Signals, Turn............................ 15
Speedometer ............................ 16
Starting .............................. 8,34
Automatic Transmission ................ 34
Engine Block Heater ................. 35,49
Manual Transmission .................. 34
Remote ............................. 8
Starting Procedures ....................... 34
Starting Procedures (Diesel Engines) ........... 34
Steering Wheel Lock .......................... 8
Synthetic Engine Oil ...................... 104
System, Remote Starting .................... 8
Tachometer ............................. 15
Temperature Gauge, Engine Coolant ........... 15
Tip Start ............................... 34
Ti re s Pressure Warning Light ................. 21 Torque Converter Clutch
.................63,74
Tow/Haul ............................. 62
Traction Control ......................... 123
Traction Control Light ..................... 17
Transfer Case Fluid ............................. 136
Transmission Automatic ........................ 54,64
Fluid ............................. 136
Manual .......................... 34,75
Shifting ............................ 52
Trip Odometer ........................ 17,18
Turn Signals ............................ 15
Viscosity, Engine Oil ...................... 103
Voltmeter ............................ 18,41
Warning Lights (Instrument Cluster Description) . . 15
Water Separator, Diesel Fuel ................ 106
8
INDEX 169
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this vehi-
cle’s electronic system to provide immunity to radio frequency
signals. Mobile two-way radios and telephone equipment must
be installed properly by trained personnel. The following must
be observed during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The
negative power connection should be made to body sheet
metal adjacent to the negative battery connection. This con-
nection should not be fused.
Antennas for two-way radios should be mounted on the roof or
the rear area of the vehicle. Care should be used in mounting
antennas with magnet bases. Magnets may affect the accu-
racy or operation of the compass on vehicles so equipped.The antenna cable should be as short as practical and routed
away from the vehicle wiring when possible. Use only fully
shielded coaxial cable.
Carefully match the antenna and cable to the radio to ensure a
low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than nor-
mal may require special precautions.
All installations should be checked for possible interference
between the communications equipment and the vehicle’s
electronic systems.
