lock RENAULT MEGANE 2005 X84 / 2.G Workshop Manual

Downloaded from www.Manualslib.com manuals search engine
1

1

3

2

NU761_2_G3-FRA.qxd 4/11/05 10:52 Page 3.31
3.31
LUGGAGE COMPARTMENT
To open
Press button 1and lift the luggage
compartment lid.
To close
Lower the luggage compartment lid
by first using the inside handles 2.
Opening the doors from inside
the vehicle
If it is impossible to lock the luggage
compartment, it can be done from
inside.
- access the boot by folding forward
the seatback(s) of the rear bench
seat,
- insert a pencil or similar object into cavity 3and slide the assembly as
shown in the diagram.
- push the luggage compartment lid to open it.
NU761_2_G3-ENG.qxp 1/5/2006 5:28 PM Page 3.31 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
3

4

5

NU761_2_G4-FRA.qxd 14/11/05 10:10 Page 4.03
4.03
BONNET (continued)
Lift the bonnet, release stay 4from
its holder 5and, for your own safety,
it is very important to fix it into
retainer 3in the bonnet.
Closing the bonnet
Before closing the bonnet, check to
make sure that nothing has been left
in the engine compartment.
To close the bonnet, replace stay 4in
its holder 5, hold the bonnet in the
middle and lower it 12 inches (30
cm) above the closed position, then
release it. It will latch automatically
under its own weight.
Check that the bonnet is
correctly locked.
NU761_2_G4-ENG.qxp 1/5/2006 5:29 PM Page 4.03 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
NU761_2_G4-FRA.qxd 14/11/05 10:11 Page 4.14
4.14
INTERIOR TRIM MAINTENANCE
Whatever type of stain is on the
trim, use soapy water (if possible,
warm water) containing:
 natural soap,
 washing up liquid (with one partwashing up liquid to 200 parts
water).
Rinse off with a soft, damp cloth.
Special instructions
 Instrumentation glass panels (e.g.:
instrument panel, clock, external
temperature display, radio
display, etc.)
Use a soft cloth (or cotton wool).
If this does not clean it properly,
use a soft cloth (or cotton wool)
slightly moistened with soapy
water and then wipe clean with a
soft damp cloth/cotton.
Finally, carefully dry off with a
soft dry cloth.
Cleaning products containing
alcohol must not be used under
any circumstances.  Seat belts
These must be kept clean.
Use products selected by
RENAULT’s Technical Department
(RENAULT accessory outlets) or
warm soapy water and a sponge
and dry off with a dry cloth.
Detergents or dyes must not be
used under any circumstances.What you should not do
You are strongly recommended not
to use high-pressure or atomising
cleaning equipment inside the
passenger compartment: unless
carefully used, such equipment
could interfere with correct
functioning of the electrical or
electronic components in the
vehicle, amongst other effects.
You are strongly recommended not
to place objects such as air
fresheners, perfumes, etc. near the
air vents, as they could damage the
dashboard.
NU761_2_G4-ENG.qxp 1/5/2006 5:29 PM Page 4.14 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
1

3

4

2

5

A

NU761_2_G5-FRA.qxd 4/11/05 11:09 Page 5.03
5.03
TOOL KIT
The tool kit Ais located inside the
luggage compartment to the right of
the emergency spare wheel.
To gain access to the tools, remove
the emergency spare wheel then
release the tool kit.
Wheel trim tool 2or 4
This tool is used to remove the
wheel embellishers.
Towing hitch 3
Refer to the information on Towing
in Section 5.
Wheelbrace 5
This is used to tighten or release the
wheel bolts.
Storage compartments
Locations are provided in the tool
kit to store an anti-theft wheel
locking nut.
Jack 1
Remove jack 1.
When replacing the jack, fold it up
completely and replace it in its
location.
The jack is designed for
wheel changing purposes
only. Under no
circumstances should it
be used for carrying out repairs
underneath the vehicle or to gain
access to the underneath of the
vehicle.
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.03 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
2

1

NU761_2_G5-FRA.qxd 4/11/05 11:09 Page 5.09
5.09
HALOGEN HEADLIGHTS: ACCESS
Access to the left-hand
headlight unit
With the engine switched off
Turn cover 1by one quarter of a turn
(in an anti-clockwise direction).
Access to the right-hand
headlight unit
With the engine switched off
Unclip cover 2.
In both cases, once the bulb has
been changed, ensure that covers 1
and 2 are correctly refitted.
The bulbs can be accessed by
removing blanking covers
1and 2
located in the wheel arches.
However, due to their reduced
accessibility (sometimes requiring
the removal of bodywork or
mechanical components), we advise
you to have your bulbs replaced by
your Renault Dealer .
Take care when working in
the engine compartment as
the engine cooling fan may
start to operate at any
moment without warning.
Risk of injury.
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.09 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
A

NU761_2_G5-FRA.qxd 4/11/05 11:09 Page 5.19
5.19
FUSES (continued)Allocation of fuses (the presence of fuses depends on the vehicle equip\
ment level)
SymbolAllocation
ZPassenger compartment
ventilation
VElectric windows
[Electric sunroof
XABS
ÎRadio
×Stop lights
ÈAccessory cut-off
SymbolAllocation
ÌHorn
ERear screen wiper.
ÔGeneral supply
ÑHeated seats
]Central door locking
SHeated door mirrors
Certain functions are protected by
fuses located inside the engine
compartment (fusebox A).
However, because they can be
difficult to access, you are advised
to have your fuses replaced by a
RENAULT Dealer .
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.19 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
NU761_2_G5-FRA.qxd 4/11/05 11:09 Page 5.21
5.21
BATTERY: troubleshooting (continued)
Connecting a battery charger
The battery charger should be
compatible with a battery with a
nominal voltage of 12 Volts.
With the engine switched off, it is
essential to disconnect the cables
connected to both battery terminals,
starting with the negative terminal .
Do not disconnect the battery when
the engine is running. Follow the
manufacturer’s instructions for the
battery charger you are using.
Only a well-charged and well-
maintained battery will have a long
and useful life and enable you to
start the vehicle’s engine normally.
The battery must be kept clean and
dry.
Have the battery’s charge status
checked regularly:
 Especially if you use your vehicle for short journeys or for frequent
driving in town.  When the external temperature
drops (in winter), the charge
decreases . In winter, only use
electrical equipment which is
really necessary.
 Finally, you should understand that the charge decreases naturally
as a result of certain “permanent
electrical consumers” such as the
clock, After-Sales accessories, etc.
When many accessories are fitted to
the vehicle, have them connected
to + after ignition feed . In this case,
it is advisable to have your vehicle
fitted with a battery which has an
increased capacity. Contact your
RENAULT Dealer. If your vehicle is to be left stationary
for a relatively long time, disconnect
the battery or have it recharged
regularly, in particular during cold
weather. The equipment with a
memory, radio etc. will then have to
be reprogrammed. The battery must
be stored in a cool dry place,
protected from frost.
Special procedures may
be required to charge
some batteries. Contact
your RENAULT Dealer.
Avoid all risk of sparks which
may cause an immediate
explosion and charge the battery
in a well-ventilated area. Risk of
serious injury.
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.21 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
1

2

3

NU761_2_G5-FRA.qxd 4/11/05 11:10 Page 5.26
5.26
WINDSCREEN WIPER BLADES
Pull on tab 2.
Then, push the wiper blade
upwards.
To refit
To refit the wiper blade, proceed in
reverse order to removal. Make sure
that the blade is correctly locked in
position.
Clean your windscreen regularly.
Replacing windscreen wiper
blades 1
- With the ignition off , lift wiper
arm 3;
- turn the blade 1.
 In frosty weather, makesure that the wiper
blades are not stuck by
ice (risk of motor
overheating).
 Monitor the condition of the blades. Replace the wiper
blades as soon as they begin to
lose efficiency (approximately
once a year).
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.26 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
5

6

NU761_2_G5-FRA.qxd 4/11/05 11:10 Page 5.27
5.27
WINDSCREEN WIPER BLADES (continued)
Regularly clean your rear screen.
Rear screen wiper blade 5
- Lift the wiper arm 6;
- move blade 5until some resistance
is met.
- remove the blade by pulling it. To refit
To refit the wiper blade, proceed in
reverse order to removal. Make sure
that the blade is correctly locked in
position.
 In frosty weather, makesure that the wiper
blades are not stuck by
ice (to avoid the risk of
the wiper motor overheating).
 Check the condition of the wiper blades.
Replace the wiper blades as
soon as they begin to lose
efficiency: approximately once
a year.
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.27 (Black plate)

Downloaded from www.Manualslib.com manuals search engine
NU761_2_G5-FRA.qxd 4/11/05 11:10 Page 5.28
5.28
TOWING: breakdown
Press the Start/Stop button twice in
succession once towing is finished
(risk of running down the battery).
Furthermore, it is essential to
respect the towing regulations
defined in the legislation of the
country concerned and, if your
vehicle is the towing vehicle, do not
exceed the towing weight of your
vehicle. Contact your RENAULT
Dealer.Towing procedure
Before any towing, check that the
steering column is not locked.
If it is not locked, insert the
RENAULT card into the reader and
press the start/stop button for five
seconds without pressing on the
pedals. The steering column
unlocks, the vehicle accessory
functions are supplied with power
and you can use the lights (stop
lights, directional indicator lights,
etc.): the vehicle must have its lights
on at night.
Do not remove the RENAULT card
from the reader at any point when
the vehicle is being towed.
Towing a vehicle with
automatic transmission: special
information
Engine switched off: The gearbox is
no longer lubricated. It is preferable
to tow this type of vehicle on a
trailer or tow it with the front
wheels off the ground.
Under exceptional circumstances ,
you may tow the vehicle with all
four wheels on the ground, only
going forward, with the gear lever in
the N position, and for a distance
not exceeding 30 miles (50 km).
If the lever is stuck at P,
even though you are
depressing the brake
pedal, the lever can be
released manually.
To do this, unclip the upper
section of the cover at the base of
the lever.
Press simultaneously on the mark
on the gaiter and the unlocking
button on the lever.
NU761_2_G5-ENG.qxp 1/5/2006 5:30 PM Page 5.28 (Black plate)