lock Peugeot RCZ 2011 Owner's Guide
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2011, Model line: RCZ, Model: Peugeot RCZ 2011Pages: 276, PDF Size: 51.24 MB
Page 58 of 276
56
OPERATING FAULT
AUTOMATIC ACTIVATION *
LOCKING THE VEHICLE WITHOUT ACTIVATING
THE ALARM
)
Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fi xed illumination of the indicator lamp
in the button indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
2 minutes after the last door or the boot is closed, the system is
activated automatically.
)
To avoid triggering the alarm on entering the vehicle, fi rst press the
unlocking button on the remote control.
* According to country.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
)
Unlock the vehicle using the key in the driver's door lock.
)
Open the door; the alarm is triggered.
)
Switch on the ignition; the alarm stops. The indicator lamp in the
button goes off.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
fl ashing of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched on, this fl ashing stops immediately.
This is indicated by sounding of the siren and fl ashing of the direction
indicators for thirty seconds.
Page 59 of 276
2/
ACCESS
ELECTRIC WINDOWS
Fitted with a safety anti-pinch system.
A.
Left-hand electric window control switch.
B.
Right-hand electric window control switch.
ONE-TOUCH ELECTRIC WINDOWS
There are two options:
- manual mode
)
Press or pull the switch gently. The window stops when the
switch is released.
- automatic mode
)
Press or pull the switch fi rmly. The window opens or closes fully
when the switch is released.
)
Pressing the switch again stops the movement of the window.
The electric window switches remain operational for approximately
45 seconds after the ignition is switched off or until the vehicle is
locked after a door is opened.
If the passenger's window cannot be operated from the driver's
door control panel, carry out the operation from the control panel
of the passenger door.
After approximately ten consecutive complete opening/closing
movements of the window, a protection function is activated which
only authorises closing of the windows, so as to prevent damage
to the electric window motor.
Once the window is closed, the switches will become operational
again after approximately 40 minutes.
Safety anti-pinch
When the window rises and meets an obstacle, it stops and partially
lowers again.
If the window cannot be closed (for example, in the presence of ice),
immediately after the movement is reversed:
)
press and hold the switch until the window opens fully,
)
then pull the switch immediately and hold it until the window
closes,
)
continue to hold the switch for approximately one second after
the window has closed.
The safety anti-pinch function is not operational during these
operations.
Page 61 of 276
2/
ACCESS
DOORS
OPENING
From outside
)
After unlocking the vehicle completely using the remote control or
the key, take hold of the door handle then pull it.
The window lowers automatically by a few millimetres to permit
opening of the door.
In freezing conditions, the presence of ice may hinder the automatic
partial opening of the window; remove the ice which may have
formed along the lower seal, located at the base of the window.
When the selective unlocking is activated, the fi rst press of the
remote control unlocking button permits unlocking of the driver's
door only.
From inside
)
Pull the door control to open the door; this unlocks this vehicle
completely.
The window lowers automatically by a few millimetres to permit
opening of the door.
With the selective unlocking activated:
- the driver's door control unlocks the driver's door and the fuel
fi ller fl ap only.
- the passenger's door control unlocks the passenger's door
and the boot.
The interior door controls do not operate when the vehicle is
deadlocked. If you leave the door open for more than one minute, the window
rises again.
Pull the handle again to reactivate the system.
Page 62 of 276
60
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.
- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot lid and fuel fi ller fl ap from inside the vehicle.
Locking
)
Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
)
Press this button again to unlock the vehicle.
The red indicator lamp on the button goes off.
Locking/deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp fl ashes and the button is inactive.
)
With normal locking, pull on the interior door control lever to
unlock the vehicle.
)
With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
- fi rst lock the vehicle using the remote control or the key,
- avoid spraying the upper part of the windows,
- keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly: Be aware of the risk of pinching when the window rises
automatically on closing the door.
- when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
Page 63 of 276
2/
ACCESS
Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).
Activation/Deactivation
You can activate or deactivate this function.
)
With the ignition on, press the button for more than two seconds.
A confi rmation message appears in the screen.
In the event of a serious impact with triggering of an airbag, the
vehicle's doors unlock automatically to allow the occupants to exit.
EMERGENCY LOCKING
To lock or unlock the doors mechanically in the event of a central
locking system failure or fl at battery.
Locking the driver's door
)
Insert the key in the lock, then turn it to the right.
Unlocking the driver's door
)
Insert the key in the lock, then turn it to the left.
Locking the passenger door
)
Using the key, remove the black cap on the edge of the door.
)
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door.
)
Remove the key and refi t the cap.
Unlocking the passenger door
)
Pull the interior door opening control.
ANTI-ATTACK SECURITY
This function permits automatic and simultaneous locking of the doors,
boot lid and fuel fi ller fl ap as soon as the vehicle speed exceeds 6 mph
(10 km/h).
Operation
If one of the doors is open, the automatic central locking does not take
place.
If the boot lid is open, the automatic central locking of the doors is
active.
Page 64 of 276
62
BOOT
OPENING
)
Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
)
Lift the boot lid.
This action also unlocks the doors and the fuel fi ller fl ap.
Using the manual control; vehicle unlocked
)
Press the opening control above the number plate.
)
Lift the boot lid.
CLOSING
)
Lower the boot lid using one of the interior grab handles.
)
If necessary, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly:
- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When the selective unlocking is activated, the boot can be opened
at the second press of the unlocking button on the remote control.
Using the remote control
Emergency locking
If the central locking system fails (fl at battery), you are advised to
disconnect the battery.
- when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Page 69 of 276
3/
5
090
1
3001/2
1
CHE
CK/
0
0
0
EASE OF USE AND COMFORT
STEERING WHEEL ADJUSTMENT
)
When stationary
, pull the control lever to release the adjustment
mechanism.
)
Adjust the height and reach to suit your driving position.
)
Push the control lever to lock the adjustment mechanism.
As a safety precaution, these operations should only be carried
out while the vehicle is stationary.
Page 71 of 276
3/
EASE OF USE AND COMFORT
Folding
)
From outside: lock the vehicle using the remote control or the key.
)
From inside: with the ignition on, pull the control A
in the central
position rearwards.
If the mirrors are folded using control A
, they will not unfold when
the vehicle is unlocked. Pull again on control A
.
Unfolding
)
From outside: unlock the vehicle using the remote control or the key.
)
From inside: with the ignition on, pull the control A
in the central
position rearwards.
The folding and unfolding of the door mirrors using the remote
control can be deactivated by a PEUGEOT dealer or a qualifi ed
workshop.
Never fold or unfold the electric folding mirrors manually.
Automatic tilting in reverse gear
System which provides a view of the ground during parking manoeuvres
in reverse gear.
Programming
)
With the engine running, engage reverse gear.
)
Select and adjust the left-hand and right-hand mirrors in
succession.
The adjustment is stored immediately.
Switching on
)
With the engine running, engage reverse gear.
)
Move control A
to the right or to the left to select the corresponding
mirror.
The glass of the mirror selected tilts downwards, in accordance with its
programming.
Switching off
)
Exit reverse gear and wait ten seconds.
or
)
Return control A
to the central position.
The mirror glass returns to its initial position.
The mirror glass also returns to its initial position:
- if the speed exceeds 6 mph (10 km/h),
- if the engine is switched off.
Page 73 of 276
3/
EASE OF USE AND COMFORT
ACCESS TO THE REAR SEATS
REAR SEATS
Two-seat bench with one-piece fi xed seat cushion and one-piece folding
backrest.
The rear headrests are fi xed.
FOLDING DOWN THE REAR BACKREST
RETURNING THE REAR BACKREST TO THE UPRIGHT POSITION
When returning the backrest to the upright position, ensure that it is
locked securely to assure your safety.
)
Open the boot.
)
Pull the backrest release handle, located under the shelf.
When transporting long objects, do not place a load of more
than 30 kg on the rear of the backrest.
Do not place rough objects on the rear of the backrest which
could damage it.
)
Check that the front seat has been moved forward suffi ciently.
)
Pull the control upwards to tilt the backrest.
When the seat is put back in place, the backrest returns to its initial position.
The backrest can be folded down to increase the boot storage space.
The backrest release control is located in the boot.
)
Check that the front seats have been moved forward suffi ciently.
)
Check that nothing has been left on the rear seats.
)
Store the seat belt buckles on their respective securing points
located between the headrests.
)
Fold the backrest down onto the seat cushion.
Page 79 of 276
3/
EASE OF USE AND COMFORT
COURTESY LAMP
A.
Courtesy lamp
B.
Map reading lamps
COURTESY LAMP
In this position, the courtesy lamp comes on gradually:
- when the vehicle is unlocked,
- when the key is removed from the ignition,
- when a door is opened,
- when the remote control locking button is activated, in order to
locate your vehicle. It switches off gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- 30 seconds after the last door is closed.
Permanently off.
Permanent lighting.
With the "permanent lighting" mode, the duration of lighting varies,
depending on the circumstances:
- with the ignition off, approximately ten minutes,
- in energy economy mode, approximately thirty seconds,
- with the engine running, unlimited.
MAP READING LAMPS
)
With the ignition on, press the corresponding switch.