wheel RENAULT KOLEOS 2015 1.G Owner's Guide

JauneNoir Noir texte
178
ENG_UD21005_5
Changement de roue (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
Attach the wheelbrace 1 and the jack
handle 6 (in groove 5).
Turn the wheelbrace until the wheel lifts
off the ground.
CHANGING A WHEEL (1/2)
Vehicles equipped with
jack, wheelbrace and wheel
wrench
Use the wheelbrace 1 to slacken off
the wheel bolts. Fit it so that you press
downwards rather than pulling up-
wards.
Start cranking up jack 4 by hand to
align the base plate (which should sit
flat against the ground) and until the
jack head 3 is in the centre of mark 2.
1
2
3
4
5
6
1
Switch on the hazard warn-
ing lights.
Keep the vehicle away from
traffic and on a level sur-
face where it will not slip (if neces-
sary, place a solid support under the
jack base).
Apply the parking brake and engage
a gear (first or reverse, or P for auto-
matic transmissions).
Ask all the passengers to leave the
vehicle and keep them away from
traffic.
To prevent any risk of injury
or damage to the vehi-
cle, raise the jack until the
wheel you are replacing is
a maximum of 3 centimetres off the
ground.
If the vehicle is not equipped with a
jack, wheelbrace or wheel wrench,
these can be obtained from an ap-
proved dealer.

JauneNoir Noir texte
179
ENG_UD21005_5
Changement de roue (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
Undo the bolts and take off the wheel.
Fit the emergency spare wheel on the
central hub and turn it to locate the
mounting holes in the wheel and the
hub.
If bolts are supplied with the emergency
spare wheel, only use these bolts for
the emergency spare wheel. Tighten
the bolts, checking that the wheel is
correctly positioned on its hub and
lower the jack.
With the wheel on the ground, tighten
the screws as fully as possible and
check the tightness as soon as possi-
ble (tightening torque 108 N.m).
If you have a puncture, re-
place the wheel as soon as
possible.
A tyre which has been punc-
tured should always be inspected
(and repaired, where possible) by a
specialist.
Anti-theft bolt
If you use anti-theft bolts, fit these
nearest the valve (wheel embel-
lisher may not be able to fit).
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
CHANGING A WHEEL (2/2)

JauneNoir Noir texte
180
ENG_UD21006_4
Pneumatiques (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
TYRES (1/3)
Maintaining the tyres
The tyres must be in good condition
and the tread form must have sufficient
depth; tyres approved by our techni-
cal department have tread wear indica-
tors 1 which are indicators moulded
into the tread at several points.
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essen-
tial to keep them in good condition.
You must make sure that your tyres
conform to local road traffic regulations.When the tyre tread has been worn to
the level of the wear indicators, they
become visible 2: it is then neces-
sary to replace your tyres because the
tread rubber is 1.6 mm deep at most,
resulting in poor roadholding on wet
roads.
An overloaded vehicle, long journeys
by motorway, particularly in very hot
weather, or continual driving on poorly
surfaced minor roads will lead to more
rapid tyre wear and affect safety.
When they need to be re-
placed, only tyres of the
same make, size, type and
profile should be used.
Tyres fitted to the vehicle should
either be identical to those fitted
originally or conform to those
recommended by your approved
dealer.
Incidents which occur when
driving, such as striking the
kerb, may damage the tyres
and wheel rims, and could
also lead to misalignment of the
front or rear axle geometry. In this
case, have the condition of these
checked by an approved dealer.
1
2

JauneNoir Noir texte
181
ENG_UD21006_4
Pneumatiques (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
Emergency spare wheel
Refer to the information on the
“Emergency spare wheel” and in-
structions on “Changing a wheel” in
Section 5.
Changing wheels around
Vehicles fitted with the
tyre pressure monitors
The tyre pressure moni-
tor takes around 8 min-
utes to identify that tyres have been
swapped or replaced. The system
will not operate during this time.
While the tyre pressure monitor is
identifying the tyres which have
been replaced, the information sent
by the system may be inaccurate
and this could have serious conse-
quences.
TYRES (2/3)
Tyre pressures
Adhere to the tyre pressures (including
the emergency spare wheel). The tyre
pressures should be checked at least
once a month and additionally before
any long journey (refer to the label af-
fixed to the edge of the driver’s door).
Incorrect tyre pressures
lead to abnormal tyre wear
and unusually hot running.
These are factors which
may seriously affect safety and lead
to:
– poor road holding,
– risk of bursting or tread separa-
tion.
The pressure depends on the load
and the speed of use. Adjust the
pressures according to the condi-
tions of use (refer to the information
on “Tyre pressures”).
Pressures should be checked when the
tyres are cold; ignore higher pressures
which may be reached in hot weather
or following a fast journey.
If tyre pressures cannot be checked
when the tyres are cold, the normal
pressures must be increased by 0.2 to
0.3 bar (or 3 PSI).
Never deflate a hot tyre.
Special note
Depending on the vehicle, there may
be an adapter which needs to be posi-
tioned on the valve before air is added.
Please be aware that a
poorly tightened or miss-
ing valve cap can make the
tyres less airtight and lead
to pressure loss.
Always use valve caps identical to
those fitted originally and tighten
them fully.

JauneNoir Noir texte
182
ENG_UD21006_4
Pneumatiques (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
Studded tyres
This type of equipment may only be
used for a limited period and as laid
down by local legislation. It is neces-
sary to observe the speed specified by
current legislation.
These tyres must, at a minimum, be
fitted to the two front wheels.Use in winter
Chains
For safety reasons, fitting snow
chains to the rear axle is strictly for-
bidden.
Chains cannot be fitted to tyres which
are larger than those originally fitted to
the vehicle.
Snow or Winter tyres
We would recommend that these be
fitted to all four wheels to ensure that
your vehicle retains maximum adhe-
sion.
Warning: These tyres sometimes have
a specific direction of rotation and a
maximum speed index which may be
lower than the maximum speed of your
vehicle.
TYRES (3/3)
Chains may only be fitted
to tyres of the same size
as those originally fitted to
your vehicle.
In all cases, we would recommend
that you contact an approved dealer
who will be able to advise you on
the choice of equipment which is
most suitable for your vehicle.
Fitting new tyres
Always ensure tyres with identi-
cal specifications are fitted to all four
wheels (brand, size, structure, wear
etc.). Fitting tyres of different sizes to
the front and rear wheels and/or left
and right wheels may have serious
consequences for the tyres, gearbox,
transfer gearbox and the rear differen-
tial pinions.
For safety reasons, this op-
eration must be carried out
by a specialist.
Fitting different tyres may
change your vehicle as follows:
– it may mean that your vehicle no
longer conforms to current regu-
lations;
– it may change the way it handles
when cornering;
– it may cause the steering to be
heavy;
– It may affect the use of snow
chains.
When changing a tyre, make sure all four tyres are changed at the same
time in order to preserve the transmission system.

JauneNoir Noir texte
193
ENG_UD21012_4
Fusibles (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
FUSES (2/2)
Allocation of fuses (DEPENDING ON THE EQUIPMENT LEVEL)
Some accessories are protected by
fuses located in the engine compart-
ment in fuse box A.
However, because of their reduced ac-
cessibility, we advise you to have your
fuses replaced by an approved Dealer.
A
Symbol Allocation Symbol Allocation
SPARE Spare fuses ELEC IGN Electrical equipment
BLOWER
MOTORVentilation4WD
CONTAll-wheel drive trans-
mission
REAR
DEFOGHeated rear screen METER Counter
BOSE AMP Audio systemROOM
LAMPInterior light
FRONT
POWER
SOCKETFront lightsMIRROR
HEATERHeated door mirrors
CIGAR
LIGHTERCigar lighterBOSE
AMPAudio system
AUDIO
MIRRORAudio system and elec-
tric rear-view mirrorsSTOP
LAMPBrake lights
REAR
POWER
SOCKETRear lightsELEC
B (+)Electrical equipment
AIR BAG Air bag
METER Equipment and options

JauneNoir Noir texte
200
ENG_UD31483_4 Remorquage : d pannage (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
TOWING: breakdown (2/4)
3233032331
2WD vehicles
Vehicles fitted with an automatic transmission or continuously vari-able transmission.
With the ignition off, the gearbox is no longer lubricated. If it is not, the vehi-cle must be transported on a trailer or be towed with the front wheels off the ground.
If the lever is stuck in P, even though you are de-pressing the brake pedal, the lever can be released manually.
To do this, first remove the cover 2 on the left-hand side of the gear lever.
While depressing the brake pedal, shift the gear lever into neutral (N) and simultaneously press the button 1 on the lever and on the button under the cover 2.
2
1

JauneNoir Noir texte
201
ENG_UD31483_4 Remorquage : d pannage (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
TOWING: breakdown (3/4)
3233232333
4WD vehicles
Whichever type of gearbox is fitted, a 4WD vehicle must never be towed if any of its 4 wheels are touching the ground.
A 4WD vehicle must never be towed if one of its 4 wheels is touching the ground.

JauneNoir Noir texte
202
ENG_UD31483_4
Remorquage : d pannage (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
TOWING: breakdown (4/4)
Only use the front towing point 1 and
the rear towing point 4 (never use the
driveshafts). These towing points may
only be used for towing: never use
them for lifting the vehicle directly or in-
directly.
When the engine is
stopped, steering and brak-
ing assistance are not op-
erational.
– RENAULT recommends
the use of a rigid towing bar.
If a rope or cable is used
(where the law allows this),
the vehicle being towed must be
able to brake.
– A vehicle must not be towed if it is
not fit to be driven.
– Do not accelerate or brake sud-
denly when towing, as this may
result in damage being caused to
the vehicle.
– When towing a vehicle, it is ad-
visable not to exceed 15 mph
(25 km/h).
1
324
Using the towing hitch
Remove cover 2.
Screw in towing hitch 3 as far as
possible. To do this, insert the towing
hitch 3 and screw it in by hand, then
tighten it using the wheelbrace.
The towing hitch 3 and the wheelbrace
are located in the tool kit in the luggage
compartment (refer to information con-
cerning the tool kit in Section 5).
Never leave tools unse-
cured in the vehicle: there
is a risk that they may be
thrown about during brak-
ing.

JauneNoir Noir texte
204
ENG_UD21017_3
Anomalies de fonctionnement (X45 - H45 - X95 - J95 - R95 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_5
OPERATING FAULTS (2/5)
The starter is activated POSSIBLE CAUSES WHAT TO DO
The instrument panel indicator lights
are weak or fail to light up and the
starter does not turn.Battery terminals not tight,
battery terminals discon-
nected or oxidised.Retighten or reconnect the terminals, or clean
them if they are oxidised.
Discharged battery or not
operational.Connect another battery to the faulty battery.
Refer to information on “Battery: troubleshooting”
in Section 5 or replace the battery if necessary.
Do not push the vehicle if the steering column is
locked.
The engine will not start.Starting conditions are not
fulfilled.Refer to the information on “Starting/stopping the
engine” in Section 2.
The RENAULT “hands-free”
card does not work.Insert the card in the card reader in order to start
the engine.
Refer to the information on “Starting/stopping the
engine” in Section 2.
The engine cannot be switched off. Card not detected. Insert the card in card reader.
Electronic fault. Press the starter button quickly five times.
The steering column remains locked. Steering wheel locked. Move the steering wheel while pressing the engine
start button (refer to the information on “Starting
the engine” in Section 2).