thermostat PONTIAC GRAND PRIX 2003 Owners Manual

3.3. Lift the engine cover shield at the front, slide
the catch tab out
of the engine bracket and
remove the cover shield.
3.4. Put the oil fill tube, with cap attached, in the
valve cover oil
fill hole until you’re ready to
replace the cover shield. 4.
After the engine cools, open the coolant air bleed
valve or valves.
Thermostat Bypass Tube
(3100 V6)
Thermostat Housing
(31 00 V6)
3100 V6 engine: There are two bleed valves. One is
located on the thermostat housing. The other is located
on the thermostat bypass tube.
5-43

3800 V6 engine: There is
one bleed valve. It is
located on the thermostat
housing.
Thermostat Housing
(3800 V6)
5. Fill the radiator with the proper DEX-COOL@
coolant mixture, up to the base of the filler
neck. See Engine Coolant
on page 5-30 for more
information about the proper coolant mixture.
If you see a stream of coolant coming from an air
bleed valve, close the valve. Otherwise, close
the valves after the radiator is filled.
6. Rinse or wipe any spilled coolant from the engine
and the compartment.
7.
If you have the 3800 V6 engine, replace the 3800
7.1. Remove the oil fill tube, with cap attached,
Series
II V6
engine cover shield.
from the valve cover.
7.2. Insert the catch tab on the cover shield
under the bracket
on the engine.
7.3. Place the hole in the cover shield over the
hole
in the valve cover. Install oil fill tube and
cap by twisting clockwise.
7.4. If you have the supercharged engine, install
the nut in the center
of the cover shield.
5-44