engine overheat RENAULT KANGOO 2016 X61 / 2.G Owners Manual

JauneNoirNoir texte
1.45
ENG_UD7264_1
Tableau de bord : témoins lumineux (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
ûSTOP light
This goes out as soon as the engine
starts. It lights up in conjunction with
other warning lights.
It requires you to stop immediately, for
your own safety, as soon as traffic con-
ditions allow. Switch off the engine and
do not restart it.
Contact an approved Dealer.
øSER vICE warning light
This comes on when the igni-
tion is switched on and goes out after
3 seconds.
It may comes on in conjunction with
other warning lights on the instrument
panel.
It means you should drive very care-
fully to an approved Dealer as soon as
possible. You risk damaging your vehi-
cle if you keep driving after this warning
light has come on.
INSTRUMENT PANEL: warning lights (4/4)
The presence and operation of the warning lights DEPEND ON THE EQUIPMENT\
AND COUNTRY.
A
ÆSerious injection fault warn-
ing light/Coolant tempera-
ture warning light
Warning light for serious injection
fault
If this light flashes when you are driv-
ing, it indicates a fault in the injection
system. Stop immediately, switch off
the ignition and contact an approved
Dealer.
Coolant temperature warning light
If this light comes on (continuously
lit) when you are driving, it indicates
engine overheating. Stop and allow
the engine to run at idle speed for a
minute or two. The temperature should
drop. If not, stop the engine. Let the
engine cool down, then check the cool-
ant level. Contact an approved Dealer
if necessary
ÐNot used
ENot used
VNot used
ùNot used
HNot used
ïNot used
ÑNot used

special features of petrol vehicles ........ (up to the end of the DU)
driving ................................................... (up to the end of the DU)
catalytic converter................................. (up to the end of the DU)
2.4
ENG_UD10826_1
Particularités des versions essence (X95 - J95 - R95 - Renault)
ENG_NU_854-2_X76LL_Renault_2
Special features of petrol versions
SPEcIAl fEA tURES of PEtRol vERSIoNS
Do not park the vehicle or
run the engine in locations
where combustible sub-
stances or materials such as
grass or leaves can come into con-
tact with the hot exhaust system.
The following operating conditions
should be avoided:
–
driving for long periods when the low
fuel level warning light is lit;
–

using leaded petrol;
– using fuel or lubrication additives
which are not approved.
Or operating faults such as:
–
faulty ignition, running out of fuel or
disconnected spark plugs resulting
in the engine misfiring or cutting out
when driving;
–

loss of power,
may cause the catalytic converter to
overheat, reducing its efficiency which
may irreparably damage it and cause
heat damage to the vehicle. If you notice any of the above operating
faults, have the necessary repairs car-
ried out as soon as possible by an ap-
proved dealer.
These faults may be avoided by regu-
larly taking your vehicle to an approved
Dealer at the intervals specified in the
Maintenance Service Booklet.
Starting problems
To avoid damaging the catalytic con-
verter,
do not keep trying to start the
engine (using the start button, or by
pushing or towing the vehicle) without
having identified and corrected the
cause of the fault.
If the fault cannot be identified, do not
continue to try and start the engine, but
contact an approved dealer.

JauneNoirNoir texte
5.35
ENG_UD7332_1
Anomalies de fonctionnement (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_5
OPErA ting FAults (3/4)
On the road POssiBlE cAusEsWhAt tO DO
Steering becomes heavy. Assistance overheating.Consult an approved Dealer.
The engine overheats. The coolant
temperature indicator and the STOP
warning light come on. Engine cooling fan not working. Stop the vehicle, switch off the engine and
contact an approved Dealer.
Coolant leaks. Check the coolant reservoir: it should con-
tain fluid. If there is no coolant, consult an
approved Dealer as soon as possible.
radiator: If there is a lack of coolant, remember that it must never be topped up using cold coolant while the engine is
very warm. After any procedure on the vehicle which has involved even partial draining of the cooling system, it must
be refilled with a new mixture prepared in the correct proportions. Reminder: only products approved by our Technical
Department may be used for this purpose.