motor RENAULT MEGANE SCENIC 1995 Service Owner's Guide

AUTOMATIC TRANSMISSION
Wiring diagram
23
104 - Ignition switch
119 - Automatic transmission computer
120 - Injection computer
129 - ECO/PERF selector switch
160 - Stop switch
163 - Starter motor
225 - Diagnostic socket
247 - Double headlight relay
250 - Speed sensor
303 - Automatic transmission selector lighting
319 - Air conditioning control panel
535 - ECO/PERF selector switch warning light
569 - 4 speed automatic transmission kickdown
597 - Engine fuse box
645 - Passenger compartment connection unit
754 - Electrical/hydraulic interface
779 - Automatic transmission multifunction switch
780 - Automatic transmission turbine or vehicle speed sensor
781 - Line pressure sensor
R22 - Engine/automatic transmission
R34 - Engine/dashboard
MH - Engine electric earth
MJ - Front right pillar electric earth
23-27

SIDE DOOR MECHANISMS
Front door window mechanism
Remove the window mechanism.
51
RR R R
EE E E
MM M M
OO O O
VV V V
AA A A
LL L L
After removing the interior trim, the side impact
bar and the window, compress the window
mechanism rings.
PRE5101
Disconnect the motor connector.
Remove the window mechanism mounting bolts.
12279R
12280S
51-1

SIDE DOOR MECHANISMS
Front door window mechanism
Turn the motor shaft until the mounting bolt (3) is
accessible.
Remove the mounting bolts.
51
PRE5103
CC C C
HH H H
AA A A
NN N N
GG G G
II I I
NN N N
GG G G

TT T T
HH H H
EE E E

MM M M
OO O O
TT T T
OO O O
RR R R
After removing the window mechanism, mark the
position of the stop (1).
Remove the stop.
Open the motor cover mounting plates (2) and
remove the motor.
Detach the toothed ring.
Remove the mounting bolt (4).
12286R
12285R
12284R
51-2

SIDE DOOR MECHANISMS
Front door window mechanism
51
RR R R
EE E E
FF F F
II I I
TT T T
TT T T
II I I
NN N N
GG G G
Secure the motor and engage the toothed wheel.
Connect the motor and operate the window
mechanism.
Position the stop (1) at the marks and tighten it.
Refit the window mechanism - window assembly.
The tightening torque for all of the bolts is 8 N.m.
AA A A
DD D D
JJ J J
UU U U
SS S S
TT T T
MM M M
EE E E
NN N N
TT T T
See section 54.
51-3

SIDE DOOR MECHANISMS
Quarter light mechanism
- the window .
AA A A
DD D D
JJ J J
UU U U
SS S S
TT T T
MM M M
EE E E
NN N N
TT T T
See section 54
51
RR R R
EE E E
MM M M
OO O O
VV V V
AA A A
LL L L
After removing the seat, the rear bench seat
backrest, the interior trim and the window,
disconnect the motor connector.
PRE5102
Remove:
- the window mechanism mountings (1),
12295R
12296S
51-4

UPPER INTERIOR ACCESSORIES
Road box
CC C C
HH H H
AA A A
NN N N
GG G G
II I I
NN N N
GG G G

TT T T
HH H H
EE E E

BB B B
LL L L
II I I
NN N N
DD D D

LL L L
OO O O
CC C C
KK K K
II I I
NN N N
GG G G

MM M M
OO O O
TT T T
OO O O
RR R R
58
Close the hood cover.
Check the clearance (5 mm) between the
compartment and the hood cover.
If necessary, adjust the clearance using the nut (1).
Connect the electrical wiring (A).After removing the road box, disconnect the
motor harness (1).
Detach the locking rod (2).
Remove the mounting bolt (3).
12479R12475R
58-3

52
NON-SIDE OPENING ELEMENT MECHANISMS
Sunroof motor (F)

GENERAL
Engine and equipment
40
(1) If necessary, unleaded fuel with an octane rating of 91 may be used.
Vehicle
typeVersionEngine
Type Ratio InjectionCapacity
(cm
3)Idle speed
(rpm)Fuel type
KA0M
KA0V1.4 l E7J 9.5/1 Multipoint 1390Non-
adjustableUnleaded
95 or 98 (1)
KA0W
KA0D1.4 l
16 VK4J 10/1 Multipoint 1390Non-
adjustableUnleaded
95 or 98 (1)
KA04
KA0B1.6 l
16 VK4M 10/1 Multipoint 1598Non-
adjustableUnleaded
95 or 98 (1)
KA0J
VA0J1.9 l D F8Q 21.5/1 Indirect 1870 825±50 Diesel
KA05
VA05
KA0N
VA0N
KA01
VA011.9 l
DtiF9Q
Turbo18.3/1 Direct 1870850±50
Non-
adjustableDiesel
Vehicle Rim TyresTyre inflation pressure -
cold (bar) (1)
Front Rear
KA0M/KA0V
KA0W/KA0D5.5 J 14 175/70 R 14 2.2 2.0
KA04/KA0B6.0 J 15 185/60 R 15 2.2 2.0
KA0J/VA0J6.0 J 15 175/70 R 14 2.2 2.0
KA0N/VA0N
KA05/VA05
KA01/VA01
6.0 J 15 185/60 R 15 2.2 2.0
(1) Fully laden and motorway use.
Tightening torque for wheel nuts : 9 daN.m
Rim run-out: 1.2 mm
Identification
40-2

NON-SIDE OPENING ELEMENT
MECHANISMS
Tailgate lock barrel
Rear screen wiper motorPage
Contents
WINDOWS
Rear door sliding window
Rear screen
Rear quarter panel window
EXTERIOR PROTECTION
Rear bumper
55
54
Mechanisms and
accessories
54-1
54-3
54-6
55-1
52
52-1
52-3
Number plate lights mounting 56-1 EXTERIOR ACCESSORIES
56
59-1
59-3 Front seat belts
Rear seat belts
59INTERIOR SAFETY ACCESSORIES

NON-SIDE OPENING ELEMENT MECHANISMS
Tailgate lock barrel
REMOVAL
Remove:
- the tailgate inner trim (see section 73A),
PRE5206
52A
15418R
- the two mounting bolts (A),
- the lock control linkage (B),
- the motor connector (C).
52-1