
consumption.
If dashes are displayed continuously while driving in place of the
digits, contact a PEUGEOT dealer or a qualifi ed workshop.
This function is only displayed from 20 mph (30 km/h). When the range falls below 20 miles (30 km), dashes are displayed.
After fi lling with at least 5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (100 km).
Current fuel consumption
(mpg or l/100 km or km/l)
This is the average fuel consumption during the last few
seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
This is the average fuel consumption since the last trip
computer zero reset.
Average speed
(mph or km/h)
This is the average speed calculated since the last trip
computer zero reset (ignition on).
Distance travelled
(miles or km)
This indicates the distance travelled since the last trip
computer zero reset.
Page 50 of 276
48
This screen is opened and stored automatically.
However, you can also open it, store it and adjust it using the various
manual controls:
- opening or storing by means of control A
,
- angle adjustments by means of control B
.
It is also fi tted with safety auto-reverse protection.
ACCESS TO THE RETRACTABLE SCREEN
Opening the screen
)
With the screen stored, press control A
to open it.
The screen opens automatically when the ignition is switched on, when
the audio and telematics system is switched on, when an outgoing
telephone call is made, when a voice command is given and when a
warning message linked with the STOP warning lamp is received.
Closing the screen
)
With the screen open, press control A
to store it.
The screen is stored automatically when the ignition is switched off, after
approximately three seconds, if the audio and telematics system is off.
If you close the screen during operation of the audio and
telematics system, it will re-open automatically when an outgoing
telephone call is made, when a voice command is given or when a
warning message linked with the STOP warning lamp is received. If you wish the screen to open or close automatically when the
audio and telematics system is switched on or off, the screen must
not be closed when the audio and telematics system is operating.
Safety auto-reverse
If the screen meets an obstacle as it opens or closes, the movement
stops immediately and is reversed by a few millimetres.
After clearing the obstacle, issue the command required again.
Page 54 of 276
52
Folding the key
)
First press this button to fold the key.
LOCATING YOUR VEHICLE
REMOTE CONTROL PROBLEM
Following disconnection of the vehicle battery, replacement of the
remote control battery or in the event of a remote control malfunction,
you can no longer unlock, lock or locate your vehicle.
)
First of all, use the key in the lock to unlock or lock your vehicle.
)
Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT dealer as soon as
possible.
Reinitialisation
)
Switch off the ignition.
)
Turn the key to position 2 (Ignition on)
.
)
Press the closed padlock immediately for a few seconds.
)
Switch off the ignition and remove the key from the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR1620/3 volts.
If the battery is fl at, you are informed by illumination of this
warning lamp, accompanied by an audible signal and an alert
message in the screen.
)
Unclip the casing using a coin at the notch.
)
Slide the fl at battery out of its location.
)
Slide the new battery into its location observing the original
direction.
)
Clip the casing.
)
Reinitialise the remote control.
This function allows you to identify your vehicle from a
distance, particularly in poor light. Your vehicle must be
locked.
)
Press the closed padlock on the remote control.
This will switch on the courtesy lamps and the direction indicators will
fl ash for a few seconds.
Page 55 of 276
2/
ACCESS
LOST KEYS
Visit a PEUGEOT dealer with the vehicle's V5 registration
document and your personal identifi cation documents.
The PEUGEOT dealer will be able to retrieve the key code and
the transponder code required to order a replacement key.
LOCKING THE VEHICLE
Driving with the doors locked may make access to the passenger
compartment by the emergency services more diffi cult in an emergency.
As a safety precaution (with children on board), remove the key from the
ignition when you leave the vehicle, even for a short time.
REMOTE CONTROL
The high frequency remote control is a sensitive system; do not
operate it while it is in your pocket as there is a possibility that it
may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of
range and out of sight of your vehicle. You run the risk of stopping it
from working and the remote control would have to be reinitialised.
The remote control does not operate when the key is in the
ignition, even when the ignition is switched off, except for
reinitialisation.
ANTI-THEFT PROTECTION
Do not make any modifi cations to the electronic engine
immobiliser system; this could cause malfunctions.
Do not throw the remote control batteries away, they contain
metals which are harmful to the environment.
Take them to an approved collection point.
WHEN PURCHASING A SECOND-HAND
VEHICLE
Have the key codes memorised by a PEUGEOT dealer, to ensure
that the keys in your possession are the only ones which can start
the vehicle.
Page 56 of 276
54
ALARM *
System which protects and provides a deterrent against theft and break-
ins. It provides the following types of monitoring.
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a door, the boot, the
bonnet...
- Interior volumetric
The system checks for any variation in the volume in the passenger
compartment.
The alarm is triggered if anyone breaks a window, enters the passenger
compartment or moves inside the vehicle.
- Tilt
The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted, moved or knocked.
For all work on the alarm system, contact a PEUGEOT dealer or a
qualifi ed workshop.
LOCKING THE VEHICLE WITH FULL ALARM
SYSTEM
Activation
)
Switch off the ignition and get out of the vehicle.
)
Press the locking button on the remote control.
The monitoring system is active: the indicator lamp in the button fl ashes
once per second.
After the locking button on the remote control is pressed, the exterior
perimeter monitoring is activated after a delay of 5 seconds and the
interior volumetric and anti-tilt monitoring after a delay of 45 seconds.
Deactivation
)
Press the unlocking button on the remote control.
The alarm system is deactivated: the indicator lamp in the button goes off.
Self-protection function
The system checks for the putting out of service of its
components.
The alarm is triggered if the battery, the central control or the siren
wiring are put out of service or damaged.
*
According to country. If an opening (door, boot...) is not closed fully, the vehicle is not
locked but the exterior perimeter monitoring will be activated after
a delay of 45 seconds at the same time as the interior volumetric
and anti-tilt monitoring.
Page 57 of 276
2/
ACCESS
LOCKING THE VEHICLE WITH EXTERIOR
PERIMETER MONITORING ONLY
Deactivation of the interior volumetric and anti-tilt monitoring
)
Switch off the ignition.
)
Within ten seconds, press the button until the indicator lamp is on
continuously.
)
Get out of the vehicle.
)
Press the locking button on the remote control immediately.
The exterior perimeter monitoring alone is activated: the indicator lamp
in the button fl ashes once per second.
Reactivation of the interior volumetric and anti-tilt monitoring
)
Press the unlocking button on the remote control to deactivate the
exterior perimeter monitoring.
)
Press the locking button on the remote control to activate all the
monitoring functions.
The indicator lamp in the button again fl ashes once per second.
Deactivate the interior volumetric and anti-tilt monitoring to avoid
unwanted triggering of the alarm in certain cases such as:
- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle,
- changing a wheel,
- having your vehicle towed,
- transport by sea. To be effective, this deactivation must be carried out each time the
ignition is switched off.
Page 58 of 276
56
OPERATING FAULT
AUTOMATIC ACTIVATION *
LOCKING THE VEHICLE WITHOUT ACTIVATING
THE ALARM
)
Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fi xed illumination of the indicator lamp
in the button indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
2 minutes after the last door or the boot is closed, the system is
activated automatically.
)
To avoid triggering the alarm on entering the vehicle, fi rst press the
unlocking button on the remote control.
* According to country.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
)
Unlock the vehicle using the key in the driver's door lock.
)
Open the door; the alarm is triggered.
)
Switch on the ignition; the alarm stops. The indicator lamp in the
button goes off.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
fl ashing of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched on, this fl ashing stops immediately.
This is indicated by sounding of the siren and fl ashing of the direction
indicators for thirty seconds.