keyless entry Ram 4500 Chassis Cab 2018 User Guide

Driver Two Memory Position Recall
•To recall the memory setting for driver two using the
memory switch, push memory button (2) on the
memory switch.
• To recall the memory settings for driver two using the
key fob, push the unlock button on the key fob linked to
memory position 2.
A recall can be cancelled by pushing any of the memory
buttons during a recall (S, 1, or 2). When a recall is
cancelled, the driver’s seat and the power pedals (if
equipped) stop moving. A delay of one second will occur
before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver ’s seat positioning to
enhance driver mobility when entering and exiting the
vehicle.
The distance the driver ’s seat moves depends on where
you have the driver ’s seat positioned when you remove the
key fob from the ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-Go).
• When you remove the key fob from the ignition (or
change the ignition to OFF, for vehicles equipped with Keyless Enter-N-Go), the driver ’s seat will move about
2.4 inches (60 mm) rearward if the driver ’s seat position
is greater than or equal to 2.7 inches (67.7 mm) forward
of the rear stop. The seat will return to its previously set
position when you place the ignition into the ACC or
RUN position.
• When you remove the key fob from the ignition (or
change the ignition to OFF, for vehicles equipped with
Keyless Enter-N-Go), the driver ’s seat will move to a
position 0.3 inches (7.7 mm) forward of the rear stop if
the driver ’s seat position is between 0.9 inches and 2.7
inches (22.7 mm and 67.7 mm) forward of the rear stop.
The seat will return to its previously set position when
you place the ignition to the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when the
driver ’s seat position is less than 0.9 inches (22.7 mm)
forward of the rear stop. At this position, there is no
benefit to the driver by moving the seat for Easy Exit or
Easy Entry.
Each stored memory setting will have an associated Easy
Entry and Easy Exit position.
3
GETTING TO KNOW YOUR VEHICLE 51

•The pedals cannotbe adjusted when the vehicle is in
REVERSE or when the Speed Control System is on. The
following messages will appear on vehicles equipped
with an instrument cluster display if the pedals are
attempted to be adjusted when the system is locked out:
“Adjustable Pedal Disabled — Cruise Control Engaged”
or “Adjustable Pedal Disabled — Vehicle In Reverse”.
NOTE:
• Always adjust the pedals to a position that allows full
pedal travel.
• Further small adjustments may be necessary to find the
best possible seat/pedal position.
• For vehicles equipped with Driver Memory Seat, you
can use your remote keyless entry key fob or the
memory switch on the driver ’s door trim panel to return
the adjustable pedals to pre-programmed positions. Re-
fer to “Driver Memory Seat” in “Getting To Know Your
Vehicle” for further information.
WARNING!
Do not adjust the pedals while the vehicle is moving.
You could lose control and have an accident. Always
adjust the pedals while the vehicle is parked.
CAUTION!
Do not place any article under the adjustable pedals or
impede its ability to move, as it may cause damage to
the pedal controls. Pedal travel may become limited if
movement is stopped by an obstruction in the adjust-
able pedal’s path.
MIRRORS
Inside Day/Night Mirror — If Equipped
The mirror head can be adjusted up, down, left, and right
for various drivers. The mirror should be adjusted to center
on the view through the rear window.
Headlight glare from vehicles behind you can be reduced
by moving the small control under the mirror to the night
position (toward the rear of the vehicle). The mirror should
be adjusted while set in the day position (toward the
windshield).
60 GETTING TO KNOW YOUR VEHICLE

Battery Saver
To protect the life of your vehicle’s battery, load shedding
is provided for both the interior and exterior lights.
If the ignition is OFF and any door is left ajar for 10 minutes
or the dimmer control is rotated all the way up to the dome
on position for 10 minutes, the interior lights will automati-
cally turn off.
NOTE:Battery saver mode is canceled if the ignition is
ON.
If the headlights remain on while the ignition is cycled OFF,
the exterior lights will automatically turn off after eight
minutes. If the headlights are turned on and left on for
eight minutes while the ignition is OFF, the exterior lights
will automatically turn off.
INTERIOR LIGHTS
Courtesy Lights
Courtesy and dome lights are turned on when the front
doors are opened, when the dimmer control (rotating
wheel on the bottom of the switch) is rotated to the far right
detent position. If your vehicle is equipped with Remote
Keyless Entry, and the unlock button is pushed on the key
fob, the courtesy and dome lights will turn on.
Courtesy/Reading Lights
Both lights in the overhead console and rear passenger
compartment will illuminate as courtesy lights when a
door is opened, when the dimmer control is rotated to the
courtesy light position (full right position), or when the
unlock button is pushed on the Remote Keyless Entry key
fob, if equipped. These lights are also operated individu-
ally as reading lights by pushing on the corresponding
lens.
Front Courtesy/Reading Lights
76 GETTING TO KNOW YOUR VEHICLE

5. Push and hold the programmed HomeLink button. Theinstrument cluster display will display “CHANNEL #
TRANSMIT.” If the device is plugged in and activates,
programming is complete.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink Button
(Canadian/Gate Operator)
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
NOTE: For vehicle’s equipped with Keyless Enter-N-Go,
place the ignition in the RUN position with the Engine ON.
For vehicle’s equipped with Keyless Enter-N-Go, place the
ignition in the RUN position with the Engine ON. Make
sure while programming HomeLink with the engine ON
that your vehicle is outside of your garage, or that the
garage door remains open at all times.
2. Push and hold the desired HomeLink button until the instrument cluster display shows “CHANNEL #
TRAINING” Do not release the button. 3.
Without releasing the button proceed with “Canadian/
Gate Operator Programming” Step 2 and follow all
remaining steps.
Using HomeLink
To operate, push and release the programmed HomeLink
button. Activation will now occur for the programmed
device (i.e. garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.) The
hand-held transmitter of the device may also be used at
any time.
Security
It is advised to erase all channels before you sell or turn in
your vehicle.
To erase the channels press and hold the two outside
HomeLink buttons (I and III) for up 20 seconds. The
instrument cluster display will display “CLEARING
CHANNELS.” Release the buttons when the instrument
cluster display shows “CHANNELS CLEARED.”
The HomeLink Universal Transceiver is disabled when the
Vehicle Security Alarm is active.
108 GETTING TO KNOW YOUR VEHICLE

Jump Starting............................ .345
Key Fob Panic Alarm .............................22
Programming Additional Key Fobs ..........26, 33
Key Fob Battery Service (Remote Keyless Entry) .....23
Key Fob Programming (Remote Keyless Entry) ......26
Key-In Reminder ............................29
Keyless Enter-N-Go ..................... .37, 242
Lock The Vehicle’s Doors ................451, 472
Passive Entry ............................37
Passive Entry Programming ...........37, 451, 472
Key, Replacement ...........................33
Keys ....................................19
Key, Sentry (Immobilizer) ......................32
Lane Change And Turn Signals .................75
Lane Change Assist ..........................75
Latches ................................. .236
Hood ................................ .101
Lead Free Gasoline ........................ .429
Leaks, Fluid ............................. .236
Life Of Tires ............................. .408
Light Bulbs .............................. .236
Lights .................................. .236AirBag .........................150, 197, 234
Automatic Headlights
......................72
Brake Assist Warning ..................... .172
Brake Warning ......................... .150
Bulb Replacement ....................... .325
Cap Top Clearance ...................... .330
Cargo .................................75
Center Mounted Stop ..................... .328
Courtesy/Reading ..................... .76, 77
Cruise ............................... .159
Daytime Running .........................71
Engine Temperature Warning ................151
Exterior .............................. .236
Fog ........................... .74, 157, 328
Four-Wheel Drive Indicator .................260
Hazard Warning Flasher ...................320
Headlights ..............................69
High Beam ..............................71
High

Beam/Low Beam Select .................71
Hill Descent Control Indicator ...............174
Illuminated Entry .........................78
Interior ............................. .76, 77
Low Fuel ............................. .156
Malfunction Indicator (Check Engine) ..........153
Park ................................. .158
518 INDEX

Rearward........................... .46, 48
Recline .................................46
Tilt ................................ .46, 48
Up ................................ .46, 48
Power Steering Fluid ....................... .437
Pregnant Women And Seat Belts ................194
Programmable Electronic Features ...............144
PTO (Power Take-Off) ...................... .266
Radial Ply Tires ........................... .406
Radiator Cap (Coolant Pressure Cap) .........384, 386
Radio Frequency General Information ................26, 31, 33, 40
Radio Operation .......................... .486
Rain Sensitive Wiper System ...................80
Rear Axle (Differential) ...................392, 393
Rear ParkSense System ...................273, 280
Rear Seat, Folding ...........................43
Reclining Rear Seats .........................45
Recreational Towing .........................311
Shifting Into Transfer Case Neutral (N) .........313
Shifting Out Of Transfer Case Neutral (N) .......315
Reformulated Gasoline ...................... .430
Refrigerant .............................. .372
Release, Hood ............................ .101Reminder, Seat Belt
........................ .184
Remote Keyless Entry ........................21
Panic Alarm .............................22
Programming Additional Key Fobs ..........26, 33
Remote Sound System (Radio) Controls ...........484
Remote Starting Exit Remote Start Mode .....................31
Uconnect Customer Programmable Features . .454, 474
Uconnect Settings .....................454, 474
Replacement Keys ...........................33
Replacement Tires ......................... .409
Reporting Safety Defects .....................509
Restraint, Head .............................55
Restraints, Child .......................... .208
Rotation, Tires ............................ .416
Safety Checks Inside Vehicle ...................234
Safety Checks Outside Vehicle .................236
Safety
Defects, Reporting .....................509
Safety, Exhaust Gas ........................ .233
Safety Information, Tire ..................... .394
Safety Tips .............................. .233
Schedule, Maintenance ...................... .359
Seat Belt Adjustable Upper Shoulder Belt Anchorage ......190
12
INDEX 521