radiator PONTIAC FIREBIRD 1995 Owners Manual

Vehicle Symbols
These are some of the symbols you may find on your vehicle.
For example, these symbols
are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
CAUSTIC
BURNS
AVOID
SPARKS
OR
FLAMES
SPARK OR ,\I/,
COULD FLAME
EXPLODE BAllERY
These symbols
are important
for you and
your passengers
whenever your
vehicle is
driven:
FASTEN SEAT 4
BELTS
POWER
WINDOW
These symbols
have to
do with
your lights:
SIGNALS e
TURN
pAE: pf
HIGH LAMPSoR BEAM = =o
FOG LAMPS $0
These symbols are on some
of
your controls:
WINDSHIELD
WIPER
i ‘t’ i
WINDSHIELD Q
WASHER I
WINDSHIELD
DEFROSTER
WINDOW
DEFOGGER
VENTILATING FAN
These symbols
are used on
warning and
indicator lights:
COOLANT F*
TEMP --
ENGINE
CHARGING 1-1
BATTERY
SYSTEM
BRAKE (0)
RADIATOR COOLANT
a
FUEL
ENGINE OIL
PRESSURE
9%
TEMP OIL &
ANTI-LOCK (a)
BRAKE
-
Here are some
other symbols
you may see:
FUSE
RAM0 h
VOLUME
CONDITIONING AIR 43
RELEASE a
LIGHTER m
SPEAKER
b
V
ProCarManuals.com

Windshield Washer
At &e top of the turn signal lever there’s a paddle with
thd wbrd
PUSH on it. To spray washer fluid on the
windshield, just push the paddle for less
than a second.
The washer will continue to spray until you release the
paddle. The wipers will clear the window and wipe a
few niore times before stopping or retuming to the
pr&+ms setting.
NOTICE:
0 When using concentrated washer fluid,
follow the manufacturer’s instructions for
adding water.
0 Don’t mix water with ready-to-use washer
fluid. Water can cause the solution
to freeze
and damage your washer fluid
tank aiad
other parts of the washer system.
Also,
water doesn’t clean as well as washer fluid.
0 Fili your washer fluid tank only 3/4 full
when it’s very cold. This allows fop
expansion, which could damage the
tank if
it is completely full.
windshield washer. It can damage your
washer system and paint.
0 Don’t use radiator antifreeze in your
ProCarManuals.com

Low Coolant Light (V8 Engine)
COOLANT
I I
I NOTICE:
Driving with the LOW COOLANT light on caul4
cause your Pontiac to overheat. See “Engine Overheating” in the Index. Your Pontiac&ul@ be
damaged and it wouldn’t be covered
by your
warranty.
This red warning light should come on while you are
starting your engine.
If the light doesn’t come on, have it
repaired. The light also comes
on when the coolant in
your radiator
is low. You may need to add coolant. See
“Engine Coolant” in the Index.
. 2773
ProCarManuals.com

Cooling System
V8 Engine
I.
When you decide it’s safe to lift the hood, here’s what
you’ll see:
1. Coolant recovery tank
2. Radiator pressure cap
3. Electric engine fan
V6 Engines
When you decide it’s safe to lift the hood, here’s what
you’ll see:
1. Coolant recovery tank
2. Radiator pressure cap
3. Electric engine fan
ProCarManuals.com

NOTICE:
In cold weather, water can freeze and crack the
engine, radiator, heater core and other parts. Use the recommended coolant.
I I
engine parts. Coolant contains ethylene gly
and it will burn if the engine narts arp hnt
When the coolant in the coolant recovery tank is at
WLL COLD, start your vehicle.
If the overheat warning continues, there’s one more
thing you can
try. You can add the proper coolant mix
directly to the radiator, but be sure the cooling system is 1
cool before you do it.
5-21
ProCarManuals.com

How to Add Coolant to the Radiator
(V6 Engines)
2. Then keep turning the pressure cap, but now push
down as you turn it. Remove the pressure cap.
1. You can remove the radiator pressure cap when the
cooling system, including the radiator pressure cap
and upper radiator hose, is no longer hot. Turn the
pressure cap slowly to the left until it first stops.
(Don’t press down while turning the pressure cap.)
If you hear a hiss, wait for that to stop. A hiss means
there is still some pressure left.
5-23
ProCarManuals.com

3. Fill the radiator with the proper mix, up to the base
of the filler neck.
4. Then fill the coolant recovery tank to mJLL COLD.
5-24
ProCarManuals.com

5. Put the cap back on the coolant recovery tank, but
leave the radiator pressure cap off.
6.
7.
Start the engine and let it run until you can feel the
upper radiator hose getting hot. Watch out for the
engine fan(
s) .
By this time the coolant level inside the radiator
filler neck may be lower.
If the level is lower, add
more
of the proper mix through the filler neck until
the level reaches the base of the filler neck.
5-25
ProCarManuals.com

How to Add Coolant to the Radiator - LTl
(Code P) Engine Only
NOTICE:
The LTl Engine (Code P) has a specific radiator
fill procedure. Failure to follow this procedure
could cause your engine to overheat and be
severely damaged.
8. Then replace the pressure cap. At any time during
this procedure
if coolant begins to flow out of the
filler neck, reinstall the pressure cap. Be sure the
arrows on the pressure cap line up like this.
5-26
ProCarManuals.com

1. You can remove the radiator pressure cap when the
cooling system, including the radiator pressure cap and upper radiator hose, is no longer hot.
Turn the
pressure cap slowly to the left until it first stops. (Don’t press down while turning the pressure cap.)
If you hear a hiss, wait for that to stop. A hiss means
there is still some pressure left.
2. Then keep turning the pressure cap, but now push
down as you
turn it. Remove the pressure cap. 3. After the engine cools, open the air bleed valves on
the heater return hose and water pump inlet.
5-27
ProCarManuals.com