wiring diagram RENAULT CLIO 1997 X57 / 1.G Petrol Engines Workshop Manual

ENGINE AND PERIPHERALS
En
gine repair10
- the distributor with the wiring loom,
- the fuel pump (if fitted) with new seals,
- the thermostat support, making it tight with
Loctite 518.
The bead (H) should be
0.6 to 1 mm wide and
should be applied as shown in the diagram be-
low,
- the seal, using mounting bush
Mot. 1127-01;
this tool is designed to obtain an offset seat fo
r
the seal,
92102S92066R
Lubricate the camshaft.
Refit the camshaft and its flange.
Check:
- the end play which should be between
0.06 and
0.015 mm; if this is not the case, the flange o
r
the camshaft are to blame,
92102-1R
- the camshaft sprocket, immobilising it with tool
Mot. 799-01, and tighten the bolt to a torque
value of
4.5 daN.m (lubricate the thread an
d
underneath the bolt head).
10-33
Page 1 of 1 E_Series_35
04.08.2003 http://jester.com.ua/renault/motors/e/E_Series/css/E_Series_35.htm