sensor Peugeot RCZ 2015 User Guide

66
RCZ_en_Chap03_confort_ed01-2015
ExTERIOR WELCOME
LIGHTING
The remote switching on of the lighting makes your approach to the
vehicle easier in poor light. It is activated according to the level of \
light
detected by the sunshine sensor.
SWITCHING ON
F Press the open padlock on the remote control.
The dipped beam headlamps and the sidelamps come on; your
vehicle is also unlocked.
The duration of the welcome lighting is associated with and
identical to that of the automatic guide-me-home lighting.
SWITCHING OFF
The exterior welcome lighting switches off automatically after a set time,
when the ignition is switched on or on locking the vehicle.

77
RCZ_en_Chap04_visibilite_ed01-2015
C. Foglamp selection ring.
The foglamp operates with the dipped and main beam headlamps.
Rear foglamp.
F

T
urn the ring C forwards and release to switch on the rear foglamp.
When the lighting is switched off automatically (with AUTO model)
or when the dipped beam headlamps are switched off manually, the
foglamp and the sidelamps will remain on.
F

T
urn the ring C rearwards and release to switch off all the lamps. In good or rainy weather, both day and night, use of the rear
foglamp is prohibited. In these situations, the power of its beam
may dazzle other drivers. It should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch
on the foglamp and dipped beam headlamps manually as the
sunshine
sensor may detect sufficient light.
Do not forget to switch off the rear foglamp when it is no longer
needed.
Switching off the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately,
except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate ring A to the "0" position -
lamps off, then to the desired position.
On opening the driver's door a temporary audible signal warns the
driver that the lighting is on.
The lamps, with the exception of the sidelamps, switch off
automatically after a maximum duration of thirty minutes to
prevent discharging of the battery.
4/
VISIBILITY

79
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC ILLUMINATION OF HEA d LAMPS
When a low level of ambient light is detected by a sunshine sensor, the
number plate lamps,
sidelamps and dipped beam headlamps are switched
on automatically, without any action on the part of the driver. They can also
come on if rain is detected, at the same time as automatic operation of \
the
windscreen wipers.
As
soon as the brightness returns to a sufficient level or after the windscreen
wipers are switched of

f, the lamps are switched off automatically.
Activation
F Turn the ring to the "AUTO" position. The activation of the function is accompanied by the display of a message in the screen.
deactivation
F Turn the ring to another position. Deactivation of the function is accompanied by the display of a message in the screen.
MANUAL GUI d E - ME - HOME LIGHTING
The temporary illumination of the dipped beam headlamps after the
vehicle's ignition has been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F A

further "headlamp flash" switches the function off.
Switching off
The manual guide-me-home lighting switches off automatically after a
set time.
4/
VISIBILITY

80
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC GUId E - ME - HOME
LIGHTING
Operating fault
In the event of a malfunction of the sunshine sensor, the
lighting comes on, this warning lamp is displayed in the
instrument panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact

a

PEUGEOT

dealer or a qualified workshop.
In

fog

or snow, the sunshine sensor may detect sufficient light. In
this case, the lighting will not come on automatically

.
Do not cover the sunshine sensor, coupled with the rain sensor
and located in the centre of the windscreen behind the rear view
mirror; the associated functions would no longer be controlled. When the automatic illumination of headlamps function is activated
(lighting control stalk in the "
AUTO" position), under low ambient light
the dipped beams headlamps come on automatically when the ignition
is switched off.
Programming
Activation or deactivation, as well as the duration of the guide-me-home\

lighting, is set in the vehicle configuration menu.

85
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC RAIN SENSITIVE WIN d SCREEN
WIPERS
The windscreen wipers operate automatically, without any action on the
part of the driver, if rain is detected (sensor behind the rear view mirror),
adapting their speed to the intensity of the rainfall.
Activation
This is controlled manually by the driver by pushing the stalk
downwards to the "AUTO" position.
It is accompanied by a message in the screen.
Switching off
This is controlled manually by the driver by moving the stalk upwards
then returning it to position "0".
It is accompanied by a message in the screen.
Operating fault
If an automatic wiping malfunction occurs, the wipers will operate in
intermittent mode.
Have
it checked by a PEUGEOT

dealer or a qualified workshop.
The automatic rain sensitive wipers must be reactivated if the
ignition has been off for more than one minute, by pushing the
stalk downwards.
Do not cover the rain sensor, linked with the sunshine sensor
and located in the centre of the windscreen behind the rear view
mirror.
Switch off the automatic rain sensitive wipers when using an
automatic car wash.
In winter, to avoid damaging the wiper blades, it is advisable
to wait until the windscreen is completely clear of ice before
activating the automatic rain sensitive wipers.
4/
VISIBILITY

127
RCZ_en_Chap06_conduite_ed01-2015
TYRE UNDER-INFLATION DETECTION
A pressure sensor is located in the valve of each of these tyres.
The system triggers an alert if a drop in pressure is detected in one or\

more tyres.This system does not avoid the need to check the tyre pressures
regularly and before a long journey.
Driving
with under-inflated tyres adversely affects road holding,
extends braking distances and causes premature tyre wear

,
particularly under arduous conditions (vehicle loaded, high speed,
long journey).
System which automatically checks the pressures of the tyres while
driving.
The system continuously monitors the pressures of the four tyres, as
soon as the vehicle is moving.
Driving with under-inflated tyres increases fuel consumption.
The tyre pressures for your vehicle can be found on the tyre
pressure label (see the "Identification markings" section).
The tyre pressures must be checked when the tyres cold (vehicle
stopped for 1 hour or after driving for less then 6 miles (10 km) at
moderate speed). Otherwise, add 0.3 bar to the values indicated
on the label.
Spare wheel
Don't forget to also check the tyre pressure of the spare wheel.
The alloy spare wheel also has a sensor.
The steel spare wheel does not have a sensor.
The

tyre

under-inflation

detection

system

is

an

aid

to

driving

which

does not replace the need for vigilance on the part of the driver

.
6/
DRIVING

128
RCZ_en_Chap06_conduite_ed01-2015
In the event of a problem on one of the tyres, a symbol or a message is \
displayed, depending on equipment, to identify it.
F

Reduce speed, avoid sudden steering movements or harsh brake
applications.
F


Stop as soon as it is safe to do so.
F


In the event of a puncture, use the temporary puncture repair kit or
the

spare wheel (according to equipment),


or
F

if you have a compressor
, the one in the temporary puncture repair
kit for example, check the four tyre pressures when cold,


or
F

if it is not possible to check the tyre pressures at the time, drive
carefully at reduced speed.
UNdER-INFLATION ALERT
The alert is given by the fixed illumination of this warning lamp, accompanied by an audible signal and the display of a
message.
The loss of pressure detected does not always lead to visible
deformation of the tyre. Do not rely on just a visual check. With the ignition on, the pressure must be increased by at least
0.2

bar. If necessary, adjust the pressures to the values given on
the tyre pressure label. The
flashing and then fixed illumination of this warning
lamp accompanied by the illumination of the service
warning lamp indicates a fault with the system.
In this case, monitoring of the tyre pressures is not assured.
This

alert is also displayed when one or more wheels is not fitted
with a sensor (steel spare wheel).
Go

to a PEUGEOT

dealer or a qualified workshop to have the system
checked or

, following the repair of a puncture, to have the original
wheel,
equipped with a sensor, refitted.
OPERATING FAULT
The alert is maintained until the tyre or tyres concerned is reinflated, repaired or replaced.

135
RCZ_en_Chap06_conduite_ed01-2015
This function cannot, in any circumstances, take the place of the
vigilance of the driver.Certain types of obstacle (stake, roadworks cone, etc.) detected
initially will no longer be detected at the end of the manoeuvre, if
they
are located in blind spots in the sensors' field of detection.
PARKING SENSORSREAR PARKING SENSORS
Audible assistance
The proximity information is given by an intermittent audible signal, th\
e
frequency
of which increases as the vehicle approaches the obstacle.
The sound emitted by the speaker (right or left) indicates the side on\

which the obstacle is located.
When the distance between the vehicle and the obstacle becomes
less than approximately thirty centimetres, the audible signal becomes
continuous.
This system indicates the proximity of an obstacle (person, vehicle, tree,
gate,

etc.)

which

comes

within

the

field

of

detection

of

sensors

located

in the bumper

.
The system is switched on by engaging reverse gear. This is
accompanied by an audible signal.
The system is switched off when you come out of reverse gear.
6/
DRIVING

136
RCZ_en_Chap06_conduite_ed01-2015
deactivation / Activation of the front and rear parking sensors
V
isual assistance
FRONT PARKING
SENSORS
In addition to the rear parking sensors, the front parking sensors are
triggered when an obstacle is detected in front and the speed of the
vehicle is still below 6 mph (10 km/h).
The front parking sensors are interrupted if the vehicle stops for more \
than three seconds in forward gear, if no further obstacles are detected
or when the speed of the vehicle exceeds 6 mph (10 km/h).
This supplements the audible signal by displaying bars in the
multifunction screen which move progressively nearer to the vehicle.
When the obstacle is near, the "Danger" symbol is displayed in
the

screen. The function is deactivated by pressing this button. The indicator lamp
in the button comes on.
Pressing this button again reactivates the function. The indicator lamp in
the button goes off. The sound emitted by the speaker (front or rear) indicates whether the\

obstacle is in front or behind.

137
RCZ_en_Chap06_conduite_ed01-2015
deactivation / Activation of the rear parking sensors
The function is deactivated or activated via the vehicle configuration menu.
The status of the function is stored when the ignition is switched off.
OPERATING FAULT
In the event of a malfunction of the system, when reverse gear
is engaged this warning lamp is displayed in the instrument
panel and/or a message appears in the screen, accompanied
by an audible signal (short beep).
Contact
a PEUGEOT

dealer or a qualified workshop.
In bad weather or in winter, ensure that the sensors are not
covered with mud, ice or snow. When reverse gear is engaged, an
audible signal (long beep) indicates that the sensors may be dirty.
Certain sound sources (motorcycle, lorry, pneumatic drill, etc.)
may trigger the audible signals of the parking sensor system.
The function will be deactivated automatically if a trailer is being
towed

or

a

bicycle

carrier

is

fitted

(vehicle

fitted

with

a

towbar

or

bicycle carrier recommended by PEUGEOT).
6/
DRIVING