RENAULT MEGANE COUPE CABRIOLET 2016 X95 / 3.G Owners Manual

5.33
OPERATING FAULTS (3/6)
On the roadPOSSIBLE CAUSES WHAT TO DO
The steering column remains
locked. Steering wheel locked.
Move the steering wheel while pressing the engine
start button (please refer to Section 2 “Starting/stop-
ping the engine”).
Faulty circuit. Consult an authorised dealer.
Coolant boiling in the coolant
reservoir. Mechanical fault: damaged cylin-
der head gasket. Stop the engine.
Contact an approved dealer.
Smoke under the bonnet. Short-circuit or cooling system
leak. Stop, switch off the ignition, stand away from the ve-
hicle and contact an approved dealer.
The oil pressure warning light
comes on: while cornering or braking The level is too low. Top up the engine oil level (refer to the information
on “Engine oil level: topping up/filling” in Section 4).
is slow to go out or remains lit
under acceleration Loss of oil pressure.
Stop the vehicle and contact an approved dealer.
White smoke from the exhaust. In the diesel version, this is nec-
essarily a fault. Smoke may be
caused by particle filter regenera-
tion. Please refer to the information on “Special features
of diesel versions” in Section 2.

5.34
OPERATING FAULTS (4/6)
On the roadPOSSIBLE CAUSES WHAT TO DO
Steering becomes heavy. Assistance overheating. Consult an approved dealer.
The engine overheats. The
coolant temperature indica-
tor is in the warning zone and
warning light
® comes on. Engine cooling fan not working. Stop the vehicle, switch off the engine and contact an
approved dealer.
Coolant leaks. Check the coolant reservoir: it should contain fluid.
If there is no coolant, consult an approved dealer as
soon as possible.
Vibrations. T yres not inflated to correct pres-
sures, incorrectly balanced or dam-
aged. Check the tyre pressures: if this is not the problem,
have them checked by an approved dealer.
Radiator:
If there is a significant lack of coolant, remember that it must never b\
e topped up using cold coolant while
the engine is very warm. After any procedure on the vehicle which has involved even partial drain\
ing of the cooling
system, it must be refilled with a new mixture prepared in the correct p\
roportions. Reminder: only products approved
by our Technical Department may be used for this purpose.

5.35
OPERATING FAULTS (5/6)
Electrical equipmentPOSSIBLE CAUSES WHAT TO DO
The wipers do not work. Wiper blades stuck. Free the blades before using the wipers.
Faulty electrical circuit. Consult an approved dealer.
The wiper does not stop. Faulty electrical controls. Consult an approved dealer.
Direction indicators flashing
more quickly. Blown bulb.
Front: contact an approved dealer.
Rear: replace the bulb.
The direction indicators do not
work. Faulty electrical circuit or control. Consult an approved dealer.
Fuse damaged.
Replace the fuse, refer to the information on “Fuses”.
The headlights do not switch
on or off. Faulty electrical circuit or control. Consult an approved dealer.
Fuse damaged.
Replace the fuse, refer to the information on “Fuses”.
Traces of condensation in the
lights. Traces of condensation may be a
natural phenomenon caused by var-
iations in temperature.
In this case, the traces will disappear
slowly once the lights are switched
on. The traces soon disappear when the lights are
switched on.

5.36
OPERATING FAULTS (6/6)
Electrical equipmentPOSSIBLE CAUSES WHAT TO DO
The roof will not open/close or
the roof opening/closing opera-
tion is interrupted. Sunroof opening/closing conditions
not fulfilled. The message “Roof: see
handbook” appears on the instru-
ment panel. Apply the opening/closing conditions (refer to the in-
formation on “Retractable glass roof” in Section 3).
Electrical or roof fault (discharged
battery, etc.).
The message “Check roof See
handbook” accompanied by the in-
dicator light
© appears on the
instrument panel. Close the sunroof, if open, using the method de-
scribed in “Retractable glass roof: Operating fault” in
Section 3 and contact your approved Dealer.

6.1
Section 6: Technical specifications
Vehicle identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . . . 6.2
Engine identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . 6.3
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5
Engine specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . . . . . . . . 6.6
Weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.7
Towing weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.7
Replacement parts and repairs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . 6.8
Service sheets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.9
Anticorrosion check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . . . . . . . . . 6.15

6.2
VEHICLE IDENTIFICATION PLATES
A
B
A
97
8
10
5
1
2
3
4
6
The information shown on the ve-
hicle identification plate should be
quoted on all correspondence or
orders.
The presence and location of the in-
formation depends on the vehicle.
Vehicle identification plate A
1 Manufacturer name.
2 EC design number or approval
number.
3 Identification number.
Depending on the vehicle, this
information is also given on
marking B.
4 MAM (Maximum Authorised
Mass).
5 GTW (Gross train weight: vehicle
fully loaded, with trailer).
6 MPAW (Maximim Permissible
Weight) for front axle.
7 MPAW on rear axle.
8 Reserved for related or additional
entries.
9 Diesel exhaust emissions.
10 Paint reference (colour code).

6.3
ENGINE IDENTIFICATION PLATES (1/2)
Quote the information on the identi-
fication plate or label A in all corre-
spondence or when ordering parts.
(Location varies depending on engine)
1 Engine type.
2 Engine suffix.
3 Engine number.
A
A
AA
A
12
3

6.4
Quote the information on the identi-
fication plate or label A in all corre-
spondence or when ordering parts.
(Location varies depending on engine)
1 Engine type.
2 Engine suffix.
3 Engine number.
A
A
ENGINE IDENTIFICATION PLATES (2/2)
A
3
12
A
A

6.5
DIMENSIONS (in metres)
0.8622.609 1.014 1.546
4,485
1.434*
1.547
1.810
* Unladen

6.6
Versions1.2 TCe 1.6 16V 2.0 16V 2.0 T 1.5 dCi 1.6 dCi 1.9 dCi 2.0 dCi
Engine type
(see engine plate) H5FT
Turbo K4M M4R F4R Turbo K9K R9M F9Q M9R
Cubic capacity (cc) 1197 1,598 1,998 1,998 1,461 1 598 1,870 1,995
Type of fuel
Octane Rating It is
essential that you use unleaded petrol of
the octane rating stated on the label inside the
fuel filler flap.
If not available, for a limited time only, use un-
leaded fuel:
– with an octane rating of 91 for a label showing 95 or 98;
– with an octane rating of 87 for a label showing 91, 95 or 98. Diesel
The label located in the fuel filler flap indicates authorised fuels.
Spark plugs Only use the spark plugs specified for your vehi-
cle’s engine.
The type should be marked on a label affixed
inside the engine compartment. If it is not then
contact your approved dealer.
Fitting spark plugs which are not to specification
may damage the engine.
ENGINE SPECIFICATIONS