diagram RENAULT LAGUNA COUPE 2012 X91 / 3.G Owners Manual

child restraint/seat ................................ (up to the end of the DU)
child restraint/seat ................................ (up to the end of the DU)
child restraint/seat ................................ (up to the end of the DU)
child safety ............................................ (up to the end of the DU)
child seats ............................................. (up to the end of the DU)
transporting children ............................. (up to the end of the DU)
1.35
ENG_UD25098_1
Sécurité enfants : installation du siège enfant (X91 - D91 - R\
enault)
ENG_NU_939-3_D91_Renault_1
fitting a child seat
cHILd sAfETY : fitting a child seat (1/3)
In the rear side seat
A carrycot can be installed across the
vehicle and will take up at least two
seats. Position the child with his or her
feet nearest the door.
Push the vehicle seat fully forwards
to install a rear-facing child seat, then
push it back as far as possible with -
out allowing it to make contact with the
child seat.
For the safety of the child in the for -
ward-facing seat, do not move the seat
in front back past the middle of the
runner, do not tilt the seatback too far
(maximum of 25° ) and raise the seat as
much as possible.
Check that the forward-facing child seat
is resting against the back of the vehi-
cle seat and that the headrest of the ve-
hicle is not obstructing its use.
In the front seat
The laws concerning children travel
-
ling in the front passenger seat differ in
every country. Consult the legislation in
force and follow the indications on the
diagram on the following page.
Before fitting a child seat in this seat (if
authorised):
– lower the seat belt as far as possible;
– move the seat as far back as possi-
ble;
– gently tilt the seatback away from
vertical (approximately 25°);
– on equipped vehicles, raise the seat
base as far as possible.
Do not change these settings after the
child seat is installed.
R I sK O f dE AT H O R
s ERIOU s INJURY: before
installing a rear-facing child
seat in this seat, check that
the airbag has been deactivated
(please refer to “Child safety: front
passenger airbag deactivation/acti -
vation” in Section 1).
Some seats are not suitable for fitting
child seats. The diagram on the follow -
ing page shows you how to attach a
child seat.
The types of child seat indicated may
not be available. Before using a differ-
ent child seat, check with the manufac-
turer that it is compatible with the ve -
hicle.
Fit the child seat in a rear
seat wherever possible.
Check that when installing
the child seat in the vehicle
it is not at risk of coming loose from
its base.
If you have to remove the headrest,
check that it is correctly stored so
that it does not come loose under
harsh braking or impact.
Always attach the child seat to the
vehicle even if it is not in use so that
it does not come loose under harsh
braking or impact.
Ensure that the child seat
or the child’s feet do not
prevent the front seat from
locking correctly. Refer to
the information on the “Front seat”
in Section 1.

JauneNoirNoir texte
1.37
ENG_UD25098_1
Sécurité enfants : installation du siège enfant (X91 - D91 - R\
enault)
ENG_NU_939-3_D91_Renault_1
cHILd sAfETY : fitting a child seat (3/3)
(1) RIsK Of dEATH OR sERIOUs INJURY: before fitting a rear-facing child seat on the front passenger seat, check
that the airbag has been deactivated (please refer to the information on “Child safety: front passenger airbag deactiva -
tion/activation” in Section 1).
Type of child seat Weight of the child seat sizefront passenger
seat (1) (2) (5) Rear seats
c arrycot fitted across the
vehicle
Group 0 < 10 kg
F - GXX
shell seat/rear-facing seat
Group 0, 0+ and 1 Up to 18 kg
C, D, EUU - IL (3)
forward-facing seat
Group 1 9 to 18 kg
B, B1XU - IUF - IL (4)
Booster seat
Group 2 and 3 15 kg to 36 kg
XU (4)
X = Seat not suitable for fitting child seats.
U = Seat allowing a child seat with “Universal” approval to be atta\
ched by seat belt; check that it can be fitted correctly.
IUf/IL = On equipped vehicles, seat which allows an approved “Universal”/“semi-universal” or “vehicle specific” child seat to be
attached using the ISOFIX system; check that it can be fitted.
(2) Only a rear-facing child seat can be fitted in this seat: raise the seat to the maximum and position it as far back as possible,
tilting the seatback slightly (approximately 25°).
(3) Move the front seat as far forward as possible to install a rear-facing child seat, then move back the seat in front as far as it
will go, although without allowing it to come into contact with the chil\
d seat.
(4) Forward-facing child seat; position the seatback of the child seat in contact with the seatback of the vehicle seat. Adjust the
height of the headrest or remove it if necessary; do not push the seat in front of the child more than halfway back on its run-
ners and do not recline the seatback more than 25°.
(5) Make sure that the child seat or the child’s feet do not prevent the front seat from locking correctly. Refer to the information
on the “Front seat” in Section 1.
The table below summarises the information already shown on the diagram on the previous page, to ensure the regula-
tions in force are respected.