lights PORSCHE CAYMAN 2010 1.G Repair Manual
[x] Cancel search | Manufacturer: PORSCHE, Model Year: 2010, Model line: CAYMAN, Model: PORSCHE CAYMAN 2010 1.GPages: 284, PDF Size: 5.94 MB
Page 250 of 284

248
Practical Tips, Emergency Service
Headlights
Caution!
Risk of damage to headlights due to exces-
sive temperatures and abrasion.
f To ensure optimum ventilation, do not cover
the gap between headlight and body
(e.g. “stone guards” or films).
f Use soapy water only to clean light lenses and
plastic headlight lenses.
In no case may chemical cleaners or other vol-
atile cleaning fluids be used.
f To prevent scratches, do not rub with a dry or merely moist cloth, tissue or insect sponges.
Removing headlights1. Unscrew plastic nut A.
Detach the side carpeting. 2. Remove rubber plug
B from the unlocking
opening.
Page 251 of 284

Practical Tips, Emergency Service
249
3. Place socket wrench (tool kit) on the unlocking spindle.
The handle of the wrench should point horizon-
tally to the rear.
4. Turn socket wrench approx. 180° A. The
headlight is unlocked and pushed forward
slightly during this process.
5. Turn socket wrench ba ck until it is pointing
vertically downward B and leave in position.
6. The headlight is now unlocked and can be pulled forward out of the fender.
Installing1. Insert headlight into the guide rails and push
fully into the fender.
2. Push headlight to the rear and at the same time turn the socket wrench until it points
horizontally to the rear C.
The headlight locking device must perceptibly
and audibly engage.
3. Insert the rubber plug into the unlocking opening and secure the carpet.
Check the function of all lights.
Low beam/high beam
Halogen/Bi-Xenon headlightOpening the lid of the headlight housing
1. Unscrew the 4 screws A .
2. First lift release tab B, then push both release
tabs C upwards and take off lid.
Page 252 of 284

250
Practical Tips, Emergency Service
Changing bulb for low beam
Halogen headlights1. Pull off plug A.
2. Disengage fixing clip B.
3. Replace defective bulb. When doing so, ensure bulb is seated properly.
4. Reassemble in reverse order.
Closing the cover of the headlight housing
1. Push on cover until it is felt to engage.
2. Fasten cover with the 4 screws.
Changing bulb for high beam
Halogen headlights1. Turn housing cover counter-clockwise and take it off. 2. Turn bulb holder clockwise and remove it
(bayonet lock).
3. Pull both plug release tabs apart and pull plug out.
4. Replace the defective bulb with bulb holder.
5. Insert bulb holder and turn it as far as it will go to the left.
6. Close the housing cover.
Page 253 of 284

Practical Tips, Emergency Service
251
Changing bulb for low beam/high beam
Bi-Xenon headlights1. Unscrew the 3 screws A on the control unit and
remove the control unit. 2. Turn the plug counter-clockwise and pu
ll it off. 3. Disengage both fixing clips.
4. Replace defective bulb.When doing so, ensure bulb is seated properly.
5. Engage both fixing clips, push on plug and turn right as far as the stop.
6. Fit control unit and screw tight.
Closing the cover of the headlight housing
1. Push on cover until it is felt to engage.
2. Fasten cover with the 4 screws.
Page 254 of 284

252
Practical Tips, Emergency Service
Changing bulb for additional high beam
Bi-Xenon headlights1. Turn housing cover counter-clockwise and take it off. 2. Pull off plug. 3. Disengage fixing clip.
4. Replace defective bulb.
5. Engage fixing clip, insert plug and close housing cover.
Page 255 of 284

Practical Tips, Emergency Service
253
Changing bulb for turn signal light
Halogen/Bi-Xenon headlights1. Turn housing cover counter-clockwise and take it off. 2. Turn bulb holder counter-clockwise and
remove it (bayonet lock). 3. Replace the defective bulb (bayonet lock).
4. Insert the bulb holder and turn it clockwise.
5. Close the housing cover.
Page 256 of 284

254
Practical Tips, Emergency Service
A- Fog light height adjustmentChanging bulb for fog lights1. Pull cover forward in direction of arrow. 2. Loosen the two screws on the bulb housing,
swivel the housing out to the side and
remove it. 3. Pull both plug release tabs apart and pull
plug out.
4. Turn bulb holder in direction of arrow and remove it.
5. Replace the defective bulb with bulb holder.
6. Insert bulb holder and turn it as far as it will go to the right. Then insert plug. Make sure that
the two tabs engage correctly.
Page 258 of 284

256
Practical Tips, Emergency Service
3. Remove side marker and undo bulb holder
(bayonet lock).
4. Remove the bulb from the holder and replace it. Insert holder.
Check operation of the light.
5. Insert the side marker’s retaining lugs A into
the side section at the front.
Push in side marker until the securing spring B
is felt to engage.
6. Press the cap into the wheel housing liner.
Number Plate LightChanging bulb1. Unscrew both screws A and take off the light
lens.
2. Remove defective bulb from between the contact springs and replace.
3. Reassemble in reverse order. Check operation of the light.
Changing Light-Emitting Diodes
and Long-Life BulbsThe following lights are equipped with light-
emitting diodes (LEDs) or long-life bulbs and
cannot be replaced individually. Replacement also
involves a greater amount of installation work.
– Side light, front,
– Daytime driving lights on vehicles with Bi-Xenon headlights,
– Tail lights and
– Additional brake lights
f Have the defective light replaced at an autho-
rized Porsche dealer.
Page 259 of 284

Practical Tips, Emergency Service
257
Adjusting HeadlightsfPlease see the chapter “LIGHTS, REPLACING
BULBS” on Page 247.
Adjustment
The adjustment is made wi th the vehicle ready to
drive and the fuel tank completely filled.
The driver’s seat must be loaded by a person or a
165 lbs. (75 kg) weight and the tire pressures
must meet the prescribed values.
After being loaded, the car must be rolled a few
meters so that the suspension can settle.
For checking the headlight adjustment, the verti-
cal position of the cutoff of the lowbeam (see fig.)
has to be projected on a ve rtical screen (wall) in
distance of 24.6 ft. (7.5 m) from the front lens of
the headlamp.
The correct position of the cutoff is 2.0 in. (5 cm)
at 24.6 ft. or 7.5 m (0.4 °) below a horizontal line,
x cm from ground to the center of the headlamp
lens. Lateral adjustment of the
headlights should be
carried out at a specialist workshop with an optical
adjustment unit.
Distance
Visual aim shall be perf ormed at not less than
24.6 ft./7.5 m (this value is a rounded down con-
version from the 25-foot distance typical of field
aim using a screen). The 24.6 ft./7.5 m distance
is measured from the headlamp lens to the view-
ing screen.
Page 277 of 284

Index
275
AABS (antilock brake system) .......................... 59
Warning light .......... .............................. 60
Adaptive sports seat ..................................... 33
Adjusting Headlights.... ................................ 257
Advanced Airbag......... .................................. 45
Air conditioning ........... ................................ 110
Air conditioning compressor ................ 113, 115
Air conditioning system .................... ........... 113
Air distribution ................ ............ 110, 113, 115
Air filter ...................... ................................ 201
Air intake.................... ................................ 116
Airbag ............................ .............................. 44
Cleaning covers ...... ............................ 208
Function ..................... .......................... 45
Warning light .......... .............................. 48
Air-conditioning compressor ........................ 112
Alarm system ................. ...................... 25, 103
Deactivating passenger compartment
monitoring .............. .............................. 26
Fault indication........ .............................. 26
Function indication ................................ 25
Not active .............. ............................ 236
Alcantara, cleaning . .................................... 209
Antenna ................. .................... 103, 104, 204
Antifreeze .................................................. 187
Antilock brake system (ABS) .......................... 59
Warning light .......... .............................. 60
Ashtray .......................... .............................. 89
Assembly aids for wheel changes................. 227
Audio operation .............. .................... 101, 102
Auto-button, air conditioning ........................ 113
Automatic Air conditioning system ....................... 113 Anti-glare mirrors .......................
...........30
Car washes .............. ..........................204
Door locking ............. ......................18, 24
Garage door ......... ................................76
Headlight adjustment .............................79
Speed control .........................86, 87, 124
Transmission ............ ..........................178
Automatic speed contro l..............................124
Indicator light ........ ..............................124
Average consumption .... ......................135, 165
Average speed ............. ......................135, 165
BBackrest
Adjustment ............... ............................32
Release .................... ............................32
Battery ......................... ..............................239
Care......................... ..........................240
Charge state......... ..............................239
Charging .................. ..........................240
Putting vehicle into operation ...............241
Remote control ..... ..............................244
Removing ................. ..........................242
Replacing ................. ..........................241
Warning light......... ..............................132
Winter operation.... ..............................241
Before driving off ...... ..................................8, 9
Belts ................ ............................................42
Cleaning ................... ..........................209
Tensioner ................. ............................42
Warning light......... ................................43
Blower adjustment ........ ......................110, 116
Blower speed adjustme nt ............................114 Brake
Break in ................... ............................ 10
Pads ....................... ............................ 58
Pedal....................... ............................ 57
Wear ....................... ............................ 58
Brake fluid Changing ................. .......................... 193
Checking level ...... .............................. 192
Level ....................... .......................... 192
Warning light ............ .......................... 193
Brake light .............. ................................... 256
Brake light, addition al ................................. 256
Brakes ........................ .............................. 192
Brake circuit division warning light ....... 193
Brake warning light ............................. 132
Fluid ............................ .............. 192, 271
Fluid warning light. .............................. 193
Function .................. ............................ 56
New brake pads or linings ..................... 58
Pads ....................... ............................ 10
Parking brake....... ................................ 55
Porsche Ceramic Composite Brake
(PCCB) .................................... .............. 4
Test stand ........... ................................ 65
Break in brakes ....... ..................................... 10
Break in hints .......... ..................................... 10
Bulbs Chart ....................... .......................... 247
Replacing ................ .......................... 247