Oil grade Peugeot RCZ 2011 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2011, Model line: RCZ, Model: Peugeot RCZ 2011Pages: 276, PDF Size: 51.24 MB
Page 36 of 276

34
Oil level correct
This is indicated by the fl ashing of "OIL"
or an alert message in the
instrument panel, accompanied by illumination of the service warning
lamp and an audible signal.
If the lack of oil is confi rmed by a check using the dipstick, it is essential
that the level is topped up to prevent damage to the engine.
This is indicated by the fl ashing of "OIL--"
or the appearance of an alert
message in the instrument panel. Contact a PEUGEOT dealer or a
qualifi ed workshop.
Lack of oil
Oil level indicator fault
Dipstick
Refer to the "Checks" section to locate the dipstick and the oil fi ller cap
on your engine.
There are 2 marks on the dipstick:
-
A
= max; never exceed this level (risk of damage to
the engine),
-
B
= min; top up the level via the oil fi ller cap, using
the grade of oil suited to your engine.
Oil level
correct
Oil level
incorrect
Oil level measurement
invalid
Page 151 of 276

7/
CHECKS
CHECKING LEVELS
Check all of these levels regularly and top them up if necessary, unless
otherwise indicated.
If a level drops signifi cantly, have the corresponding system checked by
a PEUGEOT dealer or a qualifi ed workshop.
OIL LEVEL
The check is carried out either when the ignition is switched
on using the oil level indicator on the instrument panel, or
using the dipstick.
This manual check will only be correct if the vehicle is on level ground
and the engine has been off for more than 30 minutes.
After topping up the oil, the check when switching on the ignition
with the oil level indicator in the instrument panel will only be valid
30 minutes after topping up.
It is normal to top up the oil level between services. PEUGEOT
recommends that you check the oil level and top up if necessary
every 3 000 miles (5 000 kilometres).
Engine oil change
Refer to the Warranty and Maintenance Record for details of the interval
for this operation.
In order to maintain the reliability of the engine and emission control
system, the use of additives in the engine oil is prohibited.
BRAKE FLUID LEVEL
The brake fl uid level should be close to the "MAX" mark. If it is
not, check the brake pad wear.
Changing the fluid
Refer to the Warranty and Maintenance Record for details of the interval
for this operation.
Fluid specification
The brake fl uid must conform to the manufacturer's recommendations
and meet the DOT4 standard.
POWER STEERING FLUID LEVEL
The power steering fl uid level should be close to the "MAX"
mark. Unscrew the cap, with the engine cold, to check the level.
When working under the bonnet, take care, as certain areas of the
engine may be extremely hot (risk of burns).
Oil specification
The oil must be the correct grade for your engine and conform to the
manufacturer's recommendations.