display Ram Cargo Van 2015 Owner's Guide

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS
INSTRUMENT PANEL FEATURES ..........286
 INSTRUMENT CLUSTER — BASE ..........287
 INSTRUMENT CLUSTER — PREMIUM .......288
 INSTRUMENT CLUSTER DESCRIPTIONS .....289
 ELECTRONIC VEHICLE INFORMATION
CENTER (EVIC) — IF EQUIPPED ...........303
▫ Electronic Vehicle Information Center (EVIC)
Displays ........................... .305
▫ EVIC White Telltale Lights ...............309
▫ EVIC Amber Telltale Lights ..............310▫
EVIC Red Telltale Lights ................310
▫ Oil Change Required ...................313
▫ Fuel Economy ....................... .314
▫ Vehicle Speed ....................... .315
▫ Trip Info .......................... .316
▫ TirePSI............................ .316
▫ Units ............................. .317
▫
Vehicle Info (Customer Information Features) . . .317
▫ Messages # ......................... .318
▫
Keyless Enter-N-Go™ Display — If Equipped. . . .318
4

▫Compass / Temperature Display ..........318
▫ Turn Menu Off ...................... .321
▫ Customer-Programmable Features
(System Setup) ...................... .321
 Uconnect® 730N/430/430N CD/DVD/
HDD/NAV — IF EQUIPPED ..............328
▫ Operating Instructions (Voice Command
System) — If Equipped .................328
▫ Operating Instructions (Uconnect® Phone) —
If Equipped ......................... .328
 Uconnect® 130 ....................... .329
▫ Operating Instructions — Radio Mode ......329
▫ Operation Instructions — CD MODE For
CD And MP3 Audio Play ...............332
▫ Notes On Playing MP3 Files .............334▫
Operation Instructions — Auxiliary Mode . . . .337
 Uconnect® 130 WITH SATELLITE RADIO .....338
▫ Operating Instructions — Radio Mode .......338
▫ Operation Instructions — CD MODE For
CD And MP3 Audio Play ................344
▫ Notes On Playing MP3 Files .............346
▫ LIST Button — CD Mode For MP3 Play ......349
▫ INFO Button — CD Mode For MP3 Play .....350
▫ Uconnect® (Satellite Radio) — If Equipped . . .350
▫ Operating Instructions (Uconnect® Phone) —
If Equipped ......................... .355

iPod®/USB/MP3 CONTROL — IF EQUIPPED . .355
▫ Connecting The iPod® Or External USB
Device ............................ .356
282 UNDERSTANDING YOUR INSTRUMENT PANEL

▫Replacing The Remote Control Batteries ......385
▫ Headphones Operation .................386
▫ Blu-ray™ Headphones Operation ..........387
▫ Controls ........................... .388
▫ Replacing The Headphone Batteries .........389
▫ Unwired® Stereo Headphone Lifetime
Limited Warranty .....................389
▫ System Information ....................390
▫ Shared Modes ....................... .390
▫ Information Mode Display ...............392
▫ Numeric Keypad Menu .................392
▫ Station List Menu .....................393
▫ Disc Menu ......................... .394▫
Display Settings ...................... .394
▫ Listening To Audio With The Screen Closed . . .395
▫ Disc Formats ........................ .395
▫ Display ............................ .401
▫ Product Agreement ....................406
 STEERING WHEEL AUDIO CONTROLS —
IF EQUIPPED ........................ .409
▫ Radio Operation ..................... .410
▫ CD Player .......................... .410
 CD/DVD/Blu-ray™ Disc MAINTENANCE . . . .411

RADIO OPERATION AND MOBILE PHONES . . .411
▫ General Information ...................412
 CLIMATE CONTROLS ...................412
284 UNDERSTANDING YOUR INSTRUMENT PANEL

6. Odometer Display/Electronic Vehicle Information
Center (EVIC) — If Equipped
Odometer Display / Trip Odometer DisplayThe odom-
eter display shows the total distance the vehicle has been
driven.
U.S. Federal regulations require that upon transfer of
vehicle ownership, the seller certify to the purchaser the
correct mileage that the vehicle has been driven. If your
odometer needs to be repaired or serviced, the repair
technician should leave the odometer reading the same
as it was before the repair or service. If s/he cannot do so,
then the odometer must be set at zero, and a sticker must
be placed in the door jamb stating what the mileage was
before the repair or service. It is a good idea for you to
make a record of the odometer reading before the repair/
service, so that you can be sure that it is properly reset, or
that the door jamb sticker is accurate if the odometer
must be reset at zero. This also displays Trip A and Trip B, DTE, MPG or
L/100km, OAT (Outside Air Temperature) information to
Base Cluster, use STEP and RESET button (on steering
wheel) to access or reset the display.
Message Display Area
When the appropriate conditions exist, the following
odometer messages will display:
door
............................. Door Ajar
gATE .......................... Liftgate Ajar
LoW tirE ....................LowTirePr essure
gASCAP ...................... Fuel Cap Fault
noFUSE .......................... Fuse Fault
CHAngE OIL ..............Oil Change Required
LoCOOL .......................Low Coolant
290 UNDERSTANDING YOUR INSTRUMENT PANEL

NOTE:Some of the above warnings will be displayed in
the Electronic Vehicle Information Center Display Area
located in the instrument cluster.
Refer to ”Electronic Vehicle Information Center (EVIC) —
If Equipped” in this section for further information.
LoW tirE
When the appropriate condition exists, the odometer dis-
play will toggle between LoW and tirE for three cycles.
gASCAP
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“gASCAP” message will display in the odometer display
area. Tighten the fuel filler cap properly and push the
STEP button on the steering wheel to turn off the
message. If the problem continues, the message will
appear the next time the vehicle is started. noFUSE
If the vehicle diagnostic system determines that the
Ignition Off Draw (IOD) fuse is improperly installed, or
damaged, a “noFUSE” message will display in the odom-
eter display area. For further information on fuses and
fuse locations, refer to “Fuses” in “Maintaining Your
Vehicle.”
CHAngE OIL
Your vehicle is equipped with an engine oil change
indicator system. The
CHAngE OILmessage will flash
in the instrument cluster odometer for approximately
12 seconds, after a single chime has sounded, to indicate
the next scheduled oil change interval. The engine oil
change indicator system is duty cycle-based, which
means the engine oil change interval may fluctuate
dependent upon your personal driving style.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 291

Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
position. To reset the oil change indicator system (after
performing the scheduled maintenance), perform the
following steps.
1. Turn the ignition switch to the ON/RUN position (do
not start the engine).
2. Fully push the accelerator pedal, slowly, three times
within 10 seconds.
3. Turn the ignition switch to the OFF position.
NOTE:If the indicator message illuminates when you
start the engine, the oil change indicator system did not
reset. If necessary, repeat these steps. Electronic Vehicle Information Center (EVIC) —
If Equipped
The Electronic Vehicle Information Center (EVIC) features
a driver-interactive display that is located in the instrument
cluster. For further information, refer to “Electronic Vehicle
Information Center (EVIC)” in this section.
7. Anti-Lock Brake (ABS) Light
This light monitors the Anti-Lock Brake System
(ABS). The light will turn on when the ignition
switch is turned to the ON/RUN position and
may stay on for as long as four seconds.
If the ABS light remains on or turns on while driving, it
indicates that the Anti-Lock portion of the brake system
is not functioning and that service is required. However,
the conventional brake system will continue to operate
normally if the BRAKE warning light is not on.
292 UNDERSTANDING YOUR INSTRUMENT PANEL

15. Air Bag Warning LightThis light will turn on for four to eight seconds
as a bulb check when the ignition switch is first
turned to ON/RUN. If the light is either not on
during starting, stays on, or turns on while
driving, have the system inspected at an authorized
dealer as soon as possible. Refer to “Occupant Restraints”
in “Things To Know Before Starting Your Vehicle” for
further information.
16. Shift Lever Indicator
The Shift Lever Indicator is self-contained within the
instrument cluster. It displays the gear position of the
automatic transmission. NOTE:
•You must apply the brakes before shifting from
PARK.
• The highest available transmission gear is displayed
in the lower right corner of the Electronic Vehicle
Information Center (EVIC) whenever the Electronic
Range Select (ERS) feature is active. Use the +/-
selector on the shift lever to activate ERS. Refer to
“Automatic Transmission” in “Starting And Operat-
ing” for further information.
17. Vehicle Security Light — If Equipped
This light will flash at a fast rate for approxi-
mately 15 seconds, when the vehicle security
alarm is arming, and then will flash slowly
until the vehicle is disarmed.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 297

CAUTION!
Continuous driving with the Transmission Tempera-
ture Warning Light illuminated will eventually cause
severe transmission damage or transmission failure.
WARNING!
If you continue operating the vehicle when the
Transmission Temperature Warning Light is illumi-
nated you could cause the fluid to boil over, come in
contact with hot engine or exhaust components and
cause a fire.
ELECTRONIC VEHICLE INFORMATION CENTER
(EVIC) — IF EQUIPPED
The Electronic Vehicle Information Center (EVIC) fea-
tures a driver-interactive display that is located in the
instrument cluster.
Electronic Vehicle Information Center (EVIC)
4
UNDERSTANDING YOUR INSTRUMENT PANEL 303

•DOWN Button
Push and release the DOWN button to scroll
downward through the main menu items.
• RIGHT Button
The RIGHT/SELECT button allows access to
information in EVIC submenus, selects some
feature settings, and resets some EVIC features.
The EVIC prompts the driver when the RIGHT
button can be used by displaying the right arrow graphic.
Once the RIGHT button has been selected for
the desired submenu list, follow the EVIC
prompts to properly select the desired sub-
menu EVIC features. •
BACK Button
Push and release the BACK button to scroll
back to a previous menu or sub-menu.
Electronic Vehicle Information Center (EVIC)
Displays
The EVIC display consists of three sections:
1. The top line where compass direction and outsidetemperature are displayed.
2. The main display area where the menus and pop up messages are displayed.
3. The reconfigurable telltales section below the odom- eter line.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 305

The main display area will normally display the main
menu or the screens of a selected feature of the main
menu. The main display area also displayspop up
messages that consist of approximately 60 possible warn-
ing or information messages. These pop up messages fall
into several categories:
• Five Second Stored Messages
When the appropriate conditions occur, this type of
message takes control of the main display area for five
seconds and then returns to the previous screen. Most of
the messages of this type are then stored (as long as the
condition that activated it remains active) and can be
reviewed from the Messagesmain menu item. As long
as there is a stored message, an iwill be displayed in the
EVIC’s compass/outside temp line. Examples of this
message type are Right Front Turn Signal Lamp Out
and Low Tire Pressure. •
Unstored Messages
This message type is displayed indefinitely or until the
condition that activated the message is cleared. Examples
of this message type are Turn Signal On(if a turn signal
is left on) and Lights On(if driver leaves the vehicle).
• Unstored Messages Until RUN
These messages deal primarily with the Remote Start
feature. This message type is displayed until the ignition
is in the RUN state. Examples of this message type are
Remote Start Aborted - Door Ajar andPress Brake
Pedal and Push Button to Start.
• Five Second Unstored Messages
When the appropriate conditions occur, this type of mes-
sage takes control of the main display area for five seconds
and then returns to the previous screen. Examples of this
message type are Memory System Unavailable - Not in
Park andAutomatic High Beams On. 
306 UNDERSTANDING YOUR INSTRUMENT PANEL