engine Peugeot RCZ 2015 Owner's Guide

97
RCZ_en_Chap05_securite_ed01-2015
REAR SEAT BELTS
The rear seats are each fitted with a three-point inertia reel seat belt with force limiter
.
Fastening
1. Pull the strap and insert the tongue F in the black buckle F, in the
centre of the bench seat.
2.

Insert the tongue
G in the outer red buckle G.
3.

Check that each buckle is fastened correctly by pulling the strap.
Unfastening
1. Press the red button on the buckle G , then the black button on the
buckle F.
2.

Guide the strap as it reels in and bring the tongue G

, then the
tongue F to the corresponding securing point on the backrest.
Seat belt unfastened warning lamps display
A. Rear seat belts unfastened warning lamp.
d

.
Rear right seat belt warning lamp.
E.


Rear left seat belt warning lamp.
The warning lamp A

comes on, either on in the seat belt and
passenger's front airbag warning lamps display, when one or more rear
passengers unfasten their seat belt.
From
approximately 12 mph (20 km/h), this warning lamp flashes for
two minutes accompanied by an audible signal of increasing volume.
Once these two minutes have elapsed, this warning lamp remains on
until the one or more rear passengers fasten their seat belt.
When the ignition is switched on, with the engine running or the vehicle\

moving at a speed below approximately 12 mph (20 km/h),
the

corresponding warning lamps
d
and E come on in red for
approximately 30 seconds, if the seat belt is not fastened.
When the vehicle is moving at a speed of more than approximately
12
mph (20 km/h), the corresponding warning lamp
d
or E comes on in
red, accompanied by an audible signal and a message in the screen,
if
a rear passenger has unfastened their seat belt. Unfastening is detected on both buckles of the seat belt. The
corresponding warning lamp comes on when at least one of the
two buckles is unfastened.
5/
SAFETY

11 5
RCZ_en_Chap06_conduite_ed01-2015
A FEW DRIVING
RECOMMENDA
TIONS
Never leave a vehicle unsupervised with the engine running. If
you have to leave your vehicle with the engine running, apply the
parking brake and put the gearbox into neutral or position N or P,
depending on the type of gearbox.
Observe the driving regulations at all times and remain vigilant whatever
the

traffic

conditions.
Pay

close

attention

to

the

traffic

and

keep

your

hands

on

the

wheel

so

that you are ready to react at any time to any eventuality

.
On a long journey, a break every two hours is strongly recommended.
In

difficult

weather,

drive

smoothly,

anticipate

the

need

to

brake

and

increase the distance from other vehicles.
dRIVING ON FLOOdEd ROA
d S
If you are obliged to drive through water: We strongly advise against driving on flooded roads, as this could
cause serious damage to the engine or gearbox, as well as to the
electrical systems of your vehicle.IMPORTANT!
Never drive with the parking brake applied - Risk of overheating
and damage to the braking system!
Do not park or run the engine when stationary in areas where
inflammable
substances and materials (dry grass, dead leaves...)
might

come into contact with the hot exhaust system - Risk of fire!
-

check that the depth of water does not exceed 10 cm, taking
account of waves that might be generated by other users,
-


drive as slowly as possible without stalling. In all cases, do not
exceed 6 mph (10 km/h),
-


do not stop and do not switch of
f the engine.
On

leaving the flooded road, as soon as circumstances allow, make
several light brake applications to dry the brake discs and pads.
If in doubt on the state of your vehicle, contact a PEUGEOT

dealer or a
qualified workshop.
6/
DRIVING

11 6
RCZ_en_Chap06_conduite_ed01-2015
IGNITION SWITCH
Ignition on position
It allows the use of the vehicle's electric equipment or portable devices to be charged.
Once the state of charge of the battery drops to the reserve level, the \
system switches to energy economy mode: the power supply is cut off
automatically to preserve the remaining battery charge.
In wintry conditions, the warning lamp can stay on for a longer
period. When the engine is hot, the warning lamp does not
come
on.
STARTING-SWITCHING OFF THE ENGINE
It has 3 positions:
-
position 1 (Stop): insert and removing the key,
-
position 2 (Ignition on) : steering column unlocked, ignition on,
Diesel preheating, engine running,
-
position 3 (Starting).
STARTING THE ENGINE
With the parking brake applied and the gearbox in neutral or
position
N or P:
F

depress the clutch pedal fully (manual gearbox),


or
F press
the brake pedal firmly (automatic gearbox),
F

insert the key into the ignition switch; the system recognises
the

code,
F

unlock the steering column by simultaneously turning the steering
and the key

.
F

With a petrol engine, operate the starter motor by turning the key to
position 3

without pressing the accelerator pedal, until the engine
starts. Once the engine is running, release the key.
F

With a Diesel engine, turn the key to position 2

, ignition on, to
operate the engine pre-heating system.
In certain cases, you may have to apply more force to the steering
(wheels on full lock, for example).
Avoid attaching heavy objects to the key, which would weigh down
on its blade in the ignition switch and could cause a malfunction. Switching off the engine leads to a loss of braking assistance. Wait until this warning lamp goes off in the instrument panel
then operate the starter motor by turning the key to position
3
without pressing the accelerator pedal, until the engine starts.
Once the engine is running, release the key.

11 7
RCZ_en_Chap06_conduite_ed01-2015
In temperate conditions, do not leave the engine at idle to warm
up but move off straight away and drive at moderate speed.To facilitate unlocking of the steering column, it is recommended
that the wheels be returned to the straight ahead position before
switching off the engine.
For more information, refer to the "Practical information" section,
under "Energy economy mode". When you leave the vehicle, keep the key with you and lock
the
vehicle.
If the engine does not start straight away, switch off the ignition.
Wait a few moments before operating the starter motor again.
If the engine does not start after several attempts, do not keep
trying: you risk damaging the starter motor or the engine. Contact
a
PEUGEOT

dealer or a qualified workshop.
Never switch off the ignition before the vehicle is at a complete
stop. With the engine off, the braking and steering assistance
systems are also cut off: risk of loss of control of the vehicle.
Never leave the engine running in an enclosed area without
adequate
ventilation: internal combustion engines emit toxic
exhaust gases, such as carbon monoxide. Danger of intoxication
and death!
In very severe wintry conditions (temperatures below -23°C), to
ensure the correct operation and durability of the mechanical
components of your vehicle, engine and gearbox, it is necessary
to leave the engine running for 4 minutes before moving of

f.
SWITCHING OFF THE ENGINE
F Stop the vehicle.
F
With the engine running at idle, turn the key to position 1

.
F

Remove the key from the ignition switch.
F


T
o lock the steering column, turn the steering until it locks.
F

Check that the parking brake is correctly applied, particularly on
sloping ground.
Energy economy mode
After switching off the engine (position 1-Stop), for a maximum of
30 minutes you can still use functions such as the audio and telematic
system, the wipers, dipped beam headlamps, courtesy lamps,
...
6/
DRIVING

11 8
RCZ_en_Chap06_conduite_ed01-2015
ELECTRONIC ENGINE IMMOBILISER
The key contains an electronic chip which has a special code. When
the ignition is switched on, this code must be recognised in order for
starting to be possible.
A few minutes after the ignition is switched off, this electronic engine
immobiliser locks the engine management system and prevents starting
of the engine by anyone who does not have the key.In the event of a malfunction, you are informed by lighting of this
warning lamp, an audible signal and a message in the screen.
In this case, your vehicle does not start; contact a PEUGEOT
dealer as soon as possible.
Key left in the "Ignition on" position
On opening the driver's door, an alert message is displayed,
accompanied by an audible signal, to remind you that the key is
still in the ignition switch at position 1 (Stop).
If the key has been left in the ignition switch at position 2 (Ignition
on), the ignition will be switched off automatically after one hour.
To switch the ignition back on, turn the key to position 1 (Stop),
then back to position 2 (Ignition on).

120
RCZ_en_Chap06_conduite_ed01-2015
HILL START ASSIST
System which keeps your vehicle immobilised temporarily
(approximately 2 seconds) when starting on a gradient, the time it tak\
es
to move your foot from the brake pedal to the accelerator pedal.
OPERATION
This function is only active when:
-

the vehicle is completely stationary
, with your foot on the brake
pedal,
-

certain conditions of slope are met,
-


with the driver
’s door closed.
The hill start assist system cannot be deactivated.
Do not exit the vehicle while it is being held in the hill start assist \
phase.
OPERATING FAULT
On an ascending slope, with the vehicle stationary, the vehicle is
held for a brief moment when you release the brake pedal:
- provided
you are in first gear or neutral on a manual gearbox,
-

provided you are in position d
or M on an automatic gearbox. On a descending slope, with the vehicle stationary and reverse
gear engaged, the vehicle is held for a brief moment when you
release the brake pedal.
If you need to exit the vehicle with the engine running,
apply the parking brake and then check that the
corresponding warning lamp in the instrument panel is on.
If a malfunction of the system occurs, these warning lamps come on.
Have it checked by a PEUGEOT

dealer or a qualified workshop.

121
RCZ_en_Chap06_conduite_ed01-2015
6-SPEED MANUAL GEARBO x
ENGAGING 5TH OR 6TH GEAR
F Move the lever fully to the right to engage 5th or 6th gear.
ENGAGING REVERSE GEAR
F Raise the ring under the knob and move the gear lever to the left
then forwards.
As a safety precaution and to facilitate starting of the engine:
-

always select neutral,
-


press the clutch pedal.
Failure to observe this procedure may cause permanent damage
to the gearbox (engaging 3
rd or 4th gear by mistake).
Only engage reverse gear when the vehicle is stationary with the engine
at idle.
6/
DRIVING

122
RCZ_en_Chap06_conduite_ed01-2015
"PORSCHE TIPTRONIC SYSTEM"
AUT
OMATIC GEARBO x
GEAR SELECTION GA TE
1. Gear selector.
2. Button "S" (sport).
3.

Button "
T" (snow).
GEAR SELECTOR POSITIONS
P. Park.
-
Immobilisation of the vehicle, parking brake on or of
f.
-

Starting the engine.
R.

Reverse.
-

Reversing manoeuvres, vehicle stationary
, engine at idle.
N. Neutral.
-

Immobilisation of the vehicle, parking brake on.
-


Starting the engine.
d

. Automatic operation.
M. + / -
Manual

operation with sequential changing of the six gears.
F

Press forwards to change up through the gears.
or
F


Press rearwards to change down through the gears.
Six speed automatic gearbox which of

fers a choice between the comfort
of fully automatic operation, enhanced by sport and snow programmes,
or manual gear changing.
There are two driving modes:
-

automatic

operation for electronic management of the gears by
the gearbox, with the sport programme for a more dynamic driving
style or the snow programme to facilitate driving when grip is poor.
-

manual


operation

for

sequential

changing

of

the

gears

by

the

driver

.

3
3
123
RCZ_en_Chap06_conduite_ed01-2015
dISPLAYS IN THE INSTRUMENT PANEL
When you move the gear selector in the gate to select a position, the
corresponding symbol is displayed in the instrument panel.
P. Park
R. Reverse
N. Neutral
d

1... d 6. Drive (Automatic driving)
S. Sport programme
T. Snow programme
M1... M6.


Manual (Sequential driving)
-. Invalid value during manual operation
MOVING OFF
F Apply the parking brake.
F
Select position P

or N.
F

Start the engine.
If this procedure

is not followed, there is an audible signal, accompanied
by a message in the screen.
F

With the engine running, press the brake pedal

.
F

Release the parking brake.
F


Select position R

, d or M,
F

Gradually release the brake pedal.
The vehicle then moves of

f.
If position N is engaged inadvertently while driving, allow the
engine to return to idle then engage position
d

to accelerate.
When the engine is running at idle, with the brakes released, if
position R,
d or M is selected, the vehicle moves even without the
accelerator being pressed.
When the engine is running, never leave children in the vehicle
without supervision.
When carrying out maintenance with the engine running, apply the
parking brake and select position P.
A message is displayed if you try to move the gear selector from
position
P without pressing the brake pedal.
6/
DRIVING

3
3
124
RCZ_en_Chap06_conduite_ed01-2015
AUTOMATIC OPERATION
F Select position d for automatic changing of the six gears.
Never select position N while the vehicle is moving.
Never select positions P or R unless the vehicle is completely
stationary.
The gearbox then operates in auto-adaptive mode, without any
intervention on the part of the driver. It continuously selects the most
suitable
gear according to the style of driving, the profile of the road and
the load in the vehicle.
d

and the gears selected automatically appear in succession in the
instrument panel.
For maximum acceleration without touching the selector, press the
accelerator pedal down fully (kick down). The gearbox changes down
automatically or maintains the gear selected until the maximum engine
speed is reached.
On braking, the gearbox changes down automatically to provide
efficient
engine braking.
If you release the accelerator sharply, the gearbox will not change to a
higher gear for safety reasons.
SPORT AN d SNOW PROGRAMMES
These two special programmes supplement the automatic operation in
very
specific conditions of use.
Sport programme "S"
F Press button "S", after starting the engine.
The gearbox automatically favours a dynamic style of driving.
S appears in the instrument panel.
Snow programme "T"
F Press button " T", after starting the engine.
The gearbox adapts to driving on slippery roads.
This programme improves starting and drive when traction is poor.
T appears in the instrument panel.
RETURN TO AUT OMATIC OPERA TION
F At any time, press the button selected again to quit the programme engaged and return to auto-adaptive mode.
MANUAL OPERATION
F Select position M for sequential changing of the six gears.
F
Push the selector towards the +

sign to change up a gear.
F

Pull the selector towards the -

sign to change down a gear.