display RAM CHASSIS CAB 2016 Owners Manual

WARNING! (Continued)• Do not leave the Key Fob in or near the vehicle, or
in a location accessible to children, and do not
leave the ignition of a vehicle equipped with
Keyless Enter-N-Go in the ACC or ON/RUN mode.
A child could operate power windows, other con-
trols, or move the vehicle.
• Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up may
cause serious injury or death.
CAUTION!An unlocked vehicle is an invitation. Always remove
the key from the ignition and lock all doors when
leaving the vehicle unattended. Key-In-Ignition Reminder
Opening the driver’s door when the Key Fob is in the
ignition and the ignition switch position is OFF or ACC,
a chime will sound to remind you to remove the Key Fob.
NOTE:
•  Keyed  Ignition systems will chime in OFF or ACC
when the driver door is open.
• “Keyless  Ignition systems will chime in ACC or RUN
when the driver door is open.
• If equipped with Electronic Vehicle Information Center
(EVIC)/Driver Information Display (DID), the EVIC or
DID will display “Key In Ignition.”18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

“Dome ON” position (rotate horizontal thumb wheel on
the bottom of the switch to the far right detent position).
The illuminated entry system will not operate if the
dimmer control is in the “Dome OFF” position (rotate
horizontal thumb wheel on the bottom of the switch to
the far left detent position).
NOTE: If your vehicle is equipped with illuminated
approach lights under the outside mirrors, they can be
turned off by using the Electronic Vehicle Information
Center (EVIC) or Driver Information Display (DID) con-
trols (if NOT equipped with a touchscreen radio) or the
Uconnect radio (if equipped with a touchscreen radio).
Refer to “Electronic Vehicle Information Center (EVIC),”
“Driver Information Display (DID),” or “Uconnect Set-
tings” in “Understanding Your Instrument Panel” for
further information. REMOTE KEYLESS ENTRY (RKE)
The RKE system allows you to lock or unlock all doors,
tailgate, and the RamBox (if equipped) as well as activate
the Panic Alarm from distances up to approximately 66 ft
(20 m) using a hand-held radio transmitter with inte-
grated key. The transmitter does not need to be pointed at
the vehicle to activate the system. Push and release the
LOCK button on the RKE transmitter to lock all doors,
the tailgate and the RamBox (if equipped). The turn
signal lights will flash and the horn will chirp to ac-
knowledge the signal.
NOTE: Inserting the Key Fob with RKE transmitter into
the ignition switch disables the system from responding
to any button pushes from that RKE transmitter. Driving
at speeds 5 mph (8 km/h) and above disables the system
from responding to all RKE transmitter buttons for all
RKE transmitters. 2THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25

Remote Start Abort Message
The following messages will display in the EVIC/DID if
the vehicle fails to remote start or exits remote start
prematurely:
• Remote Start Cancelled — Door Open
• Remote Start Cancelled — Hood Open
• Remote Start Cancelled — Fuel Low
• Remote Start Cancelled — System Fault
• Remote Start Disabled — Start Vehicle to Reset
The EVIC/DID message stays active until the ignition is
turned to the ON/RUN position.
To Enter Remote Start Mode
Push and release the REMOTE START button on the
RKE transmitter twice within five seconds. The park-
ing lights will flash, vehicle doors will lock, and the horn will chirp twice (if programmed). Once the
vehicle has started, the engine will run for 15 minutes.
NOTE:
• If your power door locks were unlocked, Remote Start
will automatically lock the doors.
• If an engine fault is present or fuel level is low, the
vehicle will start and then shut down in 10 seconds.
• The park lamps will turn on and remain on during
Remote Start mode.
• For security, power window and power sunroof op-
eration (if equipped) are disabled when the vehicle is
in the Remote Start mode.
• The engine can be started two consecutive times (two
15-minute cycles) with the RKE transmitter. However, 2THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 35

UNDERSTANDING THE FEATURES OF YOUR VEHICLE CONTENTS  MIRRORS ........................... .128
▫ Inside Day/Night Mirror — If Equipped . . . .128
▫ Automatic Dimming Mirror — If Equipped . . .129
▫ Automatic Dimming Mirror With Rear View
Camera Display — If Equipped .......... .136
▫ Outside Mirrors ..................... .136
▫ Outside Mirrors Folding Feature .......... .137
▫ Power Mirrors — If Equipped ........... .138
▫ Heated Mirrors — If Equipped .......... .140
▫ Illuminated Vanity Mirror — If Equipped . . . .140 ▫ “Slide-On-Rod” Features Of Sun Visor — If
Equipped .......................... .140
▫ Trailer Towing Mirrors — If Equipped ..... .141
 SEATS ............................. .142
▫ Driver’s Power Seat — If Equipped ....... .143
▫ Passenger ’s Power Seat — If Equipped ..... .145
▫ Power Lumbar — If Equipped ........... .146
▫ Heated Seats — If Equipped ............ .146
▫ Ventilated Seats — If Equipped ........... .149
▫ Manual Seat Adjuster — If Equipped ...... .1503

▫ Flash-To-Pass ....................... .174
▫ High/Low Beam Switch ............... .174
 WINDSHIELD WIPERS AND WASHERS ..... .174
▫ Windshield Wipers ................... .174
▫ Windshield Wiper Operation ............ .175
▫ Intermittent Wiper System .............. .175
▫ Windshield Washers .................. .175
▫ Mist Feature ........................ .176
▫ Rain Sensing Wipers — If Equipped ....... .177
 TILT STEERING COLUMN .............. .178
 DRIVER ADJUSTABLE PEDALS — IF
EQUIPPED .......................... .179
 HEATED STEERING WHEEL — IF EQUIPPED .181  ELECTRONIC SPEED CONTROL .......... .182
▫ To Activate ......................... .183
▫ To Set A Desired Speed ................ .184
▫ To Deactivate ....................... .184
▫ To Resume Speed .................... .184
▫ To Vary The Speed Setting .............. .184
▫ To Accelerate For Passing .............. .186
 PARKSENSE REAR PARK ASSIST — IF
EQUIPPED .......................... .187
▫ ParkSense Sensors .................... .187
▫ ParkSense Warning Display ............. .188
▫ ParkSense Display .................... .188
▫ Enabling And Disabling ParkSense ........ .1923UNDERSTANDING THE FEATURES OF YOUR VEHICLE 125

▫ Service The ParkSense Rear Park Assist
System ............................ .193
▫ Cleaning The ParkSense System .......... .194
▫ ParkSense System Usage Precautions ....... .194
 PARKSENSE FRONT AND REAR PARK ASSIST —
IF EQUIPPED ........................ .196
▫ ParkSense Sensors .................... .197
▫ ParkSense Warning Display ............. .197
▫ ParkSense Display .................... .198
▫ Enabling And Disabling Front And/Or Rear
ParkSense .......................... .200
▫ Service The ParkSense Park Assist System . . . .201
▫ Cleaning The ParkSense System .......... .202
▫ ParkSense System Usage Precautions ....... .202  PARKVIEW REAR BACK UP CAMERA — IF
EQUIPPED .......................... .205
 OVERHEAD CONSOLE — IF EQUIPPED .... .208
▫ Courtesy/Reading Lights .............. .208
 ELECTRICAL POWER OUTLETS .......... .210
 AUXILIARY SWITCHES — IF EQUIPPED .... .215
 CIGAR LIGHTER AND ASH RECEIVER — IF
EQUIPPED .......................... .215
 POWER INVERTER — IF EQUIPPED ....... .216
 CUPHOLDERS ....................... .217
▫ Front Seat Cupholders (40–20–40 Seats) ..... .217
▫ Front Instrument Panel Cupholders — Floor
Storage Bin ......................... .217
▫ Rear Cupholders — If Equipped .......... .218126 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING! (Continued)electrical equipment to the vehicle’s electrical sys-
tem. This may prevent your vehicle from sending a
signal to initiate an emergency call. To avoid inter-
ference that can cause the 9-1-1 Call system to fail,
never add aftermarket equipment (e.g., two-way
mobile radio, CB radio, data recorder, etc.) to your
vehicle’s electrical system or modify the antennas
on your vehicle. IF YOUR VEHICLE LOSES BAT-
TERY POWER FOR ANY REASON (INCLUDING
DURING OR AFTER AN ACCIDENT), THE
UCONNECT FEATURES, APPS AND SERVICES,
AMONG OTHERS, WILL NOT OPERATE.
• Modifications to any part of the 9-1-1 Call system
could cause the air bag system to fail when you
need it. You could be injured if the air bag system
is not there to help protect you. 9-1-1 Call System Limitations
Vehicles sold in Canada and Mexico DO NOT have 9-1-1
Call system capabilities.
9-1-1 or other emergency line operators in Canada and
Mexico may not answer or respond to 9-1-1 system calls.
If the 9-1-1 Call system detects a malfunction, any of the
following may occur at the time the malfunction is
detected, and at the beginning of each ignition cycle:
• The Rearview Mirror light located between the ASSIST
and 9-1-1 buttons will continuously be illuminated
red.
• The Device Screen will display the following message
“Vehicle device requires service. Please contact your
dealer.”
• An In-Vehicle Audio message will state “Vehicle de-
vice requires service. Please contact your dealer.” 3UNDERSTANDING THE FEATURES OF YOUR VEHICLE 133

Automatic Dimming Mirror With Rear View
Camera Display — If Equipped
A single ball joint mirror is provided in the vehicle. It is
a twist on mirror that has a fixed position at the wind-
shield. The mirror installs on the windshield button with
a counterclockwise rotation and requires no tools for
mounting. The mirror head can be adjusted up, down,
left, and right for various drivers. The mirror should be
adjusted to center on the view through the rear window.
This mirror automatically adjusts for headlight glare
from vehicles behind you.
When the vehicle is placed into reverse gear a video
display illuminates to display the image generated by the
rear view camera. The auto dimming feature is also
disabled to improve rear view viewing. Outside Mirrors
To receive maximum benefit, adjust the outside mirrors
to center on the adjacent lane of traffic with a slight
overlap of the view obtained on the inside mirror. Automatic Dimming Mirror With Rear View Camera136 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!• Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes,
spinal cord injury, medication, alcohol use, exhaus-
tion or other physical condition must exercise care
when using the seat heater. It may cause burns
even at low temperatures, especially if used for
long periods of time.
• Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cushion.
This may cause the seat heater to overheat. Sitting
in a seat that has been overheated could cause
serious burns due to the increased surface tempera-
ture of the seat.
Front Heated Seats
The front heated seats control buttons are located within
the climate or controls screen of the touchscreen. • Press the heated seat button
once to turn the HI
setting On.
• Press the heated seat button a second time to turn
the LO setting On.
• Press the heated seat button a third time to turn
the heating elements OFF.
If the HI-level setting is selected, the system will auto-
matically switch to LO-level after approximately 60 min-
utes of continuous operation. At that time, the display
will change from HI to LO, indicating the change. The
LO-level setting will turn OFF automatically after ap-
proximately 45 minutes.
NOTE: The engine must be running for the heated seats
to operate. 3UNDERSTANDING THE FEATURES OF YOUR VEHICLE 147

2. Adjust all memory profile settings to desired prefer-
ences (seat, side mirrors, adjustable pedals and radio
station presets).
3. Push and release the S (Set) button on the memory
switch.
4. Within five seconds, push and release either of the
memory buttons (1) or (2). The Electronic Vehicle
Information Center (EVIC) or Driver Information Dis-
play (DID) will display which memory position has
been set.
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• To set a memory profile to your RKE transmitter, refer
to “Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory” in this section. Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory
Your RKE transmitters can be programmed to recall one
of two pre-programmed memory profiles by pushing the
UNLOCK button on the RKE transmitter.
NOTE: Before programming your RKE transmitters to
memory the feature has to be selected.
• If your vehicle is equipped with a touchscreen, you
must select the “Memory To FOB” feature through the
Uconnect system. Refer to “Uconnect Settings ” in
“Understanding Your Instrument Panel” for further
information.
• If your vehicle is not equipped with a touchscreen, you
must select the “Key Fob Linked To Memory” feature
through the Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID). Refer to
“Electronic Vehicle Information Center (EVIC)” or 3UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157