low beam RENAULT KANGOO ZERO EMISSION 2012 X61 / 2.G Owners Manual

display .................................................. (up to the end of the DU)
warning lights ........................................ (up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
driver’s position .................................... (up to the end of the DU)
trip computer and warning system ........(up to the end of the DU)
indicators: instrument panel ............................. (up to the end of the DU)
operating faults ..................................... (up to the end of the DU)
lights: fog lights .......................................................... (current page)
lights: dipped beam headlights ................................... (current page)
lights: direction indicators ........................................... (current page)
lights: main beam headlights ...................................... (current page)
1.60
ENG_UD26204_4
Témoins lumineux (X61 électrique - Renault)
ENG_NU_911-4_F61e_Renault_1
Jaune NoirNoir texte
Ú12v battery charge warning
light
If it comes on when you are driving, it
indicates that the circuit is overcharged
or has discharged. Stop and consult an
approved Dealer as soon as possible.
Warning lights
instrument panel A
In some cases, the appearance of a
warning light is accompanied by a mes-
sage.
WArNiNg lightS (1/3)
If no lights or sounds are apparent, this indicates a fault in the instrument
panel. This indicates that it is essential to stop immediately (as soon as
traffic conditions allow). Ensure that the vehicle is correctly immobilised
and contact an approved Dealer.
A
Warning light ® re-
quires you to stop immedi -
ately, for your own safety,
as soon as traffic conditions allow.
Switch off the engine and do not re-
start it. Contact an approved Dealer.
the presence and operation of the warning lights DePeND ON the eQUiPmeNt AND cOUNtr Y.
The © warning light means
you should drive very carefully to
an approved Dealer as soon as pos-
sible. If you fail to follow this recom-
mendation, you risk damaging your
vehicle.
ámain beam headlight tell-tale
light
kDipped beam headlight tell -
tale
gFront fog light tell-tale light
frear fog light tell-tale
cleft-hand direction indicator
tell-tale light
br ight-hand direction indica -
tor tell-tale light
v ehicle ready for driving
warning light
This comes on when the engine is
started.
c harging cord plugged in
warning light
This comes on when the charging cord
is plugged into the vehicle.

headlight beam adjustment .................. (up to the end of the DU)
lights adjustment ...................................... (up to the end of the DU)
1.82
ENG_UD19080_1
Réglage électrique de la hauteur des faisceaux (X61 - F61 - Renau\
lt)
ENG_NU_911-4_F61e_Renault_1
Electric beam height adjustment
electricAl ADJUStmeNt OF the DiPPeD BeAm heADlightS
Control knob 1 is used to adjust the
height of the headlight beams accord -
ing to the load.
Turn control knob 1 downwards to
lower the headlights and upwards to
raise them.
Unladen, control knob 1 should be at 0.
When the vehicle is partially or com -
pletely laden, the headlight beam
should be set to light the road at be -
tween 50 and 100 metres. Then use
positions 1 to 4 on the control knob.
AB
100 m 50 m
A Poor adjustment: the lights are set
too high and could dazzle other
drivers. Turn the control knob
downwards to lower the beam.
B Good adjustment: the beam’s
maximum range is between 50
and 100 metres.
1