rambox Ram 1500 2020 Owner's Manual

4
Climate Control Functions ........................................... 90
Automatic Temperature Control (ATC) — If
Equipped......................................................................... 91
Operating Tips .............................................................. 92
 WINDOWS .......................................................................... 94
Power Windows ........................................................... 94
Wind Buffeting .............................................................. 97
 POWER SUNROOF — IF EQUIPPED ............................. 98
Single Pane Power Sunroof — If Equipped ............... 98
Dual Pane Power Sunroof — If Equipped ............... 101
 HOOD ................................................................................ 105
To Open The Hood ..................................................... 105
To Close The Hood...................................................... 106
 TAILGATE ......................................................................... 106
Opening ........................................................................ 106
Closing .......................................................................... 107
Multifunction Tailgate — If Equipped ..................... 107
 GARAGE DOOR OPENER — IF EQUIPPED............... 109
Before You Begin Programming HomeLink® ........ 110
Canadian/Gate Operator Programming ................. 113
Using HomeLink® ...................................................... 114
Security ......................................................................... 114
Troubleshooting Tips .................................................. 115
General Information .................................................... 115 
INTERNAL EQUIPMENT ...............................................116
Storage ...........................................................................116
Cupholders ..................................................................126
Electrical Power Outlets..............................................128
Power Inverter — If Equipped ................................. 131
Wireless Charging Pad — If Equipped ...................134
Overhead Sunglass Storage........................................135
 PICKUP BOX .....................................................................135
 RAMBOX — IF EQUIPPED ............................................136
RamBox Integrated Box Side Storage Bins............... 137
RamBox Safety Warning .............................................139
Bed Divider — If Equipped........................................140
Bed Rail Tie-Down System .........................................144
 SLIDE-IN CAMPERS .......................................................146
Camper Applications ..................................................146
 EASY-OFF TAILGATE ....................................................147
Disconnecting The Rear Camera And Remote
Keyless Entry ................................................................147
Removing The Tailgate ...............................................148
Locking Tailgate........................................................... 150
 TRI-FOLD TONNEAU COVER — IF EQUIPPED ....... 150
Tri-Fold Tonneau Cover Removal.............................150
Tri-Fold Tonneau Cover Installation ........................ 155
Tri-Fold Tonneau Cover Cleaning ............................160
2020_DT_1500_OM_US.book Page 4

18 GETTING TO KNOW YOUR VEHICLE
KEYS
Key Fob
Your vehicle uses a keyless ignition system. The ignition
system consists of a key fob with Remote Keyless Entry
(RKE) and a START/STOP push button ignition system. The
Remote Keyless Entry system consists of a key fob and
Keyless Enter-N-Go feature.
NOTE:
• The key fob may not be found if it is located next to amobile phone, laptop or other electronic device; these
devices may block the key fob’s wireless signal.
• If your vehicle is equipped with a Wireless Charging Pad, the key fob may not be found if it is placed within 15 cm
(150 mm) of the pad. Refer to “Wireless Charging Pad—If
Equipped” in this chapter for further information.
The key fob allows you to lock or unlock all doors, tailgate,
and the RamBox (if equipped) as well as activate the Panic
Alarm from distances up to approximately 66 ft (20 m) using
a handheld key fob. The key fob does not need to be pointed
at the vehicle to activate the system. NOTE:
• In the ON/RUN position, all key fob buttons will work
until the vehicle reaches 2 mph (4 km/h).
• The key fob should not be placed next to the wireless charging pad (if equipped).
Key Fob
1 — Emergency Key
2 — PANIC
3 — Lock
4 — Unlock
5 — LED Light
2020_DT_1500_OM_US.book Page 18

GETTING TO KNOW YOUR VEHICLE 19
In case the ignition switch does not change with the push of
a button, the key fob may have a low or fully depleted
battery. A low key fob battery can be verified by referring to
the instrument cluster, which will display directions to
follow.
NOTE:
A low key fob battery condition may be indicated by a
message in the instrument cluster display, or by the LED
light on the key fob. If the LED key fob light no longer illu-
minates from key fob button pushes, then the key fob battery
requires replacement.
In a situation where the battery is low or fully depleted, a
back up method can be used to operate the ignition switch.
Put the nose side of the key fob (side opposite of the emer-
gency key) against the START/STOP ignition button and
push to operate the ignition switch.
To Unlock The Doors And Tailgate
Push and release the unlock button on the key fob once to
unlock the driver’s door. Push the unlock button twice
within five seconds to unlock all doors, the tailgate and the
RamBox (if equipped). The turn signal lights will flash to
acknowledge the unlock signal. The illuminated entry
system will also turn on. NOTE:
The instrument cluster display or Uconnect Settings are
setup for driver door first, otherwise this will unlock all
doors.
To Lock The Doors And Tailgate
Push and release the lock button on the key fob to lock all
doors, the tailgate, and the RamBox (if equipped). The turn
signal lights will flash and the horn will chirp to acknowl
-
edge the signal.
Sound Horn With Remote Key Lock
This feature will cause the horn to chirp when the doors are
locked with the key fob. This feature can be turned on or
turned off.
NOTE:
Pushing the lock button on the key fob while you are in the
vehicle will activate the vehicle security alarm system.
Opening a door with the vehicle security alarm system acti -
vated will cause the alarm to sound. Push the unlock button
to deactivate the vehicle security alarm system.
Refer to “Instrument Cluster Display” in “Getting To Know
Your Instrument Panel” for further information.
2
2020_DT_1500_OM_US.book Page 19

132 GETTING TO KNOW YOUR VEHICLE
NOTE:
400 Watts is the maximum for the inverter, not each outlet. If
three outlets are in use, 400 Watts is shared amongst the
devices plugged in.
If equipped, a 115 Volt (400 Watts Maximum) inverter may
be located inside the ram box of your vehicle. The inverter
can be turned on by the Instrument Panel Power Inverter
switch located to the left of the steering wheel. The RamBox
inverter can power cellular phones, electronics and other low
power devices requiring power up to 400 Watts. Certain
high-end video game consoles exceed this power limit, as
will most power tools.
The Instrument Panel Power Inverter switch is only found on
vehicles equipped with a RamBox. The switch only controls
on/off operation of the power outlet in the RamBox; it does
not control on/off operation of the power outlets located
inside the cabin of the vehicle.Ram Box Power Inverter
2020_DT_1500_OM_US.book Page 132

136 GETTING TO KNOW YOUR VEHICLE
(Continued)
NOTE:
If you are installing a Toolbox, Ladder Rack or Headache
Rack at the front of the Pickup Box, you must use Mopar Box
Reinforcement Brackets that are available from an autho-
rized dealer.
You can carry wide building materials (sheets of plywood,
etc.) by building a raised load floor. Place lumber across the
box in the indentations provided above the wheel housings
and in the bulkhead dividers to form the floor.
There are stampings in the sheet metal on the inner side
bulkheads of the box in front of and behind both wheel hous-
ings. Place wooden boards across the box from side to side to
create separate load compartments in the pickup box.

There are four tie-down cleats bolted to the lower sides of the
pickup box that can sustain loads up to 1000 lbs (450 kg) total.

RAMBOX — IF EQUIPPED
The RamBox system is an integrated pickup box storage and
cargo management system consisting of three features:
• Integrated box side storage bins
• Cargo divider
• Bed rail tie-down system
WARNING!
• The pickup box is intended for load carrying purposes only, not for passengers, who should sit in seats and
use seat belts.
• Care should always be exercised when operating a vehicle with unrestrained cargo. Vehicle speeds may
need to be reduced. Severe turns or rough roads may
cause shifting or bouncing of the cargo that may result
in vehicle damage. If wide building materials are to be
frequently carried, the installation of a support is
recommended. This will restrain the cargo and transfer
the load to the pickup box floor.

• If you wish to carry more than 600 lbs (272 kg) of materialsuspended above the wheelhouse, supports must be
installed to transfer the weight of the load to the pickup
box floor or vehicle damage may result. The use of proper
supports will permit loading up to the rated payload.

• Unrestrained cargo may be thrown forward in an acci -
dent causing serious or fatal injury.
WARNING! (Continued)
2020_DT_1500_OM_US.book Page 136

GETTING TO KNOW YOUR VEHICLE 137
NOTE:
Bed rail tie-down system is also available for vehicles not
equipped with a RamBox.
RamBox Integrated Box Side Storage Bins
Cargo storage bins are located on both sides of the pickup
box. The cargo storage bins provide watertight, lockable,
illuminated storage for up to 150 lbs (68 kg) of evenly distrib-
uted cargo.
RamBox Cargo Storage Bins To open a storage bin with the RamBox unlocked, push and
release the button located on the lid. The RamBox lid will
open upward to allow hand access. Lift the lid to fully open.
NOTE:
RamBox will not open when the pushbutton is pushed if the
RamBox is locked.
CAUTION!
Failure to follow the following items could cause
damage to the vehicle:
• Assure that all cargo inside the storage bins is properly secured.
• Do not exceed cargo weight rating of 150 lb (68 kg) per bin.
2
2020_DT_1500_OM_US.book Page 137

138 GETTING TO KNOW YOUR VEHICLE
RamBox Push Button And Keyhole LockThe interior of the RamBox will automatically illuminate
when the lid is opened. The timing can be adjusted through
your touchscreen.
Refer to “Uconnect Settings” in “Multimedia” for further
information.
Cargo bins feature two removable drain plugs (to allow
water to drain from bins). To remove plug, pull up on the
edge. To install push plug downward into drain hole.
If equipped, a power inverter can be found inside the
RamBox.
Refer to “Electrical Power Outlets” in this chapter for further
information.
NOTE:
Provisions are provided in the bins for cargo dividers. These
accessories (in addition to other RamBox accessories) are
available from Mopar.
1 — Keyhole Lock
2 — Push Button
CAUTION!
Leaving the lid open for extended periods of time could
cause the vehicle battery to discharge. If the lid is
required to stay open for extended periods of time, it is
recommended that the bin lights be turned off manually
using the on/off switch.
2020_DT_1500_OM_US.book Page 138

GETTING TO KNOW YOUR VEHICLE 139
Locking And Unlocking RamBox
Push and release the lock or unlock button on the key fob to
lock and unlock all doors, the tailgate and the RamBox (if
equipped). Refer to “Keys” in this chapter for further details.
To unlatch the storage bin manually, insert the emergency
key into the keyhole and turn clockwise. Always return the
key to the upright (vertical) position before removing it from
the keyhole.RamBox Safety Warning
Carefully follow these warnings to help prevent personal
injury or damage to your vehicle:
CAUTION!
• Ensure cargo bin lids are closed and latched before moving or driving vehicle.
• Loads applied to the top of the bin lid should be mini -
mized to prevent damage to the lid and latching/
hinging mechanisms.
• Damage to the RamBox bin may occur due to heavy/ sharp objects placed in bin that shift due to vehicle
motion. In order to minimize potential for damage,
secure all cargo to prevent movement and protect inside
surfaces of bin from heavy/sharp objects with appro -
priate padding.
WARNING!
• Always close the storage bin covers when your vehicle is unattended.
• Do not allow children to have access to the storage bins. Once in the storage bin, young children may not be able
to escape. If trapped in the storage bin, children can die
from suffocation or heat stroke.
• In an accident, serious injury could result if the storage bin covers are not properly latched.
• Do not drive the vehicle with the storage bin covers open.
• Keep the storage bin covers closed and latched while the vehicle is in motion.
• Do not use a storage bin latch as a tie down.2
2020_DT_1500_OM_US.book Page 139

140 GETTING TO KNOW YOUR VEHICLE
RamBox Storage Bin Cover Emergency Release Lever —
If Equipped
As a security measure, a Storage Bin Cover Emergency
Release is built into the storage bin cover latching mecha-
nism.
Storage Bin Cover Emergency Release Lever NOTE:
In the event of an individual being locked inside the storage
bin, the storage bin cover can be opened from inside of the
bin by pulling on the glow-in-the-dark lever attached to the
storage bin cover latching mechanism.
Bed Divider — If Equipped
The bed divider has two functional positions:
• Storage Position
• Divider Position
Storage Position
The storage position for the bed divider is at the front of the
truck bed which maximizes the bed cargo area when not in
use.
2020_DT_1500_OM_US.book Page 140

GETTING TO KNOW YOUR VEHICLE 145
NOTE:
This feature is available for vehicles both equipped, or not
equipped, with a RamBox.
There are two adjustable cleats on each side of the bed that
can be used to assist in securing cargo.Adjustable Cleats
Each cleat must be located and tightened down in one of the
detents, along either rail, in order to keep cargo properly
secure. To move the cleat to any position on the rail, turn the nut
counterclockwise, approximately three turns. Then pull out
on the cleat and slide it to the detent nearest the desired loca
-
tion. Make sure the cleat is seated in the detent and tighten
the nut.
Adjustable Cleat Assembly
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
2
2020_DT_1500_OM_US.book Page 145