Service Peugeot RCZ 2015 Owner's Guide

149
RCZ_en_Chap07_verifications_ed01-2015
MANUAL GEARBOX
A

UTOMATIC
GEARBOX
B

RAKE PA d SB RAKE d ISC WEAR
The gearbox does not require any maintenance
(no oil change).
Refer to the manufacturer's service schedule for the
checking interval for this component.
The
gearbox does not require any maintenance

(no oil change).
Refer to the manufacturer's service schedule for details of
the level checking interval for this component.
Brake wear depends on the style of driving, particularly in
the case of vehicles used in town, over short distances.
It may be necessary to have the condition of the brakes
checked, even between vehicle services.
Unless


there is a leak in the circuit, a drop in the brake fluid level
indicates that the brake pads are worn. For information on checking brake disc wear

, contact a
PEUGEOT dealer or a qualified workshop.
Only use products recommended by PEUGEOT or products of
equivalent
quality and specification.
In order to optimise the operation of units as important as those
in
the braking system, PEUGEOT

selects and offers very specific
products.
After washing the vehicle, dampness, or in wintry conditions, ice
can

form on the brake discs and pads: braking efficiency may
be reduced. Make light brake applications to dry and defrost the
brakes.
PARKING BRAKE
If excessive travel or a loss of effectiveness of this system
is noticed, the parking brake must be checked, even
between two services.
Checking this system must be done by a PEUGEOT

dealer
or
a qualified workshop.
7/
CHECKS

184
RCZ_en_Chap08_info-pratiques_ed01-2015
TOWING A VEHICLE
TOWING EYE
This is stored in the boot under the floor.
For access to it:
F

open the boot,
F

raise the floor using the strap,
F

secure it in the vertical position beyond the stops, located on the
sides of the boot,
F


remove the towing eye from the storage box.
GENERAL RECOMMEN d ATIONS
Observe the legislation in force in your country.
Ensure that the weight of the towing vehicle is higher than that of
the towed vehicle.
The driver must remain at the wheel of the towed vehicle and
must have a valid driving licence.
When towing a vehicle with all four wheels on the ground, always
use an approved towing arm; rope and straps are prohibited.
The towing vehicle must move off gently.
When towing a vehicle with the engine off, there is no longer any
power assistance for braking or steering.
In the following cases, you must always call on a professional
recovery service:
-

vehicle broken down on a motorway or fast road,
-


four-wheel drive vehicle,
-


when it is not possible to put the gearbox into neutral, unlock
the steering, or release the parking brake,
-


towing with only two wheels on the ground,
-


where there is no approved towing arm available...

202
RCZ_en_Chap10a_BTA_ed01-2015
EMERGENCY OR ASSIST ANCE CALL
In an emergency, press this button for more than
2 seconds. Flashing of the green LED and a voice
message
confirm that the call has been made to the
"PEUGEOT

Connect SOS" centre*.
The

green

LED

remains on (without flashing) when communication is
established. It goes of

f at the end of communication. When the ignition is switched on, the green
LED comes on for 3 seconds indicating that
the system is operating correctly.
Pressing
this button again immediately cancels the request.
The
cancellation is confirmed by a voice message.
Press
this button for more than 2 seconds to request assistance if the vehicle breaks down.
A


voice message confirms that the call has been made**.
Pressing

this

button again immediately cancels the request.
The
green
LED


goes

off.

Cancellation is confirmed by a voice message.
To cancel a call, tell the "PEUGEOT Connect SOS" call centre that the call
was a mistake.
"PEUGEOT Connect SOS" immediately locates your vehicle, starts
communication with you in your language**, and where necessary sends
the appropriate public emergency services**. In countries where the
service is not available, or when the locating service has been expressl\
y
declined, the call sent directly to the emergency services (112) without the
vehicle location.
If an impact is detected by the airbag control unit, and
independently of the deployment of any airbags, an emergency call
is made automatically.
*

Subject to the general conditions for the service available from dealers\

and to technological and technical limitations. If

the orange LED flashes: there is a system
fault.
If the orange LED is on continuously: the
backup battery must be replaced.
In either case, contact a PEUGEOT

dealer.
If you purchased your vehicle outside the PEUGEOT dealer network,
we
invite you to have a dealer check the configuration of these services
and,

if desired, modified to suit your wishes. In a multi-lingual country,
configuration

is possible in the official national language of your choice.
For
technical reasons and in particular to improve the quality of
"PEUGEOT

CONNECT services" services to customers, the manufacturer
reserves the right to carry out updates to the vehicle's on-board telema\
tic
system.
PEUGEOT Connect SOS PEUGEOT Connect Assistance
Operation of the system
** Depending on the geographical cover of "PEUGEOT Connect SOS",
"PEUGEOT Connect Assistance" and the official national language
selected by the owner of the vehicle.



The list of countries covered and PEUGEOT
CONNECT services
services is available from dealers or at www.peugeot.co.uk.

03
208
RCZ_en_Chap10b_RT6-2-8_ed01-2015
A press on the knob gives access
to short-cut menus according to the
display in the screen.
display according to context
RA
d
IO:
Change waveband
MUSIC ME
d IA PLAYERS,
C
d or USB (according to
media):
Play modes:
Normal
Random
Random on all media
Repetition
TELEPHONE (call in
progress):
Private mode FULL SCREEN MAP OR
IN
A
NEW WIN d OW:
Stop / Restore guidance
Select destination
Enter an address
d

irectory
GPS coordinates
divert route
Move the map
Info. on location
Select as destination
Select as stage
Save this place (contacts)
Quit map mode
Guidance criteria
Put call on hold
d

TMF ring tones
Hang up
1
1
1
1
1
1
1
2
2
2
2
2
1
2
2
2
1
1
1
1
1
1FM
Traffic
anouncements (TA)
d
AB
Information AM
Entertainment
Special or Urgent2
2
2
2
2
2
2
Service announcements1
GENERAL OPERATION

04
213
RCZ_en_Chap10b_RT6-2-8_ed01-2015
Towards points of interest (POI)The points of interest (POI) indicate all of the service locations in \
the vicinity
(hotels, various businesses, airports...).
Select the "Enter an address" function
and
confirm, then select Select
destination


and confirm.
To select a POI close to your current
location, select " POI"
and confirm, then
select "

Around the current place" and
confirm.
To select a POI as a stage on the route,
select "POI"
and confirm, then select "On
the route"
and confirm.
To
select a POI as a destination, first
enter the country and town (refer to the
"T

owards a new destination" section),
select "POI"
and confirm, finally select
"

Near"
and confirm. Search for POIs in the categories
suggested in the following pages.
Select "Search by Name
" to search for POIs by name and not by
proximity.
Select
the POI and confirm "OK" to start
the guidance.
Press N AV
to display the
"Navigation - guidance " menu.
NAVIGATION - GUIdANCE

04
214
RCZ_en_Chap10b_RT6-2-8_ed01-2015
NAVIGATION - GUIdANCE
This icon appears when several POIs are grouped
together in the same area. Zooming in on this icon
shows details of the POIs.
Service station
Garage
PEUGEOT
Covered car park
Car park
Rest area
Hotel
Restaurant
Cafeteria
Bed and breakfast Railway station
Bus station
Port
Industrial estate
Supermarket
Vending machine
Sports complex, sports centre,
sports ground
Swimming pool
Winter sports resort Airport
Theme parks
Hospital, Chemist,
Ve t
Police station
Town hall
Post
office
Museum, Culture, Theatre,
Historic monument
Tourist information, Tourist
attraction
Risk areas / Danger
areas*
List of principal points of interest (POI)
* According to availability in the country.
School
An annual mapping update allows new points of interest to be presented t\
o you.
You can also update the Risk areas / Danger areas every month.
The detailed procedure is available on:
http://peugeot.navigation.com. Cinema

05
224
RCZ_en_Chap10b_RT6-2-8_ed01-2015
Principal TMC symbols
Red and yellow triangle: traffic information, for example:
Black and blue triangle: general information, for example:
W
eather reports
Modified signage
Risk of explosion Traffic
reports
Narrow carriageway
Road closed
Wind
Slippery surface
Demonstration Fog
Accident
Danger
Parking
Delay
No entry Snow / ice
Roadworks
Traffic
jam
Receiving TA messages
The TA (Traffic Announcement) function gives priority to T A alert messages.
To operate, this function needs good reception of a
radio
station transmitting this type of message. When a traffic report
is transmitted, the current audio source (Radio, CD, USB, ...) is
interrupted automatically to play the

TA message. Normal playback
of the audio source resumes at the end of the transmission of
the
message. Press RA
d IO to display the menu.
Select "Service announcements" then
confirm.
Activate or deactivate "TA "
then confirm.
The volume setting for TA messages can be adjusted only during the
transmission of this type of alert. Activate or deactivate the function at any time by pressing
the button.
During a message, press the button to interrupt it.
TRAFFIC INFORMATION

06
226
RCZ_en_Chap10b_RT6-2-8_ed01-2015
USING THE TELEPHONE
Pairing a Bluetooth® telephone
First connectionFor reasons of safety and because they require prolonged attention on the part of the driver , the operations for pairing the Bluetooth
mobile telephone to the hands-free system of the audio unit must be
carried out with the vehicle stationary.
In the Bluetooth menu of your telephone, select the
name "PEUGEOT" from the list of devices detected. Press this button.
Select "Bluetooth functions" and
confirm.
Select "Peripherals search " and
confirm.
The list of peripheral devices detected
is displayed. Wait until the "Connect"
button is available.
You can check the compatibility of your telephone at
www.peugeot.co.uk (services).
Activate the telephone's Bluetooth function
and ensure that it is "visible to all" (telephone
configuration).
Quick procedure from the telephone
Enter

a

minimum

4

figure

code

in

the

telephone

and

confirm. Enter the same code in the system,
select "

OK"

and

confirm. Procedure from the system

06
227
RCZ_en_Chap10b_RT6-2-8_ed01-2015
USING THE TELEPHONE
Select "Connect" and confirm.
The system of fers to connect the
telephone:
-

in "
Hands-free mode" (telephone
only),
-

in "
Audio" mode (streaming: playing
music
files on the telephone),
-

or "
All" (for selection of both
modes).
Select "OK"
and confirm. Then accept automatic connection on the telephone to allow the
telephone to reconnect automatically every time the vehicle is
started.
The ability of the system to connect in only one mode depends on
the telephone. The two modes may both connect by default. The "Hands-free mode" should be used in preference if
"Streaming" is not desired.
The services available depend on the network, the SIM card and the compa\
tibility of the Bluetooth telephone used. Check the telephone
manual and with your network provider for details of the services availa\
ble to you.
Depending on the type of telephone, the system will ask you to
accept or not the transfer of your contacts.
On return to the vehicle, the last telephone connected
automatically reconnects, within around 30 seconds after
switching on the ignition (Bluetooth activated and visible).
To modify the automatic connection mode, remove the pairing
and pair the telephone again with the desired mode.
Enter
a minimum 4 figure code in the telephone
and

confirm.
Enter the same code in the system,
select "OK" and confirm.
Select the name of the desired
peripheral from the list of devices
detected
then confirm.

06
233
RCZ_en_Chap10b_RT6-2-8_ed01-2015
Options during a call*
During a call, press the MO d E button
several times to select display of the
telephone screen, then press " OK" to
open the contextual menu.
Select "Private mode"
and confirm to
take the call on the handset.
Or select "

Hands-free mode" and
confirm
to take the call via the vehicle's
speakers.
Select "

Put call on hold "
and confirm to
put the current call on hold.
Or select "

Resume the call" and
confirm
to resume the call on hold. Select "
d TMF ring tones
" to use the
numerical keypad, so as to navigate
through the menu of an interactive vocal
server.
Select "Hang up" to end the call.
* Depending on the compatibility of the phone and your service plan. It is possible to hold a 3-way conference
call by making 2 calls in succession*.
Select "Conference mode call" in
the contextual menu accessible using
this
button.
Or make a short press on this button.
USING THE TELEPHONE