key battery RAM CHASSIS CAB 2011 User Guide

WARNING! (Continued)• Unintended movement of a vehicle could injure
those in and near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running. Before exiting a vehicle, you should
always shift the transmission into PARK, remove
the key fob from the ignition, and apply the
parking brake. Once the key fob is removed from
the ignition, the shift lever is locked in the PARK
position, securing the vehicle against unwanted
movement. Furthermore, you should never leave
unattended children inside a vehicle.
Key Ignition Park Interlock
This vehicle is equipped with a Key Ignition Park Inter-
lock which requires the shift lever to be placed in PARK
prior to rotating the ignition switch to the LOCK posi-
tion. The key fob can only be removed from the ignition switch when the ignition switch is in the LOCK position
and once removed the shift lever is locked in PARK.
Brake/Transmission Shift Interlock System
This vehicle is equipped with a Brake Transmission Shift
Interlock System (BTSI) that holds the shift lever in the
PARK position when the ignition switch is in the LOCK
position. To move the shift lever out of the PARK
position, the ignition switch must be turned to any other
ignition switch position (ACC, ON, or START) (engine
running or not) and the brake pedal must be pressed.
Brake/Transmission Interlock Manual Override
There is an override for the BTSI that allows you to move
the shift lever out of the PARK position if an electrical
system malfunction occurs (i.e., dead battery).
1. Turn the ignition switch to the ACC or ON position
without starting the engine.
2. Tilt the steering wheel to the full up position
5 STARTING AND OPERATING 267

the SELECT button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing. Normally, the OBD II system will be ready. The OBD II
system may not be ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:
1. Turn the ignition switch to the ON position, but do not
crank or start the engine.
2. If you crank or start the engine, you will have to start
this test over.
3. As soon as you turn the ignition switch to the ON
position, you will see the MIL symbol come on as part of
a normal bulb check.
7 MAINTAINING YOUR VEHICLE 379

VEHICLE STORAGE
If you are storing your vehicle for more than 21 days, we
recommend that you take the following steps to mini-
mize the drain on your vehicle’s battery:
• Disconnect the Ignition-Off Draw (IOD) fuse located in
the Integrated Power Module, located in the engine
compartment. The IOD cavity includes a snap-in re-
tainer that allows the fuse to be disconnected without
removing it from the fuse block.
• As an alternative to the above steps you may discon-
nect the negative cables from both batteries.
• Any time you store your vehicle or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again. NOTE:
• When reinstalling the IOD fuse push firmly until fully
seated; the gauges in the instrument cluster will do a
full sweep when the ignition switch is turned to the
RUN position. This is a normal condition.
• When the vehicle is shipped from the factory, the IOD
fuse is in the up or extracted position. If the radio,
interior lamps, keyless entry or other features do not
work with the key OFF, check the position of the fuse
(or check to see if the fuse is blown) to ensure that it is
fully seated. When the IOD fuse is extracted, the
instrument cluster in the odometer window will dis-
play  NO FUSE.”
REPLACEMENT BULBS
LIGHT BULBS – Interior Bulb No.
Overhead Console Lamps ............... TS 212-2
Dome Lamp ........................... 7679
7 MAINTAINING YOUR VEHICLE 415

Automatic Transmission
Adding Fluid ......................... 403
Fluid and Filter Changes ................. 404
Fluid Level Check ................... 402,403
Fluid Type ........................ 402,424
Shifting ............................. 268
Special Additives ...................... 404
Axle Fluid ....................... 400,401,424
Axle Lubrication (Axle Fluid) ............ 400,401
Battery ............................... 385
Keyless Transmitter Replacement (RKE) ....... 24
Saving Feature (Protection) ............... 144
Belts, Seat ............................ 38,73
Body Builders Guide ....................... 6
Body Mechanism Lubrication ............... 388
B-Pillar Location ........................ 300
Brake Fluid ......................... 398,424 Brake System ........................ 292,398
Anti-Lock (ABS) ....................... 292
Fluid Check .......................... 398
Master Cylinder ....................... 398
Parking ............................. 289
Warning Light ........................ 187
Brake/Transmission Interlock ............... 267
Bulb Replacement ....................... 416
Bulbs, Light .......................... 76,415
Cab Top Clearance Lights .................. 420
Calibration, Compass ..................... 204
Capacities, Antifreeze (Engine Coolant) ........ 422
Capacities, Fluid ........................ 422
Caps, Filler
Oil (Engine) .......................... 383
Power Steering ........................ 289
Radiator (Coolant Pressure) ............... 395
Car Washes ............................ 405
10 INDEX 455

Cooling System Tips .................... 340
Hitches ............................. 329
Minimum Requirements ................. 331
Mirrors .............................. 87
Trailer and Tongue Weight ............... 330
Wiring .............................. 338
Trailer Towing Guide ..................... 330
Trailer Weight .......................... 330
Transfer Case ........................... 401
Electronically Shifted ................... 278
Fluid ............................... 424
Transmission
Automatic ........................ 268,402
Fluid ............................... 424
Maintenance ......................... 402
Shifting ............................. 266
Transmitter Battery Service
(Remote Keyless Entry) .................... 24 Transmitter Programming
(Remote Keyless Entry) .................... 20
Transmitter, Remote Keyless Entry (RKE) ........ 20
Tread Wear Indicators .................... 310
Trip Odometer .......................... 182
Turn Signals ...................... 145,179,416
UCI Connector ......................... 235
Uconnect™ (Hands-Free Phone) .............. 88
Uniform Tire Quality Grades ................ 451
Universal Consumer Interface (UCI) Connector . . . 235
Variance, Compass ....................... 204
Vehicle Identification Number (VIN) ............ 6
Vehicle Loading ...................... 301,324
Vehicle Modifications/Alterations .............. 7
Vehicle Storage ....................... 257,415
Voice Recognition System (VR) .............. 118
Voltmeter ............................. 186
10 INDEX 469