lock PONTIAC FIREBIRD 1995 Owner's Manual

parking at Night
Park in a lighted spot, close all windows and lock your
vehicle. Remember
to keep you valuables out of sight.
Put them in a Storage area, or take them with you.
Parking Lots
If you park id a lot where someone will be watching
your vehicle, it's best to lock it up and
take your keys.
But what if you have to leave your ignition key? What if
you have to leave something valuable
in your vehicle?
ht your valdables in a storage area, like your glove
6 Lock the glove box.
0 Lock id1 the doors except the driver's.
Then
&e the door key with you.
bbx
PASS-Key@II
r
Your vehicle is equipped with the PASS-Key@%
(Personalized Automotive Security System) theft
deterrent system. PASS-Key% is a passive theft
deterrent system.
This means you don't have to do
anything different to arm or disarm the system. It works
when you insert or remove the key from the ignition.
PASS-Key% uses
a resistor pellet in the ignition key
that matches a decoder in your vehicle.
ProCarManuals.com

When the PASS-Key(% system senses that someone is
using the wrong key, it shuts down the vehicle’s starter and
fuel systems. For about
three minutes, the starter won’t
work and fuel won’t
go to the engine. If someone tries to
start your vehicle again or uses another key during this
time, the vehicle will not start. This discourages someone
from randomly
trying different keys with different resistor
pellets in
an attempt to make a match.
The ignition key must be clean and dry before it’s
inserted in the ignition or the engine may not start. If the
engine does not start and the
SECURITY light stays on
when you
try to start the car, the key may be dirty or
wet.
Turn the ignition off.
Clean and dry the key. Wait about three minutes and try
again. The security light may remain on during this
time. If the starter still won’t work, and the key appears
to be clean
and dry, wait about three minutes and try
another ignition key. At this time, you may also want to
check the fuses (see “Fuses and Circuit Breakers” in the
Index).
If the starter won’t work with the other key, your
vehicle needs service.
If your vehicle does start, the first
ignition key may be faulty. See your Pontiac dealer or a
locksmith who can service the PASS-Key%.
If you accidentally use a key that has a damaged or
missing resistor pellet, the starter won’t work and the
security light will flash. But you don’t have to wait three
minutes before trying another ignition key.
See your Pontiac dealer or a locksmith who can service
the PASS-Key% to have a new key made.
If you’re ever driving and the
SECURITY light comes
on and stays on, you will be able to restart
your engine if
you
turn it off. Your PASS-Key% system, however, is
not working properly and must be serviced by your
Pontiac dealer. Your vehicle is not protected by the
PASS-Key% system.
If you lose or damage a PASS-Key@II ignition key, see
your Pontiac dealer or a locksmith who can service
PASS-Key’II to have a new key made. In
an
emergency, call the Pontiac Roadside Assistance
Program at 1-800-ROADSIm or
1-800-762-3743.
2-13
ProCarManuals.com

New Vehicle “Break-In” Ignition Switch
NOTICE:
Your modern Pontiac doesn’t need an elaborate
%break-in.” But it
will perform better in the long
run
if you follow these guidelines:
0
0
0
0
Keep your speed at 55 mph (88 km@) or
less for the first
500 miles (804 km).
Don’t drive at any one speed
-- fast or slow
-- for the first 500 miles (804 km). Don’t
make full-throttle starts.
Ayoid making hard stops for the first
2a0: miles (322 kni) or so. During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this “breaking-in” guideline every
time you get new brake linings.
Don’t tow a trailer during “break-in.” See
“Towing a Trailer” in the Index for more
information.
With the ignition key in the ignition switch, you can turn
the switch to five positions:
ACC (A): Position in which you can operate your
electrical power accessories. Press in the ignition switch as you
turn the top of it toward you.
LOCK (B): The only position in which you can remove
the key. This locks your steering wheel, ignition and
automatic transmission.
2-14
ProCarManuals.com

If you have an automatic transmission, the ignition
switch can’t be turned to
LOCK unless the shift lever is
in the PARK (P) position.
OFF (C): Unlocks the steering wheel, ignition and
automatic transmission, but does not send electrical
power to
any accessories. Use this position if your
vehicle must be pushed or towed.
A warning tone will
sound if you open the driver’s door when the ignition is
OFF and the key is in the ignition.
RUN (D): Position to which the switch returns after you
start your engine and release the switch. The switch
stays in the
RUN position when the engine is running.
But even when the engine is not running, you can use
RUN to operate your electrical power accessories and to
display some instrument panel warning and indicator
lights.
START (E): Starts the engine. When the engine starts,
release the key. The ignition switch will return to
RUN
for normal driving.
Note that even if the engine is not running, ACC and
RUN allow you to operate your electrical accessories,
such as the radio and ventilation fan.
Key Release Button: If you have a manual
transmission, your ignition lock has
a key release button.
You must press the button before you can take: your key
out
of the ignition lock.
2-15
ProCarManuals.com

Retained Accessory Power (RAP)
NOTICE: ~
If your
key seems stuck in LOCK and you can’t
turn it, be sure it is all the way in. If it is, then
turn the steering wheel left and right while you
turn the key hard. But turn the key only with
your hand. Using
a tool to force it could break
the key or the ignition switch.
If none of this
works, then your vehicle needs service.
If you have power door locks, your vehicle has a feature
called Retained Accessory Power (RAP). With
RAP
your power door locks, electric mirrors, power
windows, audio system and remote hatch release will
continue to work up to
10 minutes after the ignition key
is turned to
OW and neither door is opened.
If a door is opened, the audio system and power
windows will shut
off. The power door locks, electric
mirrors and remote hatch release work until you shut the
door. Once you have shut
the door, these accessories
will continue to work for approximately
35 seconds.
After this time you will not be able to use these
accessories until the next time you open
a door or turn
the ignition.
ProCarManuals.com

Automatic Transmission
There are several different positions for your shift lever.
PARK (P): This locks your rear wheels. It’s the best
position to use when you start your engine because your
vehicle can’t move easily.
2-23
ProCarManuals.com

Ensure the shift lever is fully in PARK (P) range
before starting the engine. Your Pontiac has a
brake-transmission shift interlock. You have to fully
apply your regular brakes before you can shift from
PARK (P) when the ignition key is in the RUN position.
If you cannot shift out of PARK (P), ease pressure on
the shift lever
-- push the shift lever all the way into
PARK
(P) and also release the shift lever button on floor
shift console models
as you maintain brake application.
Then move the shift lever into the gear you wish. (Press
the shift lever button before moving the shift lever on
floor shift console models.) See “Shifting Out of
PARK (P) in
this part.
REVERSE (R): Use this gear to back up.
NOTICE:
Shifting to REVERSE (R) while your vehicle is
moving forward could damage your transmission. Shift to REVERSE
(R) only after
your vehicle is stopped.
To rock your vehicle back and forth to get out of snow,
ice or sand without damaging your transmission, see
“Stuck:
In Sand, Mud, Ice or Snow, If You’re” in the
Index.
NEUTRAL (N): In this position, your engine doesn’t
connect with the wheels.
To restart when you’re
already moving, use NEUTRAL
(N) only. Also, use
NEUTRAL,
(N) when your vehicle is being towed.
ProCarManuals.com

You can shift into FIRST (1) when you’re going less
than
20 mph (32 kmk). If you’ve come to a
complete stop and it’s hard to shift into FIRST
(1)
put the shift lever in NEUTRAL and let up on the
clutch. Press the clutch pedal back down. Then shift
into FIRST
(1).
0 SECOND (2): Press the clutch pedal as you let up
on the accelerator pedal and shift into SECOND (2).
Then, slowly let up on the clutch pedal as you press
the accelerator pedal.
THIRD, FOURTH, FIFTH, and SIXTH (3,4,5,
and 6 Gears): Shift into THIRD (3), FOURTH (4),
FIFTH (5) and SIXTH (6) the same way you do for
SECOND (2). Slowly let up on the clutch pedal as
you press the accelerator pedal.
0 To Stop: Let up on the accelerator pedal and press
the brake pedal. Just before the vehicle stops, press
the clutch pedal and the brake pedal, and shift
to“Neutra1.”
0
0
NEUTRAL (N): Use this position when you start or
idle your engine.
REVERSE (R): To back up, press down the clutch
pedal and shift into REVERSE (R). Let up on the
clutch pedal slowly while pressing the accelerator
pedal. If you
shift from SIXTH (6) into REVERSE
(R) the shift lever must be first placed in the
NEUTRAL position centered between SECOND
(2)
and THIRD (3) prior to shfting into REVERSE (R).
Your six-speed manual transmission has a feature that
allows you to safely shift into REVERSE (R) while the
vehicle is rolling (at less than
5 mph). You will be
locked-out if you try to shift into REVERSE (FQ while
your vehicle is moving faster than
5 mph.
If you have turned your ignition off and wish to park
your vehicle
in Reverse, you will have to move the shift
lever quickly to the right, “crashing” through the high
load spring and then into gear.
I
/ I
I I 2-29
f
1
ProCarManuals.com

2. Move the shift lever into PARK (P) position like
this:
Hold in the button on the lever, and push the
lever all the way toward the front of your car.
3. Move the ignition key to LOCK.
4. Remove the key and take it with you. If you can
walk away from your car with the ignition key in
your hand, your car
is in PARK (P).
Leaving Your Vehicle With the Engine
Running (Automatic Transmission Models
Only)
If you have to leave your vehicle with the engine
running, be sure your vehicle is in PARK (P) and your
parking brake is firmly set before you leave it. After
you’ve moved the shift lever into the PARK (P)
position, hold the regular brake pedal down. Then, see if
you can move the shift lever away from PARK (P)
without first pushing the button. If you can, it means
that the shift lever wasn’t fully locked into PARK
(P).
Torque Lock (Automatic Transmission)
If you are parking on a hill and you don’t shift your
transmission into PARK (P) properly, the weight of the
vehicle may put too much force on the parking pawl in
the transmission. You may find it difficult to pull the
shift lever out of PARK (P). This is called “torque lock.”
To prevent torque lock, set the parking brake and then
shift into PARK
(P) properly before you leave the
driver’s seat. To find out how, see “Shifting Into
PARK
(P)” in the Index.
When you are ready to drive, move the shift lever out of
PARK (P)
before you release the parking brake.
If “torque lock” does occur, you may need to have
another vehicle push
yours a little uphill to take some of
the pressure from the transmission,
so you can pull the
shift lever out of PARK (P).
2-35
ProCarManuals.com

Shiftiqg out of PARK (P)
(Authmatic .. .. Transmission)
Parking Your Vehicle
(Manual Transmission)
Your Pontic has a brake-transmission shift interlock. Before you get out of your vehicle, put your manual
You hqve to hlly apply your regular brake before you transmission in REVERSE (R) and firmly apply the
ca~ shjft from PARK (P) when the ignition is in the parking brake.
RUN position. See “Automatic Transmission” in the
Index.
If yov cmot shift out of PARK (P), ease pressure on
the shift lever - push the shift lever all the way into
PARK (P) and release the shift lever button as you
maintain brake application. Then press the shift lever
button
and move the shift lever into the gear you wish.
If you per hold the brake pedal down but still can’t
shift out
of PARK (P), try this:
1. Turn @e key to OFF.
If your vehicle is equipped to tow a trailer, see “Towing
a Trailer” in the Index.
2, Apply and hold the brake.
3. Shift to NEUTRAL (N).
4. St& the vehicle and then shift to the drive gear you
5. Have the vehicle fixed as soon as you can,
ww!.
ProCarManuals.com