transmission RENAULT CLIO CUP 2013 X85 / 3.G User Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2013, Model line: CLIO CUP, Model: RENAULT CLIO CUP 2013 X85 / 3.GPages: 35, PDF Size: 2.68 MB
Page 16 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-16
B.6.3.1.5 D
IAGNOSTIC PAGE 2 : GEARBOX DIAGNOSTIC
(see also chapter D -Transmissions)
Areas “Events”, “Default” and “rain light”, remains the same as DRIVERS PAGE.
Gearbox
parameters Signification
Values expected
when engine is
OFF
Values expected when Engine is
running
RPM Engine revs 0 - Idle > 1200rpm
- WaterT<50°c : RPM limiter = 4500rpm
- 50°c
- WaterT > 100°c,
Barrel (V)
Gearbox barrel
potentiometer voltage 1st gear :
1.60 V+/-10mv +0.5v / gear in upshift phase
-0.5V / gear in downshift phase
Gear Gear ratio
engaged R N 1 2 3 4 5 6 R N 1 2 3 4 5 6
Up SW UPshift paddle
ON : paddle pressed
OFF : rest ON : paddle pressed
OFF : rest
Down SW DOWNshift
paddle ON : paddle pressed
OFF : rest ON : paddle pressed
OFF : rest
Gear SW Gearbox barrel
unlocking solenoid. ON : “GEAR” button
pressed
OFF : rest ON : “GEAR” button pressed
OFF : rest
Up Cont Upshift contactor OFF : during downshift
and at rest
ON : during upshift OFF : during downshift and at rest
ON : during upshift
FL WSP (kph) Front left wheel
speed 0 >0 when a gear is engaged
FR WSP (kph)
Front right wheel
speed 0 >0 when a gear is engaged
NOTE 1:
The complete gearbox strategies (manual mode or sem
i-auto mode) is described in
Chapter D-transmission/shifting
NOTE 2 :
When an alarm appears in the area “default”, the co rresponding value by default is
displayed in blue, red or orange.
Page 23 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-23
B.6.4.3 Turning off the engine
Flick the “IGNITION” switch to the down (OFF) posit ion
NOTE : The vehicle’s electrics remain switched on
Except in the event of an emergency stop, it’s stri ctly not advised to turn off the
engine using the power supply switch (OFF button).
It is also recommended to wait 30seconds between sw itching off the engine and
switching off the power supply.
Respecting these two recommendations will guarantee optimum operation of the power
steering.
B.6.4.4 Switching off the power supply
Press the “OFF” button of the facia switch panel an d hold there for at least half a second.
The dashboard display is switched off.
NOTE: Switching off the power supply also switches off th e engine.
B.6.4.5 Changing gears
2 modes are possible and are completely independent . It’s possible to make randomly
upshift and downshift manually (using the lever) or in semi-auto using paddle shift kit.
Please refer to Chapter D-Transmission/shifting for a complete description of the shifting
modes.
B.6.4.6 Pit limiter
The purpose of this function is to limit the vehicl e's speed to 60kph
. It is enabled and
disabled by the driver.
Principle:
By pressing the button “PIT” of the steering wheel, Engine revs are thus limited (by the
ECU) to those corresponding to a speed of 60kph and the message “PIT LIMITER” is
displayed on the dashboard in the RPM Area :
Page 35 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-35
B.9.2 REPLACEMENT OF MECHANICAL COMPONENTS
The mileage of the below parts must be monitored by the user throughout the vehicle’s
lifetime.
The mileage stated in the table below is the maximu m expected mileage before
replacement, notwithstanding any incidents or accid ents.
Should any component become faulty or its condition deteriorate before reaching the
stated mileage, please contact Renault Sport Techno logies.
NOTE :
This list may not under any circumstances be cons idered to be part of the
manufacturer’s warranty.
Parts Recommanded milage
Front axle
Point E and Point F ball joint 5000 km
Wishbone ball joints 3000 km
Wheel bearing 5000 km
Shock absorbers + Bump stop 5000 km
Support strut 10000 km
Anti-roll ball joint 7000 km
Wheel stud and nut 5000 km
Rear Axle
Point F ball joint 7000 km
Point E ball joint 7000 km
Point A ball joint 7000 km
Wheel bearing 5000 km
Shock absorbers + Bump stop 5000 km
Wheel stud and nut 5000 km
Steering
Power steering module 15000 km
Steering rack 7500 km
Steering rod ball joint (point H) 7000 km
Rack ball joint 7000 km
Transmission
Gearbox 7500 km
Clutch friction 4500 km
Clutch mecanism 4500 km
Slave cylinder bearing 5000 km
Driveshafts 5000 km
Engine
Engine / Turbo / HP pump / WG / pop off 10000 km
Starter / alternator 10000 km
Engine + Gearbox mountings 10000 km
Motorised Throttle 6000 km
Gas Pedal potentiometer 10000 km
Brakes
Front brake disc 1500 km
Front brake caliper 6000 km
Rear brake disc 8000 km
Rear brake calliper 8000 km
NOTE:
Particular attention must be paid to the state of t he fasteners after any work has
been carried out.