weight RENAULT MEGANE SCENIC 1995 Service Repair Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1995, Model line: MEGANE SCENIC, Model: RENAULT MEGANE SCENIC 1995Pages: 2492, PDF Size: 32.28 MB
Page 7 of 2492
SPECIFICATIONS
Vehicle identification
01
It shows:
At A : the name of the manufacturer,
At B : the E.E.C. approval number
At 1 : the type mines of the vehicle preceded by the world manufacturers identification code (VF1 corre-
sponds to RENAULT FRANCE),
At 2 : the chassis number,
At 3 : the maximum permissible weight,
At 4 : the maximum permitted total train weight,
At 5 : the maximum permitted weight on the front axle,
At 6 : the maximum permitted weight on the rear axle,
At 7 : the first figure indicates the gearbox or factory options,
the second figure indicates the equipment level,
At 8 : the vehicle type,
At 9 : the technical equipment code,
At 10 : additional factory optional equipment,
At 11 : the equipment level,
At 12 : the paint code,
At 13 : a letter describing the factory of manufacture followed by the fabrication number,
At 14 : the trim code.
NOTE : Depending on the country of export, certain details might not be given. The plate described above
shows all possible information.
ALLOCATION OF TECHNICAL EQUIPMENT CODES
The equipment code, the three letters which appear in (9), must be documented for vehicle identification
reasons (ordering spare parts, warranty claim, etc.)
01-4
Page 8 of 2492
LIFTING
Trolley jack - Axle stands
AXLE STANDS
When putting the vehicle on axle stands, they
must be positioned:
- either under the reinforcements designed for
lifting the vehicle using the vehicle’s jack,
- or under the points located behind the
reinforcements.
Axle stands are positioned at the rear when the
vehicle is lifted from the side.
02
98699R
Safety symbol (special precautions to be taken when carrying out operations).
SPECIAL TOOLING REQUIRED
Cha. 280 -02 Adaptable cross piece for trolley
jack
Cha. 408 -01
or Adaptable socket for trolley jack
Cha. 408 -02
If a trolley jack is used, appropriate axle
stands must always be used.
It is forbidden to lift the vehicle by supporting its
weight under the front suspension arm or under
the V shaped part of the rear axle.
Depending on the type of trolley jack, use sockets
Cha. 408-01 or Cha. 408-02 to position the cross
piece Cha. 280-02.
To lift the front or rear, support the vehicle’s
weight under the vehicle’s jacking points .
TROLLEY JACK USED FROM THE SIDE
Use cross piece Cha. 280-02.
Take the weight under the sill, level with the front
door.
Position the flange correctly in the groove of the
cross piece.
98336G85679-1G7
02-1
Page 339 of 2492
MANUAL GEARBOX
Gearbox (Removal - Refitting)
21
Remove :
- the air filter sleeve,
- the tie-rod from the shock absorber turret,
- the clutch cable. Slacken but do not remove bolt (B) then remove
mounting bolt (C) from the suspended engine
mounting rod.F
engine
99309R
Remove the rear mounting.
Remove shock absorber actuator (on version F8Q).
Remove :
- the expansion bottle,
- the air filter mounting.
Release the wiring.
89204S
Position the engine support tool and take the
weight of the engine and transmission assembly.
98750S
99213S
21-14