height adjustment RENAULT MEGANE SCENIC 1995 Service Repair Manual

59
INTERIOR SAFETY ACCESSORIES
Height adjustment mechanism (A)

NON-SIDE OPENING ELEMENTS
Tailgate
REMOVAL
Remove the trim and disconnect the various wi-
ring harnesses (see sections 52 and 71).
Remove:
- the third stop light,
- the rear screen washer jet pipe,
- the wiring harness,
99386R1
48A
PRE4803
- the headlining plugs using a screwdriver (torx
20).
99621R2
Unclip the tailgate balancers at (A).
Remove the mounting nuts and remove the
hinges (B) (two persons required for this opera-
tion).
NOTE : if the tailgate or the roof is being repla-
ced, retain the height adjustment shims located
under the hinges (B).
To do this, use a cutting tool to destroy the finis-
hing seal around the shims and retain them.
The hinges are welded on the tailgate, so these
shims of thickness 1 mm are used to adjust the
clearance between the roof and the tailgate.
48-1

NON-SIDE OPENING ELEMENTS
Luggage compartment lid
48P
48-6
The peripheral play is adjusted via mountings (H) and
(B). See section 40 for the setting values.IMPORTANT:
Mountings (B1) and (H1) are used as chain guides and
only allow height adjustment.
For additional adjustment settings, these mountings
may be replaced by points (B2) and (H2) respectively.
The beading and the closure stiffness are adjusted at
the lock (I) and the closure striker plate (J), as well as
via the lower stops (K) and (L).
17515-1R
17514-1R1
16786R
D