adding oil Ram 3500 2016 Owner's Manual
[x] Cancel search | Manufacturer: RAM, Model Year: 2016, Model line: 3500, Model: Ram 3500 2016Pages: 919, PDF Size: 6.67 MB
Page 477 of 919
▫Ethanol Fuel (E-85) ....................681
▫ Fuel Requirements ....................682
▫ Selection Of Engine Oil For Flexible Fuel Vehicles
(E-85) And Gasoline Vehicles .............682
▫ Starting ........................... .683
▫ Cruising Range ...................... .683
▫ Replacement Parts ....................683
▫ Maintenance ....................... .684
ADDING FUEL ....................... .684
▫ Loose Fuel Filler Cap Message ............686
VEHICLE LOADING ....................687
▫ Certification Label ....................687
TRAILER TOWING .....................689
▫ Common Towing Definitions .............689
▫ Trailer Hitch Type and Maximum Trailer
Weight ............................ .697
▫ Trailer Towing Weights (Maximum Trailer Weight
Ratings) ........................... .698
▫ Trailer And Tongue Weight ..............698
▫ Towing Requirements ..................699
▫ Towing Tips ........................ .709
SNOWPLOW .........................711
▫ 1500 Models Only .....................711
▫ 2500/3500 Models Only .................712
5
STARTING AND OPERATING 475
Page 800 of 919
CAUTION!(Continued)
•Your vehicle has been built with improved fluids
that protect the performance and durability of your
vehicle and also allow extended maintenance inter-
vals. Do not use chemical flushes in these compo-
nents as the chemicals can damage your engine,
transmission, or air conditioning. Such damage is
not covered by the New Vehicle Limited Warranty.
If a flush is needed because of component malfunc-
tion, use only the specified fluid for the flushing
procedure.
Engine Oil
Checking Oil Level
To assure proper lubrication of your vehicle’s engine, the
engine oil must be maintained at the correct level. Check
the oil level at regular intervals, such as every fuel stop.
The best time to check the engine oil level is about five
minutes after a fully warmed up engine is shut off.
Checking the oil while the vehicle is on level ground will
improve the accuracy of the oil level readings. Always
maintain the oil level within the SAFE zone on the
dipstick. Adding one quart of oil when the reading is at
the bottom of the SAFE zone will result in a reading at the
top of the safe zone on these engines.
798 MAINTAINING YOUR VEHICLE
Page 834 of 919
5. Place the gear selector momentarily into each gearposition (allowing time for the transmission to fully
engage in each position), ending with the transmission
in PARK.
6. Remove the dipstick, wipe it clean and reinsert it until seated.
7. Remove the dipstick again and note the fluid level on both sides. The fluid level reading is only valid if there
is a solid coating of oil on both sides of the dipstick.
Note that the holes in the dipstick will be full of fluid
if the actual level is at or above the hole. The fluid level
should be between the “HOT” (upper) reference holes
on the dipstick at normal operating temperature. If the
fluid level is low, add fluid through the dipstick tube
to bring it to the proper level. Do not overfill.Use
ONLY the specified fluid (see Fluids, Lubricants, And
Genuine Parts for fluid specifications). After adding
any quantity of oil through the dipstick tube, wait a minimum of two minutes for the oil to fully drain into
the transmission before rechecking the fluid level.
NOTE: If it is necessary to check the transmission below
the operating temperature, the fluid level should be
between the two “COLD” (lower) holes on the dipstick
with the fluid at 60-70°F / 16-21°C. Only use the COLD
region of the dipstick as a rough reference when setting
the fluid level after a transmission service or fluid
change. Re-check the fluid level, and adjust as required,
once the transmission reaches normal operating tempera-
ture.
CAUTION!
If the fluid temperature is below 50 °F (10 °C) it may
not register on the dipstick. Do not add fluid until
the temperature is elevated enough to produce an
accurate reading. Run the engine at idle, in PARK, to
warm the fluid.
832 MAINTAINING YOUR VEHICLE
Page 904 of 919
Flat Tire Stowage..................... .745, 765
Flexible Fuel Vehicles Cruising Range ........................ .683
Engine Oil ........................... .682
Fuel Requirements ...................681, 682
Maintenance .......................... .684
Replacement Parts ...................... .683
Starting ............................. .683
Flooded Engine Starting ....................480
Fluid, Brake ............................ .870
Fluid Capacities ......................... .864
Fluid Leaks ............................ .122
Fluid Level Checks Brake ............................... .826
Power Steering ........................ .615
Fluids, Lubricants And Genuine Parts ...........866
Fog Lights ....................... .176, 317, 856
Fold Flat Load Floor ...................... .249
Four-Way Hazard Flasher ...................727 Four Wheel Drive
........................ .522
Freeing A Stuck Vehicle .....................775
Front Axle (Differential) .....................827
Fuel .................................. .675
Adding ............................. .684
Additives ............................ .679
Clean Air ............................ .677
Ethanol .......................... .677, 681
Filler Cap (Gas Cap) .....................686
Gasoline ............................. .675
Light ............................... .314
Materials Added ....................... .679
Methanol ............................ .677
Octane Rating ..................... .675, 866
Requirements ...................... .675, 864
Tank Capacity ......................... .864
Fuel, Flexible ........................... .681
Fuses ................................. .841
902 INDEX