torque Ram 1500 2013 Owner's Guide

These dual rear wheels should be tightened as follows:
1. Tighten the wheel nuts in the numbered sequence to asnug fit.
2. Retighten the wheel nuts in the same sequence to the torques listed in the table. Go through the sequence a second time to verify that specific torque has been
achieved. Retighten to specifications at 100 miles
(160 km) and after 500 miles (800 km).
It is recommended that wheel stud nuts be kept torqued
to specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
HOISTING
A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking loca-
tions. However, a floor jack or frame hoist must never be
used on any other parts of the underbody.
CAUTION!
Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.
Tightening Pattern
6
WHAT TO DO IN EMERGENCIES 611

CAUTION!
•Using a transmission fluid other than the manufac-
turer’s recommended fluid may cause deterioration
in transmission shift quality and/or torque con-
verter shudder, and will require more frequent
fluid and filter changes. Refer to “Fluids, Lubri-
cants, and Genuine Parts” in “Maintaining Your
Vehicle” for fluid specifications.
Special Additives
The manufacturer strongly recommends against using
any special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered product and
its performance may be impaired by supplemental addi-
tives. Therefore, do not add any fluid additives to the
transmission. The only exception to this policy is the use of special dyes for diagnosing fluid leaks. Avoid using
transmission sealers as they may adversely affect seals.
CAUTION!
Do not use chemical flushes in your transmission as
the chemicals can damage your transmission compo-
nents. Such damage is not covered by the New
Vehicle Limited Warranty.
Fluid Level Check - Six-Speed Transmission
It is best to check the fluid level when the transmission is
at normal operating temperature (170-180°F / 77-82°C).
This normally occurs after at least 15 miles (25 km) of
driving. At normal operating temperature the fluid can-
not be held comfortably between the fingertips. You can
read the transmission sump temperature in the EVIC
display (see Electronic Vehicle Information Center [EVIC]
for further information).
7
MAINTAINING YOUR VEHICLE 659

Tire Safety Information.....................482
Tongue Weight/Trailer Weight ................544
Tonneau Cover .......................... .667
Tonneau Cover Cleaning ....................667
Torque Converter Clutch ....................375
Tow Hooks, Emergency .....................618
Towing ............................... .534
Disabled Vehicle ....................... .623
Guide .............................. .540
Recreational .......................... .561
Weight .............................. .540
Traction ............................... .441
Traction Control ......................... .471
Trailer Sway Control (TSC) ..................481
Trailer Towing .......................... .534
Cooling System Tips .....................556
Hitches ............................. .539
Minimum Requirements ..................545
Mirrors ............................. .139Trailer and Tongue Weight
.................544
Wiring .............................. .553
Trailer Towing Guide ...................... .540
Trailer Weight ........................... .540
Transfer Case ........................... .658
Electronically Shifted .....................390
Fluid ............................... .692
Transmission ........................... .355
Automatic ........................... .355
Fluid ............................... .692
Maintenance .......................... .658
Shifting ............................. .352
Transmitter Battery Service (Remote Keyless Entry) . .30
Transmitter Programming (Remote Keyless Entry) . . .23
Transmitter, Remote Keyless Entry (RKE) .........23
Tread Wear Indicators ..................... .500
Turn Signals ............................ .171
Uniform Tire Quality Grades .................
71110
INDEX 729

Unleaded Gasoline....................... .521
Untwisting Procedure, Seat Belt ................59
Utility Rails, Rear Cargo Area ................243
Vehicle Identification Number (VIN) .............6
Vehicle Loading ......................... .489
Vehicle Modifications/Alterations ...............7
Vehicle Storage .......................... .332
Warning Lights (Instrument Cluster Description) . . .257
Warnings and Cautions .......................6
Warranty Information ..................... .708
Washers, Windshield ...................... .173
Washing Vehicle ......................... .662
Water Driving Through ....................... .442
Wheel and Wheel Trim .....................664
Wheel and Wheel Trim Care .................664
Wheel Cover ........................... .590Wheel Nut Torque
........................ .590
Winch ................................ .445
Accessories ........................... .449
Operation ............................ .450
Rigging Techniques ..................... .463
Usage .............................. .445
Wind Buffeting ............................47
Window Fogging ........................ .332
Windows ................................44
Power ................................44
Rear Sliding .......................... .227
Windshield Defroster ...................... .122
Windshield Washers ...................... .172
Fluid ............................... .172
Windshield Wiper Blades ....................644
Windshield Wipers ....................... .172
Wiper Blade Replacement ...................644
Wipers, Intermittent ...................... .173
Wipers, Rain Sensitive ..................... .175
730 INDEX