climate settings PONTIAC G6 2007 Owners Manual

To change the air delivery settings, turn the right
knob to select one of the following:
H(Vent):Turn the knob to this mode to direct
air to the instrument panel outlets.
)(Bi-Level):Turn the knob to this mode to
direct half of the air to the instrument panel outlets,
and the remaining air to the oor outlets. Some
air may be directed toward the side windows.
6(Floor):Turn the knob to this mode to direct
most of the air to the oor outlets with some
air directed to the side window outlets and
windshield.
:(Outside Air):Press the right side of this
button to turn the outside air mode on. When this
mode is selected, air from outside the vehicle
circulates throughout your vehicle. An indicator
light will comes on to let you know that it is
activated. The outside air mode can be used with
all modes, but it cannot be used with the
recirculation mode. Press this button again to
cancel the recirculation mode.
?(Recirculation):Press the left side of the
button to turn the recirculation mode on. The air
inside the vehicle is recirculated through the climate
control system and throughout the vehicle, not from
outside. This mode is helpful when you are trying to
limit odors from entering your vehicle and for
maximum air conditioning performance in hot
weather. An indicator light above the button will
come on to let you know that it is activated. The
indicator light will blink three times if you try to use
recirculation in a mode that it can not be used in.
Only use this mode when it is needed for comfort,
since window fogging will rapidly occur if the air
conditioning compressor is not engaged.
Press this button to cancel the outside air mode.
When you switch to the defog or defrost modes the
system automatically moves from recirculation to
outside air. When the vehicle or fan is turned off
and back on, the system defaults to outside air
automatically. Only use recirculation mode when it
is needed for comfort, since window fogging may
occur.
183

Temperature Control:Turn the center knob
clockwise or counterclockwise to increase
or decrease the temperature inside your vehicle.
When it’s cold outside 0°F (−18°C) or lower,
use the engine coolant heater, if the vehicle has
one, to warm air faster in your vehicle. An
engine coolant heater warms the engine coolant
that is used to warm the inside of your vehicle. For
more information, seeEngine Coolant Heater on
page 128.
#(Air Conditioning):Press this button to turn
the air conditioning system on or off. When
the air conditioning button is pressed, an indicator
light comes on to indicate that the air conditioning
is activated.
The air conditioning system removes moisture from
the air, so sometimes a small amount of water drips
underneath the vehicle while it is idling or after the
engine is turned off. This is normal.
Maximum Air Conditioning
On hot days, open the windows to let hot inside
air escape; then close them. This helps to reduce
the time it takes for your vehicle to cool down.
It also helps the system to operate more efficiently.For quick cool down on hot days, do the following:
1. Select the
Cvent mode.
2. Select the highest fan speed.
3. Select
#air conditioning.
4. Select the
?recirculation mode.
5. Select the coolest temperature.
Using these settings together for long periods of
time can cause the air inside of your vehicle
to become too dry. To prevent this from
happening, after the air in your vehicle has cooled,
turn the recirculation mode off.
If your vehicle has the remote start feature, it will
turn on using the last settings selected on the
climate control before the vehicle was turned off.
The fan and air delivery knobs can be used during
remote start. The buttons will not work until the
ignition is turned on by the key.
The climate control system changes back to
manual operation when the vehicle key is
turned to ON.
184