radio PONTIAC GRAND PRIX 2007 Owners Manual

Remote Keyless Entry (RKE)
System
Your Remote Keyless Entry (RKE) system
operates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
and with Industry Canada.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
Changes or modications to this system by other
than an authorized service facility could void
authorization to use this equipment.At times you may notice a decrease in operating
range. This is normal for any RKE system.
If the transmitter does not work or if you have to
stand closer to your vehicle for the transmitter
to work, try this:
Check the distance. You may be too far from
your vehicle. You may need to stand closer
during rainy or snowy weather.
Check the location. Other vehicles or objects
may be blocking the signal. Take a few steps
to the left or right, hold the transmitter
higher, and try again.
Check to determine if battery replacement is
necessary. See “Battery Replacement”
underRemote Keyless Entry (RKE) System
Operation on page 87.
If you are still having trouble, see your dealer
or a qualied technician for service.
86

Disarming with Your Key
The alarm system will disarm when the key is
used to unlock the doors. The red light will stop
ashing when the system is disarmed. If you would
like the key to disarm the alarm system, see
“Personal Programming Mode Screens” underDIC
Vehicle Customization on page 226for more
information.
PASS-Key®III
Your PASS-Key®III system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry
Canada.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
Changes or modications to this system by other
than an authorized service facility could void
authorization to use this equipment.
PASS-Key®III uses a radio frequency transponder
in the key that matches a decoder in your
vehicle.
102

ACC (ACCESSORY):This position allows things
like the radio and windshield wipers to operate
while the engine is off.
R(RUN):This position is where the key returns
to after the vehicle is started. With the engine
off, the RUN position displays some of the warning
and indicator lights.
The battery could be drained if you leave the key
in the ACC or RUN position with the engine
off. You may not be able to start your vehicle if
the battery is allowed to drain for an extended
period of time.
/(START):This position starts the engine. Let
go of the key when the engine starts. The key will
return to the RUN for normal driving.
A continuous warning chime will sound and a KEY
IN IGNITION message will display on the Driver
Information Center (DIC) if the key is turned
to OFF or ACC and the driver’s door is opened.
Key In the Ignition
Never leave your vehicle with the keys inside, as it
is an easy target for joy riders or thieves. If you
leave the key in the ignition and park your vehicle,
a chime will sound, when you open the driver’s
door. Always remember to remove your key from
the ignition and take it with you. This will lock
your ignition and transaxle. Also, always remember
to lock the doors.
The battery could be drained if you leave the key
in the ignition while your vehicle is parked.
You may not be able to start your vehicle after it
has been parked for an extended period of time.
Retained Accessory Power (RAP)
If the vehicle has Retained Accessory
Power (RAP), certain features will continue to
operate for up to 10 minutes after the ignition key
is turned to OFF unless a door is opened.
106

Your vehicle must have a working electrical
system (including adequate battery power) for the
OnStar
®equipment to operate. There are other
problems OnStar®cannot control that may prevent
OnStar®from providing OnStar®service to you
at any particular time or place. Some examples are
damage to important parts of your vehicle in an
accident, hills, tall buildings, tunnels, weather
or wireless phone network congestion.
Your Responsibility
You may need to increase the volume of your
radio to hear the OnStar®advisor. If the light next
to the OnStar®buttons is red, this means that
your system is not functioning properly and should
be checked by a dealer. If the light appears
clear (no light is appearing), your OnStar
®
subscription has expired. You can always press
the OnStar®button to conrm that your OnStar®
equipment is active.
Storage Areas
Glove Box
Open the glove box by lifting up on the lever.
Close the glove box with a rm push.
Cupholder(s)
There are two cupholders in the front of the center
console.
Cupholder Installation and Removal
Your vehicle may also have a rear cupholder that
can be installed by aligning it to the console
and snapping it into place. To remove, pull it up
from the console.
126

Traction Control System (TCS)
Warning Light........................................ 178
Enhanced Traction System
Warning Light........................................ 179
Engine Coolant Temperature
Warning Light........................................ 179
Engine Coolant Temperature Gage............ 180
Malfunction Indicator Lamp........................ 180
Oil Pressure Light..................................... 184
Fog Lamp Light......................................... 185
Cruise Control Light.................................. 185
Highbeam On Light................................... 185
Fuel Gage................................................. 185
Driver Information Center (DIC).................. 186
DIC Controls and Displays
(Base Level DIC)................................... 186
DIC Controls and Displays
(Uplevel DIC with Trip Computer)........... 190
DIC Compass (Uplevel DIC)...................... 198
DIC Warnings and Messages.................... 200
DIC Vehicle Customization........................ 226Audio System(s)......................................... 233
Setting the Time........................................ 234
Radio with CD (Base Level)...................... 235
Radio with CD (MP3)................................ 245
Radio with Six-Disc CD............................. 255
Using an MP3........................................... 269
XM Radio Messages................................. 275
Theft-Deterrent Feature............................. 277
Audio Steering Wheel Controls.................. 277
Radio Reception........................................ 278
Care of Your CDs..................................... 279
Care of the CD Player.............................. 279
Backglass Antenna.................................... 280
XM™ Satellite Radio Antenna System....... 281
Chime Level Adjustment............................ 281
Section 3 Instrument Panel
130

Battery Run-Down Protection
The vehicle has a feature to help prevent the
battery from draining in case the interior, trunk, or
underhood lamps are accidentally left on. If
any of these lamps are left on while the ignition is
in OFF, they will automatically turn off after
10 minutes. The lamps will not come back on
again until any of the following are done:
The ignition is turned to RUN or ACC.
The interior lamps control is turned completely
to the right, then back slightly to the left.
Open, or close and reopen, a door that is
closed.
If the vehicle has less than 15 miles (25 km) on
the odometer, the battery saver will turn off
the lamps after only three minutes.
Head-Up Display (HUD)
{CAUTION:
If the HUD image is too bright or too high
in your eld of view, it may take you more
time to see things you need to see when it
is dark outside. Be sure to keep the HUD
image dim and placed low in your eld
of view.
If the vehicle has the Head-Up Display (HUD),
some information concerning the operation of the
vehicle is projected onto the windshield. This
includes the speedometer reading, transaxle
positions, compass direction, outside air
temperature, the tap shift gear and the upshift
symbol if active, and a brief display of the current
radio station, including XM information or CD
track. It will also display turn-by-turn guidance
information if the vehicle is has a navigation radio.
The images are projected by the HUD lens
located on the driver’s side of the instrument panel.
151

The HUD will temporarily display CHECK TRIP
COMPUTER when there are messages on the DIC
trip computer.
The HUD will also display the following messages
when these systems, if the vehicle has them,
are active:
TRACTION CONTROL ACTIVE
STABILITY CONTROL ACTIVE
The HUD will temporarily display the TRACTION
CONTROL OFF message when the traction
control system is turned off.
The HUD will temporarily display the CRUISE SET
message when cruise control is activated or
cruise speed is increased.
Notice:If you try to use the HUD image as a
parking aid, you may misjudge the distance
and damage your vehicle. Do not use the HUD
image as a parking aid.
When the HUD is on, the speedometer reading
will continually be displayed. The current radio
station or CD track number will display for a short
period of time after the radio or CD track status
changes. This will happen whenever one of
the radio controls is pressed.The speedometer size will be reduced when radio,
CD information, warnings, or turn-by-turn
guidance information are displayed on the HUD.
The HUD control is
located on the console.
To adjust the HUD image so that items are
properly displayed, do the following:
1. Adjust the driver’s seat to a comfortable
position.
2. Start the engine.
3. Adjust the HUD controls.
Use the following settings to adjust the HUD.
9(Off):Turn the outer ring on the HUD control
to this position to turn the HUD off.
153

I II III IIII (Brightness):Turn the outer ring on the
HUD control clockwise to dim the display and
counterclockwise to brighten it.
w(Up):Press this portion of the switch on the
HUD control to move the image up.
x(Down):Press this portion of the switch on
the HUD control to move the image down.
Move the image as low as possible on the
windshield, keeping it in full view.
?(Page):Press this button to select the display
formats. Release the page button when the
format number with the desired display is shown
on the HUD.
Format One:This display gives the
speedometer reading (in English or metric
units), transaxle positions, compass direction,
and the outside air temperature.
Format Two:This display includes the
information in Format One without the compass
direction and the outside air temperature.
Format Three:This display includes all the
information in Format One, but turns the
instrument cluster lighting off. Format three is
only available at night.
All formats will show the turn-by-turn guidance
information. It will display the next turn, direction,
street name, and distance to the selected
destination. When you near your destination, the
HUD will display a distance bar that will ll in
the closer you get to your destination. All
navigation information is provided to the HUD by
the navigation radio, if the vehicle has one.
The warning indicators still appear on the
instrument panel when required. The HUD will
display Stealth Mode On.
The HUD will store the last display format selected.
If the last format displayed was Format One or
Format Three, then Format One will be displayed
when the vehicle is started.
If the last format was Format Two, then Format
Two will be displayed.
154

When the indicator nears empty, there is still a
little fuel left, but you should get more soon.
Here are four things owners usually ask about the
fuel gage. All these situations are normal and
do not indicate a problem with the fuel gage:
At the gas station the pump shuts off before
the gage reads full.
It takes more or less fuel to ll up than the
gage indicates. For example, the gage
reads half full, but it took more or less than
half the tank’s capacity to ll it.
The gage pointer may move while cornering,
braking or speeding up.
The gage may not indicate full when the
ignition is turned off.
Driver Information Center (DIC)
The Driver Information Center (DIC) gives
important safety and maintenance facts. When the
vehicle’s ignition is turned on, all of the DIC
lights illuminate for a few seconds and an
introductory message will appear. After this, the
DIC will begin working.
DIC Controls and Displays
(Base Level DIC)
The Driver Information Center (DIC) control
buttons and the message display screen are
located above the radio. The DIC gives important
safety and maintenance facts concerning the
vehicle. The status of many of the vehicle’s
systems along with driver personal programming
mode menus and warning messages about
the vehicle’s systems may display on the DIC
screen.
The vehicle’s transaxle position will also appear.
The buttons on the base level are trip odometer,
set/reset, and options.
186

Set/Reset
r(Set/Reset):Press this button to set or reset
a menu item when using the trip odometer or
options buttons.
Options
4(Options):Press this button to access the Date,
Language, Display Units, Daytime Display
Enhancement, Engine Oil Monitor System,
Personal Programming modes, and Tire Pressure
readings.
Date:This menu sets the date.
The time is set through the radio. SeeSetting the
Time on page 234for more information.
To set the date, use the following procedure:
1. Press the options button until the date
is displayed on the DIC.
2. Press the set/reset button to access the
RESET YEAR screen. The second position in
the year will be selected. Press and hold
the set/reset button to scroll through the
available digits. Release the button when the
correct digit appears.3. Press the options button to advance to the
rst position in the year. Press and hold the
set/reset button to scroll through the available
digits. Release the button when the correct
digit appears.
4. Press the options button to advance to the
months of the year.
5. Press the set/reset button to scroll through the
months of the year, releasing the button when
the correct month appears.
6. Press the options button to advance to the
days of the month.
7. Press the set/reset button to scroll through the
days of the month, releasing the button when
the correct day appears.
8. Press the options button again to advance to
the main date screen. The screen will now
display the new date.
Language:This menu allows the selection of the
language in which the DIC messages will
appear. The DIC can be programmed to one of
three languages: English, French, or Spanish. The
message on the HUD, if equipped, will also
appear in the language selected. SeeHead-Up
Display (HUD) on page 151.
188