wheel Ram ProMaster 2016 Workshop Manual

Ram ProMaster 2016 Workshop Manual ProMaster 2016 Ram Ram https://www.carmanualsonline.info/img/34/12509/w960_12509-0.png Ram ProMaster 2016 Workshop Manual

Page 318 of 448

Ram ProMaster 2016 Workshop Manual WARNING!
•Do not attempt to seal a tire on the side of the
vehicle closest to traffic. Pull far enough off the
road to avoid the danger of being hit when using
the Tire Service Kit.
• Do not use T

Page 319 of 448

Ram ProMaster 2016 Workshop Manual WARNING!(Continued)
•Tire Service Kit Sealant solution contains latex. In
case of an allergic reaction or rash, consult a phy-
sician immediately. Keep Tire Service Kit out of
reach of children. If

Page 325 of 448

Ram ProMaster 2016 Workshop Manual JACKING AND TIRE CHANGING
WARNING!
•Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating t

Page 327 of 448

Ram ProMaster 2016 Workshop Manual The winch mechanism is located under the rear of the
vehicle to the right of the spare tire.
2. Rotate the wheel wrench handle counterclockwiseuntil the spare tire is on the ground with enough cable
s

Page 329 of 448

Ram ProMaster 2016 Workshop Manual 4. Remove the retainer nut prior to removing the retainerfrom the wheel. 5. Lift the spare tire with one hand to give clearance to
tilt the retainer at the end of the cable.
Retainer NutLifting Spare

Page 330 of 448

Ram ProMaster 2016 Workshop Manual 6. Pull the retainer through the center of the wheel.
Preparations
1. Park the vehicle on a firm, level surface. Avoid ice orslippery areas.
WARNING!
Do not attempt to change a tire on the side of the

Page 331 of 448

Ram ProMaster 2016 Workshop Manual NOTE:Passengers should not remain in the vehicle
when the vehicle is being jacked.
Jacking Instructions
WARNING!
Carefully follow these tire changing warnings to
help prevent personal injury or damage

Page 332 of 448

Ram ProMaster 2016 Workshop Manual CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in the Jacking
Instructions for this vehicle.1. Loosen (but do not remove) the wheel lug bolts by
turnin

Page 335 of 448

Ram ProMaster 2016 Workshop Manual WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It could slip off the jack and
hurt someone near it. Raise the vehicle only enough
to remove the tire.
5. Remove th

Page 336 of 448

Ram ProMaster 2016 Workshop Manual WARNING!
To avoid the risk of forcing the vehicle off the jack,
do not tighten the wheel nuts fully until the vehicle
has been lowered. Failure to follow this warning may
result in personal injury.
NO