brake RENAULT MEGANE SCENIC 1995 Service Manual Online

37
MECHANICAL ELEMENT CONTROLS
Air filter - Brake servo non-return valve

37
MECHANICAL ELEMENT CONTROLS
Handbrake control lever

37
MECHANICAL ELEMENT CONTROLS
Handbrake control lever

37
MECHANICAL ELEMENT CONTROLS
Handbrake control lever

37
MECHANICAL ELEMENT CONTROLS
Handbrake

37
MECHANICAL ELEMENT CONTROLS
Handbrake

37
MECHANICAL ELEMENT CONTROLS
Brake pipes

MECHANISMS OF OPENINGS OTHER THAN SIDE DOORS
Hydraulic system reservoir
52
PRE5205
RR R R
EE E E
MM M M
OO O O
VV V V
AA A A
LL L L
RR R R
EE E E
FF F F
II I I
TT T T
TT T T
II I I
NN N N
GG G G
Coat the O-ring with hydraulic oil.
Fit the seal in the oil reservoir groove.
Position the reservoir on the pump.
Tighten the bolts (2) to a torque of 7 N.m.
II I I
MM M M
PP P P
OO O O
RR R R
TT T T
AA A A
NN N N
TT T T
:: : :
the hood must be closed when the
hydraulic system is filled.
Fill the reservoir with
EE E E
SS S S
SS S S
OO O O

UU U U
NN N N
II I I
VV V V
II I I
SS S S

JJ J J
22 2 2
66 6 6 oil (capaci-
ty 0.75 l).
The oil level must be between the MINIMUM and
MAXIMUM marks.
The hydraulic system is of the "AUTOMATIC
BLEED" type. The oil level
MM M M
UU U U
SS S S
TT T T
be checked with
the hood open, hood cover closed.
Check the oil level and top up if necessary.
Switch on the ignition, apply the handbrake.
Operate the hood switch.
Open and close the hood several times.
The bleeding process is completed when move-
ment is regular and without jolts with a constant
level of pump noise. Remove:
- the filler bolt (1) and drain,
- the reservoir mounting bolts (2).
12297-1R
52-16

NON-SIDE OPENING ELEMENTS
Tailgate
48P
148 NON-SIDE OPENING ELEMENTS
Tailgate
REMOVAL
Remove:
– the third brake light,
– the de-icing connections (B),
– the washer jet and disconnect.
Release:
– wiring harness (A),
– the two upper mounting protectors (C),
– the two hinge nuts (E),
– the balancers by removing the locking clips (D),
– the tailgate (this operation should be carried out be
two people for safety reasons).REFITTING
Before refitting it will be necessary to reseal between
the roof rear cross member and the hinges using
beading mastic.
Stick two strips of masking tape to the edge of the
tailgate, to prevent the paintwork from being scratched
during refitting.
Refit in reverse order to removal.
PRF4802
48-1
C